Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 7
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

New approach to materials behaviour studies in high-speed flue gas from oxy-steam combustion

  • Mayoral Gastón, María del Carmen
  • Andrés Gimeno, José Manuel
  • Dueso, Cristina
  • Rubio Villa, Begoña
12 Figures, 2 Tables.-- © 2019. This manuscript version is made available under the CC-BY-NC-ND 4.0 license http://creativecommons.org/licenses/by-nc-nd/4.0/, Some new proposals are being considered aiming at improving the efficiency and operability of oxy-combustion power plants, such as the so-called oxy-steam combustion. This process consists in replacing the carbon dioxide by steam in the firing atmosphere. One of the main uncertainties for the feasibility of the oxy-steam technology is the materials resistance to steam corrosion at high temperature, mainly due to chromium vaporization. The novel approach to the issue presented in this work is the generation of realistic flue gas velocity (20 m·s−1) in flames produced with a thermal spray gun using H2 as fuel. Gas composition was selected to match expected final H2O content after combustion: 40 and 60% H2O in CO2 with excess of O2. A set of metallic steels and alloys (SS304, SS310, I800HT, Kanthal and IN617) was preoxidised in air to generate external oxide scales. After preoxidation, the samples were treated under steam flames at 700 °C, placed in a position either parallel or perpendicular to the flame axis. Surface oxides composition was compared to that obtained in a quasi-static furnace, where metallic samples were exposed to steam atmosphere at 700 °C for 20 h (50% steam, 45% CO2 and 5% O2). The characterisation of the surfaces was performed using low-angle XRD and SEM-EDX for a precise measuring of the variation of oxide amount and chromium content. The analyses showed that mixed Cr-Mn and Cr-Fe external oxides formed during the preoxidation stage suffered the depletion of the surface chromium when they were exposed parallel to the steam flame axis, as a simulation of the lateral flue gas pass in the heat-exchanger tubing. Cr depletion was also observed in the windside of tubes (perpendicular to flame axis) but in minor extent. The reduction in the Cr amount of the samples when tested in the vapour furnace was negligible compared to the Cr loss found after treatment under high velocity flames. The presence of external (Mn,Cr)3O4 in preoxidised SS310 and SS304 did not provide an effective protection against Cr volatilization in the steam flame treatment, whereas surface alumina in Kanthal seemed to prevent Cr volatilization., This work was funded by the Spanish Ministry of Economy, Industry and Competitiveness under contract ENE2015-67448-C2-2-R., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Towards oxy-steam combustion: The effect of increasing the steam concentration on coal reactivity

  • Dueso, Cristina
  • Mayoral Gastón, María del Carmen
  • Andrés Gimeno, José Manuel
  • Escudero, Ana Íris
  • Díez, Luis Ignacio
14 Figures, 5 Tables.-- © 2018. This manuscript version is made available under the CC-BY-NC-ND 4.0 license http://creativecommons.org/licenses/by-nc-nd/4.0/, Oxy-steam combustion and devolatilization performance of three different coals (anthracite, blend of bituminous coals and low-rank coal) was studied in a thermobalance with a water vapour furnace under variable steam concentrations (0, 20, 40 and 70 vol% H2O) in N2 and CO2. Two oxygen concentrations were used during the combustion tests (20 and 30 vol%). Devolatilization behaviour was similar under N2 and CO2 atmosphere and increasing steam concentration did not affect significantly the observed reactivity and the reaction temperature range. Replacing CO2 with 20 vol% H2O during combustion tests produced a decrease in ignition and burnout temperatures. When H2O content increased to 40 and 70 vol%, this effect was only found with high-rank anthracite. Maximum mass loss rates for the low-rank coal with high volatile content were up to four times higher than with the other two coals. During direct oxidation experiments, DTG curves of anthracite and the coal blend showed a double peak, corresponding to devolatilization and oxidation reactions. This allowed determining independent kinetic parameters (Ea and A) for both stages. An only DTG peak was detected with the low-rank coal since devolatilization and oxidation reactions took place simultaneously owing to its high reactivity. Devolatilization and oxidation kinetics followed a first-order reaction using the Coats-Redfern integral method. Significant differences were not observed between the activation energies of the three coals when comparing conventional (N2), oxy-fuel (CO2) and oxy-steam conditions (70 vol% H2O in CO2), although Ea values were higher for the devolatilization stage than for the oxidation process., This work was funded by the Spanish Ministry of Economy, Industry and Competitiveness under contracts ENE2015-67448-C2-1 and ENE2015-67448-C2-2-R. A.I. Escudero acknowledges the FPI fellowship BES-2016-078573 financed by the Spanish Ministry of Economy, Industry and Competitiveness., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

From O2/CO2 to O2/H2O combustion: The effect of large steam addition on anthracite ignition, burnout and NOx formation

  • Escudero, Ana Íris
  • Aznar, María
  • Díez, Luis Ignacio
  • Mayoral Gastón, María del Carmen
  • Andrés Gimeno, José Manuel
9 figures, 2 tables.-- © 2020. This manuscript version is made available under the CC-BY-NC-ND 4.0 license http://creativecommons.org/licenses/by-nc-nd/4.0/, Steam-moderated combustion has been proposed to supress flue gas recycling in oxy-fired units, but the influence of replacing CO2 by H2O has to be deeply studied. In this paper, oxy-fuel combustion of anthracite with large steam addition has been experimentally characterized, and main results are discussed as concerns the influence upon the ignition temperature, the burnout and the NOx formation. The tests have been carried out in an electrically-heated entrained flow reactor for a set of O2/CO2 and O2/H2O/CO2 atmospheres, with steam addition up to 40% vol. The results show that ignition temperature diminishes when steam is added in low rates (maximum decrease of 16 °C), but the trend is reversed for the higher steam concentrations (maximum increase of 18 °C). The effect of steam addition on coal burnout rates is more significant for the 21% vol. O2 atmosphere, with a decrease of 2.2–5.3 percentage points, and almost negligible for the 35% vol. O2. An outstanding reduction of NO specific emissions is detected when adding H2O, with decrements ranging 28–45% compared to the dry conditions. The transition from O2/CO2 combustion to O2/H2O combustion barely affects the anthracite conversion but significantly diminishes NOx formation rates., The work described in this paper has been funded by the R + D Spanish National Program from the Spanish Ministry of Science, Innovation and Universities, under the Project ENE2015-67448-C2-2-R and the Grant BES-2016-078573. The Service of Electronic Instrumentation (University of Zaragoza) is also acknowledged for their support in the development of the SCADA at the experimental facility., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Oxy-co-firing in fluidized beds: control of sulfur emissions and assessment of corrosion issues

  • Mayoral Gastón, María del Carmen
  • Díez, Luis Ignacio
  • Lupiáñez, Carlos
  • Espatolero, Sergio
  • Andrés Gimeno, José Manuel
Poster presented at 13th International Conference on Greenhouse Gas Control Technologies (GHGT-13), Lausanne, Switzerland, Nov.14-18, 2016., Oxy-co-combustion of coal and biomass in fluidized bed shows outstanding advantages, like fuel/operation flexibility and good control of SO2 and NOx emissions. But inorganic matter in biomass can be responsible of operational problems such us agglomeration in the bed, and solid deposition and corrosion in heat exchange surfaces, mainly due to KCl content in crops. Goal: To analyze the relationship between Chlorine and Sulfur content in the fuel blend with the deposition tendency for a range of conditions studied., The work described in this paper was partially funded by the R+D Spanish National Program from the Spanish Ministry of Economy and Competitiveness, under the Project ENE2015-67448-C2-2-R. The project is also co-funded by the European Commission (European Regional Development Funds)., Peer reviewed
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Oxy-steam combustion: The effect of coal rank and steam concentration on combustion characteristics

  • Escudero, Ana I.
  • Aznar, María
  • Díez, Luis I.
This paper addresses the experimental investigation of coal combustion characteristics (ignition, burnout and NO formation) under oxy-steam combustion conditions. Two coals are selected in order to compare the effect of the rank: bituminous and sub-bituminous ones. The experiments have been conducted in an electrically-heated entrained flow reactor for a set of O2/N2, O2/CO2 and O2/H2O/CO2 atmospheres, with O2 concentrations up to 35% and H2O concentrations up to 40%. Regarding ignition, 10% H2O reduces ignition temperature (max. 16–19 K) but the trend is reversed when supplying additional steam to 25% and 40%. This behaviour is similar for both coals, with slight larger variations in the case of the low rank coal. Burnout degree of the sub-bituminous coal is barely affected by the steam concentration since all observed conversions are very high. Larger increments (up to 6.1 percentage points) are obtained for the bituminous coal, with a maximum burnout degree for the 25/35% H2O/O2 atmosphere. A very different effect of steam on NO formation is found depending on the coal rank. Significant reduction rates are observed for the bituminous coal in comparison to the dry O2/CO2 atmospheres, with a maximum diminution of 24% when 40% H2O replaces CO2. On the contrary, the higher volatile content in the sub-bituminous coal leads to NO increments up to 9%. For all the combustion characteristics studied, the increase of O2 concentrations attenuates the effects caused by the steam addition.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Towards oxy-steam combustion: The effect of increasing the steam concentration on coal reactivity

  • Dueso, C.
  • Mayoral, M.C.
  • Andrés, J.M.
  • Escudero, A.I.
  • Díez, L.I.
Oxy-steam combustion and devolatilization performance of three different coals (anthracite, blend of bituminous coals and low-rank coal) was studied in a thermobalance with a water vapour furnace under variable steam concentrations (0, 20, 40 and 70 vol% H2O) in N2 and CO2. Two oxygen concentrations were used during the combustion tests (20 and 30 vol%). Devolatilization behaviour was similar under N2 and CO2 atmosphere and increasing steam concentration did not affect significantly the observed reactivity and the reaction temperature range. Replacing CO2 with 20 vol% H2O during combustion tests produced a decrease in ignition and burnout temperatures. When H2O content increased to 40 and 70 vol%, this effect was only found with high-rank anthracite. Maximum mass loss rates for the low-rank coal with high volatile content were up to four times higher than with the other two coals. During direct oxidation experiments, DTG curves of anthracite and the coal blend showed a double peak, corresponding to devolatilization and oxidation reactions. This allowed determining independent kinetic parameters (Ea and A) for both stages. An only DTG peak was detected with the low-rank coal since devolatilization and oxidation reactions took place simultaneously owing to its high reactivity. Devolatilization and oxidation kinetics followed a first-order reaction using the Coats-Redfern integral method. Significant differences were not observed between the activation energies of the three coals when comparing conventional (N2), oxy-fuel (CO2) and oxy-steam conditions (70 vol% H2O in CO2), although Ea values were higher for the devolatilization stage than for the oxidation process.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

From O2/CO2 to O2/H2O combustion: The effect of large steam addition on anthracite ignition, burnout and NOx formation

  • Escudero, Ana I.
  • Aznar, María
  • Díez, Luis I.
  • Mayoral, M. Carmen
  • Andrés, José M.
Steam-moderated combustion has been proposed to supress flue gas recycling in oxy-fired units, but the influence of replacing CO2 by H2O has to be deeply studied. In this paper, oxy-fuel combustion of anthracite with large steam addition has been experimentally characterized, and main results are discussed as concerns the influence upon the ignition temperature, the burnout and the NOx formation. The tests have been carried out in an electrically-heated entrained flow reactor for a set of O2/CO2 and O2/H2O/CO2 atmospheres, with steam addition up to 40% vol. The results show that ignition temperature diminishes when steam is added in low rates (maximum decrease of 16 °C), but the trend is reversed for the higher steam concentrations (maximum increase of 18 °C). The effect of steam addition on coal burnout rates is more significant for the 21% vol. O2 atmosphere, with a decrease of 2.2–5.3 percentage points, and almost negligible for the 35% vol. O2. An outstanding reduction of NO specific emissions is detected when adding H2O, with decrements ranging 28–45% compared to the dry conditions. The transition from O2/CO2 combustion to O2/H2O combustion barely affects the anthracite conversion but significantly diminishes NOx formation rates.