Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Development of a calibration satellite for a CMB telescope flying in formation about L2 libration point

  • Bermejo-Ballesteros, J.
  • García-González, Sergio
  • Cubas, Javier
  • Casas-Reinares, F. J.
  • Martínez-González, Enrique
Trabajo presentado a la 8th European Conference for aeronautics and aerospace sciences (EUCASS), celebrada en Madrid (España) del 1 al 4 de julio de 2019., The new generation of cosmic microwave background (CMB) telescopes have reached unprecedented levels of sensitivity. These telescopes measure several cosmological parameters with different levels of accuracy. In particular, considerable effort has been made to measure the B-mode polarization, which is related to the inflationary process of the universe. The power spectrum of this signal is about four orders of magnitude fainter than the CMB temperature power spectrum. Due to the signal weakness, the instruments must be subjected to calibration processes before and after launching. Additionally, data from the same sky area is gathered repeatedly to mitigate during data analysis the systematic errors induced by instruments. Celestial sources are often used as an external reference for calibration after launch, but these sources are not perfectly characterized. In this paper we study the concept of using a calibration satellite (CalSat) flying in formation with a CMB telescope in an orbit located at the second Lagrange point (L2). The CalSat is conceived as a micro satellite (10-100 kg) and serves as a perfectly known source of a reference signal to reduce the polarization angle measurement uncertainty. According to the scanning law followed by the telescope, the influence of the relative position between the spacecrafts in the calibration process is studied. The relative motion of the spacecrafts is considered with a simplified dynamic model. Based on the mission requirements, the different subsystems are sized and a preliminary design to evaluate the feasibility is obtained. The design has been carried out under the principle of reducing at minimum the impact on the telescope architecture. It would require to be launched along with the telescope to reach L2 at the same time and being able to communicate with the telescope. This new calibration element could have a huge impact on the performance of this kind of missions, providing a significant improvement in the measurements accuracy without requiring new and costly technological developments., The authors would like to thank Spanish Ministry for Economy and Competitiveness (currently Ministry of Science,innovation and Universities) for the financial support provided under the projects with references ESP2017-92135-EXP all co-financed with EU FEDER funds.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

L2-CalSat: A calibration satellite for ultra-sensitive CMB polarization space missions

  • Casas-Reinares, F. J.
  • Martínez-González, Enrique
  • Bermejo-Ballesteros, J.
  • García-González, Sergio
  • Cubas, Javier
  • Vielva, Patricio
  • Barreiro, R. Belén
  • Sanz-Andres, A.
This article belongs to the Section Remote Sensors., In this work, the use of a calibration satellite (L2-CalSat) flying in formation with a Cosmic Microwave Background (CMB) polarization mission in an orbit located at the second Lagrange point, is proposed. The new generation of CMB telescopes are expected to reach unprecedented levels of sensitivity to allow a very precise measurement of the B-mode of polarization, the curl-like polarization component expected from gravitational waves coming from Starobinski inflationary models. Due to the CMB polarized signal weakness, the instruments must be subjected to very precise calibration processes before and after launching. Celestial sources are often used as external references for calibration after launch, but these sources are not perfectly characterized. As a baseline option, L2-CalSat is based on the CubeSat standard and serves as a perfectly known source of a reference signal to reduce polarization measurements uncertainty. A preliminary design of L2-CalSat is described and, according to the scanning strategy followed by the telescope, the influence of the relative position between the spacecrafts in the calibration process is studied. This new calibration element will have a huge impact on the performance of CMB space missions, providing a significant improvement in the measurements accuracy without requiring new and costly technological developments., This research was funded by the Spanish Agencia Estatal de Investigación (AEI, MICIU) by means of the projects with references ESP2017-92135-EXP, ESP2017-83921-C2-1-R, AYA2017-90675-REDC, and PID2019-110610RB-C21/AEI/10.13039/501100011033 co-funded with EU FEDER funds. We also acknowledge the funding from Unidad de Excelencia María de Maeztu (MDM-2017-0765)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Polarization calibration of a microwave polarimeter with near-infrared up-conversion for optical correlation and detection

  • Casas-Reinares, F. J.
  • Vielva, Patricio
  • Barreiro, R. Belén
  • Martínez-González, Enrique
  • Pascual Cisneros, Guillermo
This article belongs to the Special Issue Towards Optoelectronic Technology: From Basic Research to Applications., This paper presents a polarization calibration method applied to a microwave polarimeter demonstrator based on a near-infrared (NIR) frequency up-conversion stage that allows both optical correlation and signal detection at a wavelength of 1550 nm. The instrument was designed to measure the polarization of cosmic microwave background (CMB) radiation from the sky, obtaining the Stokes parameters of the incoming signal simultaneously, in a frequency range from 10 to 20 GHz. A linearly polarized input signal with a variable polarization angle is used as excitation in the polarimeter calibration setup mounted in the laboratory. The polarimeter systematic errors can be corrected with the proposed calibration procedure, achieving high levels of polarization efficiency (low polarization percentage errors) and low polarization angle errors. The calibration method is based on the fitting of polarization errors by means of sinusoidal functions composed of additive or multiplicative terms. The accuracy of the fitting increases with the number of terms in such a way that the typical error levels required in low-frequency CMB experiments can be achieved with only a few terms in the fitting functions. On the other hand, assuming that the calibration signal is known with the required accuracy, additional terms can be calculated to reach the error levels needed in ultrasensitive B-mode polarization CMB experiments., This research was funded by the Spanish Agencia Estatal de Investigación (AEI, MICIU) grant numbers ESP2017-92135-EXP, ESP2017-83921-C2-1-R, AYA2017-90675-REDC, and PID2019-110610RB-C21/AEI/10.13039/501100011033, co-funded with EU FEDER funds. It was also funded by Unidad de Excelencia María de Maeztu, grant number MDM-2017-0765., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Optimization of a microwave polarimeter for astronomy with optical correlation and detection

  • Pascual Cisneros, Guillermo
  • Casas-Reinares, F. J.
  • Vielva, Patricio
This article belongs to the Section Remote Sensors., Cosmic Microwave Background (CMB) B-modes detection is the main focus of future CMB experiments because of the valuable information it contains, particularly to probe the physics of the very early universe. For this reason, we have developed an optimized polarimeter demonstrator sensitive to the 10–20 GHz band in which the signal received by each antenna is modulated into a Near Infrared (NIR) laser by a Mach–Zehnder modulator. Then, these modulated signals are optically correlated and detected using photonic back-end modules consisting of voltage-controlled phase shifters, a 90-degree optical hybrid, a pair of lenses, and an NIR camera. During laboratory tests, a 1/f-like noise signal related to the low phase stability of the demonstrator has been found experimentally. To solve this issue, we have developed a calibration method that allows us to remove this noise in an actual experiment, until obtaining the required accuracy level in the measurement of polarization., This research was funded by the Spanish Agencia Estatal de Investigación (AEI, MICIU) grant numbers ESP2017-92135-EXP, ESP2017-83921-C2-1-R, AYA2017-90675-REDC, and PID2019-110610RB-C21/AEI/10.13039/501100011033, co-funded with EU FEDER funds. It was also funded by Unidad de Excelencia María de Maeztu, grant number MDM-2017-0765., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Mach–Zehnder modulators for microwave polarization measurement in astronomy applications

  • Casas-Reinares, F. J.
  • Pascual Cisneros, Guillermo
This article belongs to the Special Issue Recent Advances of Optoelectronic Devices and Semiconductor Sensors., This paper presents a study of the performances of different Mach–Zehnder modulation technologies with applications in microwave polarimeters based on a near-infrared (NIR) frequency up-conversion stage, allowing for optical correlation and signal detection at a wavelength of 1550 nm. Commercial Mach–Zehnder modulators (MZMs) are traditionally implemented using LiNbO3 technology, which does not enable integration for the fabrication of MZMs. In this work, we propose the use of an alternative technology based on InP, which allows for integration in the fabrication process. In this way, it is possible to obtain advantages in terms of bandwidth, cost, and size reductions, which yield results that are very interesting for wide-band applications such as microwave instrumentation for the study of the cosmic microwave background (CMB). Here, we describe and compare the modulation performances of different MZMs, with one commercial unit presenting a higher bandwidth than those in previous works, and another three InP integrated units provided by the Fraunhofer Institute for Telecommunications, Heinrich-Hertz-Institute (HHI). Then, these modulators were coupled to a microwave polarimeter demonstrator, which has also been presented previously, to compare the polarization measurement performances of each of the MZMs., This research was funded by the Spanish Agencia Estatal de Investigación (AEI, MICIU) grant numbers ESP2017-92135-EXP, ESP2017-83921-C2-1-R, AYA2017-90675-REDC, and PID2019-110610RB-C21/AEI/10.13039/501100011033, and co-funded with EU FEDER funds. It was also funded by Unidad de Excelencia María de Maeztu, grant number MDM-2017-0765., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Photonic integrated circuits for microwave astronomy

  • Pascual Cisneros, Guillermo
  • Casas-Reinares, F. J.
  • Vielva, Patricio
This article belongs to the Special Issue Recent Advances in Visible Light Communication and Optical Wireless Information Systems., One of the main objectives of cosmology is the measurement of the Cosmic Microwave Background (CMB) polarization and, in particular, the so-called B-modes, which could demonstrate the existence of the primordial gravitational waves generated at the early stages of the Universe. For this reason, a new integrated version of the heterodyne polarimeter photonic part shown on a previously proposed scheme that can be used in both direct imaging and interferometric instruments is presented. We have tested its properties using specific commercial software, obtaining promising results. Working as a direct imaging instrument, it is shown that the proposed polarimeter can provide sufficiently low polarization angle and polarization efficiency systematic errors, which are considered acceptable for current ground-based CMB polarization experiments dedicated to the characterization of the foreground signals affecting the lowest part of the frequency spectrum., This research was funded by the Spanish Agencia Estatal de Investigación (AEI, MICIU), grant numbers ESP2017-92135-EXP, ESP2017-83921-C2-1-R, AYA2017-90675-REDC, and PID2019-110610RB-C21/AEI/10.13039/501100011033, co-funded with EU FEDER funds. It was also funded by Unidad de Excelencia María de Maeztu, grant number MDM-2017-0765., Peer reviewed