Pasar al contenido principal

MATERIA BLANDA Y NANOFLUIDOS EN MULTIPLES ESCALAS

FIS2013-47350-C5-5-R

•
Nombre agencia financiadora Ministerio de Economía y Competitividad
Acrónimo agencia financiadora MINECO
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos I+D+i Retos de Investigación
Año convocatoria 2013
Plan Estatal 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Unidad de gestión Secretaría de Estado de Educación, Formación Profesional y Universidades
Centro beneficiario UNIVERSIDAD NACIONAL DE EDUCACION A DISTANCIA
Identificador persistente http://dx.doi.org/10.13039/501100003329

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Magnetic microwire probes for the magnetic rod interfacial stress rheometer

  • Tajuelo, J.
  • Pastor, J.M.
  • Martínez-Pedrero, F.
  • Vázquez Villalabeitia, Manuel
  • Ortega, F.
  • Rubio, R. G.
  • Rubio, M. A.
The magnetic needle interfacial shear rheometer is a valuable tool for the study of the mechanical properties of thin fluid films or monolayers. However, it is difficult to differentiate the interfacial and subphase contributions to the drag on the needle. In principle, the problem can be addressed by decreasing the needle diameter, which decreases the bulk contribution while the interfacial contribution remains essentially the same. Here we show the results obtained when using a new type of needle, that of magnetic microwires with diameter approximately 10 times thinner than for commercial needles. We show that the lower inertia of the microwires calls for a new calibration procedure. We propose such a new calibration procedure based on the flow field solution around the needle introduced in refs 1 and 2. By measuring thin silicone oil films with well-controlled interfacial viscosities as well as eicosanol (C) and pentadecanoic acid (PDA, C) Langmuir monolayers, we show that the new calibration method works well for standard needles as well as for the microwire probes. Moreover, we show that the analysis of the force terms contributing to the force on the needle helps to ascertain whether the measurements obtained are reliable for given surface shear viscosity values. We also show that the microwire probes have at least a 10-fold-lower resolution limit, allowing one to measure interfacial viscosities as low as 10 N·m/s., J.T. acknowledges a grant from UNED’s Researchers Formation Program. M.A.R. and J.M.P. acknowledge partial support from MINECO (grant FIS2013-47350-C5-5-R). F.M.P., F.O., and R.G.R. acknowledge partial support from MINECO (grant FIS2012-38231-C02-01), from E.U. through ITN Cowet, and from a PICATA fellowship of the Moncloa Campus of International Excellence (UCM-UPM).
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Mesoscopic Hamiltonian for the fluctuations of adsorbed Lennard-Jones liquid films

  • Fernández, Eva M.
  • Chacón, Enrique
  • MacDowell, Luis G.
  • Tarazona, Pedro
We use Monte Carlo simulations of a Lennard-Jones fluid adsorbed on a short-range planar wall substrate to study the fluctuations in the thickness of the wetting layer, and we get a quantitative and consistent characterization of their mesoscopic Hamiltonian, H[ξ]. We have observed important finite-size effects, which were hampering the analysis of previous results obtained with smaller systems. The results presented here support an appealing simple functional form for H[ξ], close but not exactly equal to the theoretical nonlocal proposal made on the basis a generic density-functional analysis by Parry and coworkers. We have analyzed systems under different wetting conditions, as a proof of principle for a method that provides a quantitative bridge between the molecular interactions and the phenomenology of wetting films at mesoscopic scales., We are grateful to A. O. Parry for most useful comments on this work, and we acknowledge the support of the Spanish Ministry of Science and Innovation (Grants No. FIS2010-22047-C05 and No. FIS2013-47350-C5).