Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Sensor placement for leak monitoring in drinking water networks combining clustering techniques and a semi-exhaustive search

  • Sarrate, Ramon
  • Blesa, Joaquim
  • Nejjari, Fatiha
Trabajo presentado a la 3rd Conference on Control and Fault Tolerant Systems, celebrada en Barcelona (España) del 7 al 9 de septiembre de 2016., This paper presents an optimal sensor placement strategy based on pressure sensitivity matrix analysis and a semi-exhaustive search strategy that maximizes some diagnosis specifications for water distribution networks. A mean average worst leak expansion distance has been proposed as a new leak location performance measure. The approach is combined with a clustering technique in order to reduce the size and the complexity of the sensor placement problem. The strategy is successfully applied to determine the location of a set of pressure sensors in a district metered area (DMA) in the Barcelona water distribution network (WDN)., This work has been funded by the Spanish Government (MINECO) through the project CICYT ECOCIS (ref. DPI2013-48243-C2-1-R), by MINECO and FEDER through the project CICYT HARCRICS (ref. DPI2014-58104-R), by MINECO through the grant IJCI-2014-2081, by the DGR of Generalitat de Catalunya (SAC group Ref. 2014/SGR/374), by the AGAUR of Generalitat de Catalunya through the grant 2014PDJ00102 and by EFFINET grant FP7-ICT-2012-318556 of the European Commission., Peer Reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Uncertainty effect on leak localisation in a DMA

  • Pérez, Ramon
  • Cugueró, Josep
  • Blesa, Joaquim
  • Cugueró-Escofet, Miquel Àngel
  • Sanz, Gerard
Trabajo presentado a la 3rd Conference on Control and Fault Tolerant Systems, celebrada en Barcelona (España) del 7 al 9 de septiembre de 2016., The leak localisation methodologies based on data and models are affected by both uncertainties in the model and in the measurements. This uncertainty should be quantified so that its effect on the localisation methods performance can be estimated. In this paper, a model-based leak localisation methodology is applied to a real District Metered Area using synthetic data. In the generation process of the data, uncertainty in demands is taken into account. This uncertainty was estimated so that it can justify the uncertainty observed in the real measurements. The leak localisation methodology consists, first, in generating the set of possible measurements, obtained by Monte Carlo Simulation under a certain leak assumption and considering uncertainty, and second, in falsifying sets of nodes using the correlation with a leak residual model in order to signal a set of possible leaky nodes. The assessment is done by means of generating the confusion matrix with a Monte Carlo approach., This work was partially supported by Spanish Government (MINISTERIO ECNONOMIA Y COMPETITIVIDAD) and FEDER under projects DPI2014-58104-R (HARCRICS), DPI-2013-48243-C2-1-R (ECOCIS), the grant IJCI-2014-2081, the Polytechnic University of Catalunya (UPC), EFFINET grant FP7-ICT-2012-318556 of the European Commission and by the Catalan Agency for Management of University and Research Grants (AGAUR) through the grant 2014PDJ00102., Peer Reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Fault detection and isolation in flat navigation canals

  • Segovia Castillo, Pablo
  • Rajaoarisoa, Lala
  • Duviella, Eric
  • Blesa, Joaquim
  • Nejjari, Fatiha
  • Puig, Vicenç
  • Horváth, Klaudia
Trabajo presentado a la 4th International Conference on Control, Decision and Information Technologies (CoDIT), celebrada en Barcelona (España) del 5 al 7 de abril de 2017., Inland navigation networks are composed of several artificial canals that are characterized by no slope. These canals are particularly subject to resonance phenomena, which can create waves such that the navigation condition might not be guaranteed. It is therefore required to ensure dealing with freefault measured data and actuators. In this work, a fault detection and isolation method based on the Integrator Delay Zero model (IDZ) is designed for flat navigation canals. The proposed method is dedicated to the detection and isolation of sensor and actuator faults. Finally, it is tested by considering the Cuinchy-Fontinettes canal located in the north of France., This work has been partially funded by the Spanish Ministry of Economy and Competitiveness (MINECOP) and FEDER through the project HARCRICS (ref. DPI2014-58104-R) and through the grant IJCI-2014-2081., Peer Reviewed