Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Capítulo o parte de un libro (BookPart)

Effects of different drying methods on the physicochemical properties of powders obtained from high-oleic palm oil nanoemulsions

  • Hernández-Carrión, M.
  • Moyano-Molano, M.
  • Ricaurte, L.
  • Moreno, F.L.
  • Quintanilla-Carvajal, Maria
[EN] Nanoencapsulation is an efficient process to incorporate high nutritional oils, such as high oleic palm oil (HOPO). Several drying technologies can be applied for obtaining HOPO powders. The aim of this work was to study the effect of two different drying methods (spray-drying, SP and freeze-drying, FD) on some physical properties and microstructure of powders obtained from HOPO nanoemulsions. Results showed that FD powders presented lower aw and bulk density, and higher dissolution rate than SD powders. Results suggest that SD could be a more economical alternative to FD in order to obtain HOPO powders with low moisture and aw., The authors wish to acknowledge to Banco de Desarrollo de América Latina (CAF) for the support to this research and to the Universidad de La Sabana for its help in this investigation through the funding of the ING-170-2016 project. Moreover, the authors thank to Cenipalma (Colombia) for kindly supplying the High Oleic Palm Oil used in this study and to Alexandra Mondragón Serna, Leader of the project of Health and Nutrition of Cenipalma.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Influence of Polyol/Crosslinker Blend Composition on Phase Separation and Thermo-Mechanical Properties of Polyurethane Thin Films

  • Arevalo-Alquichire, Said
  • Morales-Gonzalez, Maria
  • Navas-Gomez, Kelly
  • Diaz, Luis E.
  • Valero, Manuel F.
  • Gómez-Tejedor, José-Antonio|||0000-0001-6854-0829
  • Serrano, María-Antonia|||0000-0002-1508-6893
[EN] Polyurethanes (PUs) from Polyethylene glycol (PEG) and polycaprolactone diol (PCL) and a crosslinker, Pentaerythritol (PE), were synthetized with isophorone diisocyanate (IPDI). In this study, we investigated the effect of polyol and crosslinker composition on phase separation and thermo-mechanical properties. The properties were studied through dynamic mechanical analysis, X-ray scattering, atomic force microscopy (AFM), and thermogravimetric analysis (TGA). The results showed changes in PUs properties, microphase structure, and separation due to the composition of polyol/crosslinker blend. So, the largest concentration of PE produced multimodal loss factor patterns, indicating segment segregation while PUs with a PEG/PCL = 1 displayed a monomodal loss factor pattern, indicating a homogeneously distributed microphase separation. Additionally, the increase of the PEG concentration enhanced the damping capacity. On the other hand, agglomeration and thread-like structures of hard segments (HS) were observed through AFM. Finally, the thermal behavior of PUs was affected by chemical composition. Lower concentration of PE reduced the crosslinking; hence, the temperature with the maximum degradation rate., This work was supported by: Universidad de La Sabana (Grant number ING-176-2016); COLCIENCIAS, today Minister of Science, Technology and Innovation of the republic of Colombia, (Grant number 808-2018); Fondo Francisco Jose de Caldas (Contract number CT22-2017). CIBER-BBN is an initiative funded by the VI National R&D & I Plan 2008-2011, "IniciativaIngenio 2010", Consolider Program. CIBER actions are financed by the "Instituto de Salud Carlos III" with assistance from the European Regional Development Fund. Document