Pasar al contenido principal

INVESTIGACIÓN Y DESARROLLO DE TECNOLOGÍAS DE EGR ADAPTADAS A LAS NUEVAS ARQUITECTURAS Y REQUERIMIENTOS DE REFRIGERACIÓN EN MOTORES DIESEL SOBREALIMENTADOS PARA AUTOMOCIÓN (HIREFIRE)

IPT-370000-2010-022

•
Nombre agencia financiadora Ministerio de Ciencia e Innovación
Acrónimo agencia financiadora MICINN
Programa Programa Nacional de Cooperación Público-Privada
Subprograma Subprograma INNPACTO
Convocatoria INNPACTO
Año convocatoria 2010
Plan Estatal 2008-2011 Plan Nacional de Investigación Científica, Desarrollo e Innovación Tecnológica
Unidad de gestión Subdirección General de Centros Tecnológicos y Desarrollo Empresarial
Centro beneficiario VALEO TERMICO SA
Identificador persistente http://dx.doi.org/10.13039/501100004837

INVESTIGACIÓN Y DESARROLLO DE TECNOLOGÍAS DE EGR ADAPTADAS A LAS NUEVAS ARQUITECTURAS Y REQUERIMIENTOS DE REFRIGERACIÓN EN MOTORES DIESEL SOBREALIMENTADOS PARA AUTOMOCIÓN (HIREFIRE)

IPT-370000-2010-022

•
Nombre agencia financiadora Ministerio de Ciencia e Innovación
Acrónimo agencia financiadora MICINN
Programa Programa Nacional de Cooperación Público-Privada
Subprograma Subprograma INNPACTO
Convocatoria INNPACTO
Año convocatoria 2010
Plan Estatal 2008-2011 Plan Nacional de Investigación Científica, Desarrollo e Innovación Tecnológica
Unidad de gestión Subdirección General de Centros Tecnológicos y Desarrollo Empresarial
Centro beneficiario UNIVERSITAT POLITÈCNICA DE VALÈNCIA
Identificador persistente http://dx.doi.org/10.13039/501100004837

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

A bias correction method for fast fuel-to-air ratio estimation in diesel engines

  • Guardiola, Carlos|||0000-0002-3150-8566
  • Pla Moreno, Benjamín|||0000-0001-9238-2939
  • Blanco-Rodriguez, David
  • Mazer, Alexandre
  • Hayat, Olivier
l probes in turbocharged diesel engines are usually located downstream of the turbine, exhibiting a good dynamic response but a significant delay because of the exhaust line transport and the hardware itself. With the introduction of after-treatment systems, new sensors that can measure the exhaust concentrations are required for optimal control and diagnosis. Zirconia-based potentiometric sensors permit the measurement of nitrogen oxides and oxygen with the same hardware. However, their dynamic response is slower and more filtered than that of traditional l probes and, in addition, the sensor location downstream of the after-treatment systems increases this problem. The paper uses a Kalman filter for online dynamic estimation of the relative fuel-to-air ratio l21 in a turbocharged diesel engine. The combination of a fast drifted fuel-to-air ratio model with a slow but accurate zirconia sensor permits the model bias to be corrected. This bias is modelled with a look-up table depending on the engine operating point and is integrated online on the basis of the Kalman filter output. The calculation burden is alleviated by using the converged gain of the steady-state Kalman filter, precalculated offline. Finally, robustness conditions for stopping the bias updating are included in order to account for the sensor and model uncertainties. The proposed algorithm and sensor layout are successfully proved in a turbocharged diesel engine. Experimental and simulation results are included to support validation of the algorithm., This work was partially supported through project HIREFIRE (grant number: IPT-370000-2010-022).
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Considerations on the low-pressure exhaust gas recirculation system control in turbocharged diesel engines

  • Luján, José M.|||0000-0001-6133-8943
  • Guardiola, Carlos|||0000-0002-3150-8566
  • Pla Moreno, Benjamín|||0000-0001-9238-2939
  • Cabrera López, Pedro
Although high-pressure exhaust gas recirculation has been commonly used in turbocharged diesel engines for controlling the NOx formation, recent advances in after-treatment and material technology make possible using a low-pressure architecture, which recirculates the exhaust gas upstream the compressor. This brief article presents a basic study of control aspect related to the low-pressure architecture, emphasising the similarities and differences with the highpressure system. Data from experimental tests with both configurations and from a one-dimensional wave action model simulations are combined for the analysis of the input–output paring, linearity and the transient performance of both systems., This research has been partially financed by the Spanish Ministerio de Economia y Competitividad, through project IPT-370000-2010-022 'Investigacion y desarrollo de tecnologias de EGR adaptadas a las nuevas arquitecturas y requerimientos de refrigeracion en motores diesel sobrealimentados para automocion (HIREFIRE)'.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Potential of exhaust heat recovery for intake charge heating in a Diesel engine transient operation at cold conditions

  • Luján, José M.|||0000-0001-6133-8943
  • Climent, H.|||0000-0002-2407-5651
  • Dolz, Vicente|||0000-0003-1511-6957
  • Moratal Martínez, Ausiás Alberto
  • Borges Alejo, José
  • Soukeur, Zoulikha
In this paper, an experimental facility is implemented with the aim of improving the performance of internal combustion engines working at low ambient temperatures. Pollutant emissions and fuel consumption are one of the major issues that automotive engineers have to face. Cold engine start and warming up analysis have become important topics for researches. In this work, an exhaust heat recovery system for a diesel engine has been proposed as a solution to cold operation negative effects. The energy obtained from the exhaust gases was used to increase the intake air temperature. The experiments were carried out in transient load conditions at three different levels of ambient temperature (up to -7ºC). Exhaust heat recovery was combined with different strategies of exhaust gas recirculation. Intake air heating results with the heat recovery system show a reduction of 65% in unburned hydrocarbons, 40% in carbon monoxide and 10% in fuel use compared to standard air-air intercooler., This research has been partially financed by the Ministerio de Economia y Competitividad of Spain, through project IPT-370000-2010-022 'Investigacion y desarrollo de tecnologias de EGR adaptadas a las nuevas arquitecturas y requerimientos de refrigeracion en motores diesel sobrealimentados para automocion (HIREFIRE)'. The authors gratefully appreciate this support. Authors want to acknowledge the "Apoyo para la investigacion y Desarrollo (PAID)" grant for doctoral studies (FPI S2 2015 1062).
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

On the combination of high-pressure and low-pressure exhaust gas recirculation loops for improved fuel economy and reduced emissions in high-speed direct-injection engines

  • Desantes J.M.|||0000-0002-4124-9393
  • Luján, José M.|||0000-0001-6133-8943
  • Pla Moreno, Benjamín|||0000-0001-9238-2939
  • Soler Muniesa, José Antonio
In this paper, an experimental study of the combination of low-pressure and high-pressure exhaust gas recirculation architectures has been carried out. In the first part of the paper, the effects of both high-pressure and low-pressure exhaust gas recirculation architectures on engine behaviour and performance are analysed by means of a series of steady tests. In the second part, the effects of the combination of both architectures are addressed. The results show that the low-pressure configuration improves high-pressure exhaust gas recirculation results in brake-specific fuel consumption, nitrogen oxides and exhaust gas opacity; nevertheless, hydrocarbon emissions are increased, especially during the engine warm up. In addition, the exhaust gas recirculation rate achieved with low-pressure systems is limited by the pressure difference between diesel particulate matter outlet and compressor inlet; therefore, the high-pressure system can be used to achieve the required exhaust gas recirculation levels without increasing pumping losses. In this sense, the combination of both exhaust gas recirculation layouts offers significant advantages to reduce emissions and fuel consumption to meet future emission requirements., This work was supported by the Ministry of Science and Innovation (Spanish Government) [grant number IPT-370000-2010-022].