Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Optimal temperature range for determining magnetocaloric magnitudes from heat capacity

  • Moreno-Ramírez, Luis M.
  • Blázquez, J. S.
  • Law, Jia Yan
  • Franco, V.
  • Conde Amiano, Alejandro
The determination of the magnetocaloric magnitudes (specific magnetic entropy change, Δs , and adiabatic temperature change, ΔT ) from heat capacity (c ) measurements requires measurements performed at very low temperatures (∼0 K) or data extrapolation when the low temperature range is unavailable. In this work we analyze the influence on the calculated Δs and ΔT of the usually employed linear extrapolation of c from the initial measured temperature down to 0 K. Numerical simulations have been performed using the Brillouin equation of state, the Debye model and the Fermi electron statistics to reproduce the magnetic, lattice and electronic subsystems, respectively. It is demonstrated that it is not necessary to reach experimentally temperatures very close to 0 K due to the existence of certain starting temperatures of the experiments, the same for Δs and ΔT , that minimize the error of the results. A procedure is proposed to obtain the experimental magnitudes of Δs and ΔT with a minimum error from c data limited in temperature. It has been successfully applied to a GdZn alloy and results are compared to those derived from magnetization measurements., This work was supported by the Spanish MINECO and EU-FEDER (project MAT2013-45165-P and MAT2016-77265-R) and the PAI of the Regional Government of Andalucía. LM Moreno-Ramírez acknowledges a FPU fellowship from the Spanish MECD.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Grinding and particle size selection as a procedure to enhance the magnetocaloric response of La(Fe,Si)13 bulk samples

  • Ipus, Jhon J.
  • Borrego, J.M.
  • Moreno-Ramírez, Luis M.
  • Blázquez, J. S.
  • Franco, V.
  • Conde Amiano, Alejandro
The magnetocaloric effect of La(Fe,Si) samples deteriorates with the presence of secondary phases. However, it is highly challenging to produce single phase samples by conventional procedures and purification requires long annealing time. We propose grinding and particle size selection of non-optimal starting samples as procedure to enhance the magnetocaloric response. In this study a starting multiphase LaFeSi ingot was grinded and sieved to select three different particle size ranges. X-ray diffraction and Mössbauer spectrometry reveal that all samples mainly contain fcc-La(Fe,Si) and bcc-Fe(Si) phases. Microstructural and magnetic results show that the fcc-La(Fe,Si) phase fraction increases for samples with the smallest average particle size, increasing their magnetocaloric response in a factor larger than three with respect to that of the bulk sample., This work was supported by the Spanish MINECO and EU FEDER (projects MAT2013-45165-P and MAT2016-77265-R) and the PAI of the Regional Government of Andalucía. L.M. Moreno-Ramírez acknowledges a FPU fellowship from the Spanish MECD.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Predicting the tricritical point composition of a series of LaFeSi magnetocaloric alloys via universal scaling

  • Franco, V.
  • Law, Jia Yan
  • Conde Amiano, Alejandro
  • Brabander, V.
  • Karpenkov, D. Y.
  • Radulov, I.
  • Skokov, K.
  • Gutfleisch, O.
Typically, the most common techniques to determine the order of the phase transition of magnetocaloric materials do not allow a quantitative prediction of the composition that corresponds to the change from first to second order phase transition, i.e. the so-called tricritical point of an alloy series. In this work, we study a series of LaFeSi alloys in which the different Fe/Si ratio produces a change in the order of the transition. We show the quantitative prediction of the tricritical composition analyzing the field dependence of the peak magnetic entropy change. The proposed procedure is also simple to implement, as it does not require any modelling of the experimental data and it only requires temperature and field dependent magnetization experiments. It is shown that the obtained value is in agreement with the results emerging from the most commonly used qualitative techniques., This work was supported by MINECO and EU FEDER (project MAT2013-45165-P), AEI/FEDER-UE (project MAT-2016-77265-R), the PAI of the Regional Government of Andalucía, the Deutscher Akademischer Austauschdienst DAAD (Award A/13/09434). OG, IR, and KS would like to acknowledge funding by the DFG in the framework of the priority program 'Ferroic Cooling' (SPP1599).
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Nanostructuring as a procedure to control the field dependence of the magnetocaloric effect

  • Doblas, D.
  • Moreno-Ramírez, Luis M.
  • Franco, V.
  • Conde Amiano, Alejandro
  • Svalov, A. V.
  • Kurlyandskaya, G. V.
In this work, the field dependence of the magnetocaloric effect of Gd bulk samples has been enhanced through nanostructuring of the material. Nanostructuring consists in multilayers preparation by alternative rf-sputtering deposition of Gd layers and Ti spacers onto glass substrates. The results obtained for the multilayers were compared to those obtained for the Gd bulk. Assuming a power law for the field dependence of the magnetic entropy change (ΔS ∝ H), higher field dependences close to the transition in a wider temperature range are obtained for the multilayer material (n = 1.0) with respect to the bulk counterpart (n = 0.78). The effect of a Curie temperature distribution in the multilayer material (due to variations of the layer thickness) has been studied through numerical simulations to explain the observed field dependence of the magnetocaloric effect, obtaining a remarkable agreement between experiments and results., This work was supported by the Spanish MINECO and EU-FEDER (projects MAT2013-45165-P and MAT2016-77265-R), the PAI of the Regional Government of Andalucía, and the Ministry of Education and Science of the Russian Federation (Project No. 2582). L.M. Moreno-Ramírez acknowledges a FPU fellowship from the Spanish MECD.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Two different critical regimes enclosed in the Bean-Rodbell model and their implications for the field dependence and universal scaling of the magnetocaloric effect

  • Romero-Muñiz, Carlos
  • Franco, V.
  • Conde Amiano, Alejandro
In the last few years power laws and universal scaling have been extensively used to study the field dependence of the magnitudes involved in the magnetocaloric effect of materials. They are key tools which allow us to compare the performing properties of different materials regardless of their nature, processing or experimental conditions during measurements. It was proved that power laws and universal scaling are a direct consequence of critical phenomena in the neighborhood of phase transitions. However, there remains some controversy about the reliability of these procedures. In this work we use the well-known Bean-Rodbell model to confirm that these features are unmistakably related to the critical behavior of the continuous phase transitions. In this specific model, universal scaling occurs either at a purely mean field second order transition or at a tricritical point. Finally, we analyze in detail if the universal scaling is compatible with materials at the tricitical point, making a comprehensive comparison with available experimental data from the literature. We conclude that it is really difficult to know with full certainty if a sample really is in the tricritical regime., This work was supported by the Spanish MINECO and EU FEDER (Projects MAT2013-45165-P and MAT2016-77265-R) and the PAI of the Regional Government of Andalucía. CRM is grateful to a FPI-UAM graduate scholarship program and Fundación Universia for financial support.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Magnetocaloric effect: From materials research to refrigeration devices

  • Franco, V.
  • Blázquez, J. S.
  • Ipus, Jhon J.
  • Law, Jia Yan
  • Moreno-Ramírez, Luis M.
  • Conde Amiano, Alejandro
The magnetocaloric effect and its most straightforward application, magnetic refrigeration, are topics of current interest due to the potential improvement of energy efficiency of cooling and temperature control systems, in combination with other environmental benefits associated to a technology that does not rely on the compression/expansion of harmful gases. This review presents the fundamentals of the effect, the techniques for its measurement with consideration of possible artifacts found in the characterization of the samples, a comprehensive and comparative analysis of different magnetocaloric materials, as well as possible routes to improve their performance. An overview of the different magnetocaloric prototypes found in literature as well as alternative applications of the magnetocaloric effect for fundamental studies of phase transitions are also included., This work was supported by the Spanish MINECO (project MAT2013-45165-P), AEI/FEDER-UE (project MAT-2016-77265-R) and the PAI of the Regional Government of Andalucía. L.M. Moreno-Ramírez acknowledges a FPU fellowship from the Spanish MECD.