Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Nanoindentation and tapping mode AFM study of phase separation in poly(ethyl acrylate-co-hydroxyethyl methacrylate) copolymer networks

  • Salmerón Sánchez, Manuel
  • Romero Colomer, Francisco Jose
  • Molina Mateo, José|||0000-0002-0531-9876
  • Gómez Ribelles, José Luís|||0000-0001-9099-0885
[EN] According to our previous results the free radical copolymerization of ethyl acrylate and hydroxyethyl methacrylate gives rise to a system having chain composition and morphology different from that of the random mixture in the original solution. Besides, structural relaxation experiments revealed the existence of composition heterogeneity in the material. In this work, a deeper insight in the structure of this system is gained using atomic force microscopy (AFM) in the tapping mode and nanoindentation experiments. The material architecture of the copolymerized system is revealed to be formed by nanoaggregates as a consequence of the non-random polymerization process of the comonomers. (c) 2006 Elsevier Ltd. All rights reserved., The authors acknowledge the support of the Spanish Science and Technology Ministry through the MAT2001-2678-C02-01 project and the support to their research group by the Generalitat Valenciana through the Grupos 03/018 project. AFM was conducted by the microscopy service of the UPV, whose advice was greatly appreciated
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Thermal analysis of water in reinforced plasma-polymerised poly(2-hydroxyethyl acrylate) hydrogels

  • Serrano Aroca, Ángel
  • Rault, J.
  • Monleón Pradas, Manuel|||0000-0001-6457-0414
  • Gómez Ribelles, José Luís|||0000-0001-9099-0885
Thermal analysis of water in reinforce hydrogels of plasma-polymerised poly(2-hydroxyethyl acrylate) (plPHEA) grafted onto macroporous poly(methyl methacrylate) (PMMA) are explained in a simple thermodynamic framework based on the transition diagram. Water in bulk PHEA was also analysed for comparison with plPHEA. These two hydrophilic polymers were prepared with a broad range of water mass fractions from 0.05 to 0.72. Thermal transition diagrams of water/PHEA and water/plPHEA were determined showing less undercooling of water crystallisation in plPHEA than in PHEA. Kinetics of water crystallisation for high and low water contents were studied in both hydrophilic systems following several thermal treatments. Water crystallises much faster in plPHEA than in PHEA for high water contents. For low water contents, crystallisation becomes possible holding at 30 degrees C for some time due to water segregation in both PHEA systems. However, much less water is segregated from the water/plPHEA mixture due to the influence of the hydrophobic component., This work was supported by a Marie Curie Host Fellowship and by the Spanish Science and Technology Ministry through the MAT2001-2678-C02-01 and MAT2002-04239-C03-03 projects. CIBER-BBN is an initiative funded by the VI National R&D&i Plan 2008-2011, Iniciativa Ingenio 2010, Consolider Program, CIBER Actions and financed by the Instituto de Salud Carlos III with assistance from the European Regional Development Fund.