Pasar al contenido principal

MECANOSINTESIS DE MATERIALES DE INTERES TECNOLOGICO

MAT2010-17046

•
Nombre agencia financiadora Ministerio de Ciencia e Innovación
Acrónimo agencia financiadora MICINN
Programa Programa Nacional de Proyectos de Investigación Fundamental
Subprograma Subprograma de Proyectos de Investigación Fundamental no Orientada
Convocatoria Proyectos I+D
Año convocatoria 2010
Plan Estatal 2008-2011 Plan Nacional de Investigación Científica, Desarrollo e Innovación Tecnológica
Unidad de gestión Subdirección General de Proyectos de Investigación
Centro beneficiario AGENCIA ESTATAL CONSEJO SUPERIOR DE INVESTIGACIONES CIENTIFICAS (CSIC)
Identificador persistente http://dx.doi.org/10.13039/501100004837

Resultados relacionados

Resultados totales (Incluyendo duplicados): 1
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Spark plasma sintering of TiyNb1-yCxN1-x monolithic ceramics obtained by mechanically induced self-sustaining reaction

  • Borrell Tomás, María Amparo|||0000-0003-4292-4538
  • Salvador Moya, Mª Dolores|||0000-0002-4242-478X
  • Garcia-Rocha, Victoria
  • Fernandez, Adolfo
  • Chicardi, Ernesto
  • Gotor, Francisco J.
Nanometer-sized titanium-niobium carbonitride powders (TiyNb1-yCxN1-x) with different Ti/Nb atomic ratios were obtained by a mechanically induced self-sustaining reaction, and sintered by spark plasma sintering technique at 1500 degrees C for 1 min in a vacuum atmosphere. Mechanical properties such as hardness and Young's modulus were determined by nanoindentation technique and friction and wear coefficients assessed by ball-on-disk testing using alumina ball in dry sliding conditions. The fracture surface and wear tracks of samples were examined by scanning electron microscopy. Results showed that it is possible to obtain dense monolithic ceramics from the solid solution (TiyNb1-yCxN1-x) with good mechanical properties and excellent wear resistance. The optimum values of nanomechanical properties were found for the Ti0.3Nb0.7C0.5N0.5 ceramic composition, which exhibited a high hardness over 26.0 GPa and Young's modulus around 400 GPa. Crown Copyright (C) 2012 Published by Elsevier B.V. All rights reserved., The authors would like to thank Dr. Emilio Rayon for performing the nanoindentation analysis in the Materials Technology institute (ITM) of the Polytechnic University of Valencia and to acknowledge the financial support received from Spanish Ministry of Science and Innovation for FPI grant (MAT2006-01783). This work was supported by the Spanish government under grant (MAT2010-17046), which is financed in part by the European Regional Development Fund of 2007-2013. E. Chicardi was supported by CSIC through a JAE-Pre grant, which is financed in part by the European Social Fund (ESF).