Pasar al contenido principal

OPTIMIZACION Y VIABILIDAD INDUSTRIAL DEL PROCESO DE PREPARACION DE CAPAS DE CONVERSION BASADAS EN CERIO SOBRE ALEACIONES DE ALUMINIO DE USO AEROESPACIAL.

MAT2014-60857-R

•
Nombre agencia financiadora Ministerio de Economía y Competitividad
Acrónimo agencia financiadora MINECO
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos I+D+i Retos de Investigación
Año convocatoria 2014
Plan Estatal 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Unidad de gestión Secretaría de Estado de Educación, Formación Profesional y Universidades
Centro beneficiario UNIVERSIDAD DE CADIZ
Identificador persistente http://dx.doi.org/10.13039/501100003329

Resultados relacionados

Resultados totales (Incluyendo duplicados): 1
Encontrada(s) 1 página(s)

RODIN. Repositorio de Objetos de Docencia e Investigación de la Universidad de Cádiz
Publicación Artículo científico (JournalArticle)

Application of Commercial Surface Pretreatments on the Formation of Cerium Conversion Coating (CeCC) over High-Strength Aluminum Alloys 2024-T3 and 7075-T6

  • Alba Galvín, Juan Jesús
  • González Rovira, Leandro
  • Botana Pedemonte, Francisco Javier
  • Lekka, Maria
  • Andreatta, Francesco
  • Fedrizzi, Lorenzo
  • Bethencourt Núñez, Manuel
The selection of appropriate surface pretreatments is one of the pending issues for the industrial application of cerium-based chemical conversion coatings (CeCC) as an alternative for toxic chromate conversion coating (CrCC). A two-step surface pretreatment based on commercial products has been successfully used here to obtain CeCC on AA2024-T3 and AA7075-T6. Specimens processed for 1 to 15 min in solutions containing CeCl3 and H2O2 have been studied by scanning electron microscopy coupled with energy-dispersive X-ray analysis (SEM-EDX), glow discharge optical emission spectroscopy (GDOES), potentiodynamic linear polarization (LP), electrochemical impedance spectroscopy (EIS), and neutral salt spray (NSS) tests. SEM-EDX showed that CeCC was firstly observed as deposits, followed by a general coverage of the surface with the formation of cracks where the coating was getting thicker. GDOES confirmed an increase of the CeCC thickness as the deposition proceed, the formation of CeCC over 7075 being faster than over 2024. There was a Ce-rich layer in both alloys and an aluminum oxide/hydroxide layer on 7075 between the upper Ce-rich layer and the aluminum matrix. According to LP and EIS, CeCC in all samples offered cathodic protection and comparable degradation in chloride-containing media. Finally, the NSS test corroborated the anti-corrosion properties of the CeCC obtained after the commercial pretreatments employed., This research was funded by the Ministry of Economy, Industry and Competitiveness of Spain/FEDER Program of the EU. Project: Optimizacion y viabilidad industrial del proceso de preparacion de capas de conversion basadas en cerio sobre aleaciones de aluminio. Reference MAT2014-60857-R. The APC was funded by Instituto Universitario de Investigacion Marina (INMAR) of the University of Cadiz and the Programa de Fomento e Impulso de la Actividad de Investigacion y Transferencia of the University of Cadiz.