Pasar al contenido principal

RESIDUOS AGRICOLAS DEL AREA MEDITERRANEA: RECURSOS MEDIOAMBIENTALMENTE SOSTENIBLES PARA UNA INNOVADORA TECNOLOGIA ENERGETICA RENOVABLE

PCIN-2017-048

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos Programación Conjunta Internacional
Año convocatoria 2017
Plan Estatal 2017-2020 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSIDAD DE ZARAGOZA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Effects of biochar application in a sorghum crop under greenhouse conditions: Growth parameters and physicochemical fertility

  • Videgain-Marco, María
  • Marco-Montori, Pedro
  • Martí-Dalmau, Clara
  • Jaizme-Vega, María del Carmen
  • Manyà-Cervelló, Joan Josep
  • García-Ramos, Francisco Javier
Application of biochar from vine shoots (Vitis vinifera L.) as an organic amendment in the soil is an alternative agricultural management of interest. The behavior of this type of amendment in the soil requires more information to adjust the pyrolysis conditions in order to obtain a high-quality biochar. The aim of this work is determining the influence of the application of this type of biochar on the soil-plant system. For this purpose, an agronomic test was performed in greenhouse pots. A randomized tri-factorial block design was adopted with the following factors: final pyrolysis temperature (400 and 600 ¿C), application rate (0 wt. % as a control, 1.5 and 3 wt. %) and texture of the growing media (sandy-loam and clay-loam origin). The selected crop was sorghum (Sorghum bicolor L. Moench), the development and production of which was evaluated during two complete growing cycles under greenhouse conditions. Application of biochar produced at 400 ¿C significantly increased plants roots dry weight in the sandy-loam growing substrate (52% compared to the control). Grain production was also significantly affected by biochar application, showing better results after addition of biochar produced at 400 ¿C. Water holding capacity and K, Ca, and Mg contents were enhanced by biochar addition, with evident effects of the application ratios for some of these variables. The effect on the pH of substrates in the sandy-loam texture was weak; however, a significant decrease was observed after the addition of biochar produced at 600 ºC.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Adsorption performance of physically activated biochars for postcombustion Co2 capture from dry and humid flue gas

  • Manyà, Joan J.
  • García-Morcate, David
  • González, Belén
In the present study, the performance of four biomass-derived physically activated biochars for dynamic CO2 capture was assessed. Biochars were first produced from vine shoots and wheat straw pellets through slow pyrolysis (at pressures of 0.1 and 0.5 MPa) and then activated with CO2 (at 0.1 MPa and 800 C) up to different degrees of burn-off. Cyclic adsorption-desorption measurements were conducted under both dry and humid conditions using a packed-bed of adsorbent at relatively short residence times of the gas phase (12-13 s). The adsorbent prepared from the vine shoots-derived biochar obtained by atmospheric pyrolysis, which showed the most hierarchical pore size distribution, exhibited a good and stable performance under dry conditions and at an adsorption temperature of 50 C, due to the enhanced CO2 adsorption and desorption rates. However, the presence of relatively high concentrations of water vapor in the feeding gas clearly interfered with the CO2 adsorption mechanism, leading to significantly shorter breakthrough times. In this case, the highest percentages of a used bed were achieved by one of the other activated biochars tested, which was prepared from the wheat straw-derived biochar obtained by pressurized pyrolysis.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Activated olive mill waste-based hydrochars as selective adsorbents for CO2 capture under postcombustion conditions

  • González, B.
  • Manyà, J. J.
Porous carbons are considered to be promising sorbents for carbon capture and sequestration. As precursors, the use of biomass materials has acquiring special interest due to its low cost and high availability. Among all the possibilities to convert low-value biomass into these interesting sorbents, hydrothermal carbonization has demonstrated several advantages such as lower energy consumption over pyrolysis. In this work, activated hydrochars using two-phase olive mill waste as precursor have been prepared through physical and chemical activation using CO2 and KOH, respectively. Additionally, with the aim to study the influence of the nitrogen on their adsorption capacity, N-doped adsorbents have been prepared through a one-step hydrothermal carbonization. The behaviour of these adsorbents has been studied in terms of CO2 uptake capacity at an absolute pressure of 15 kPa and temperatures of 0, 25 and 75 °C, apparent selectivity towards CO2 over N2, and isosteric heat of adsorption. Among all these samples, the physically activated hydrochar appears to be the best due to its higher CO2 uptakes, adsorption rates and values of selectivity at 25 °C. Therefore, considering these results, doping these materials with nitrogen does not appear to enhance their adsorption properties, contrary to what some authors have previously reported. © 2020 Elsevier B.V.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Effects of pyrolysis temperature and pressure on agronomic properties of biochar

  • Balmuk, Gizem
  • Videgain, María
  • Manyà, Joan J.
  • Duman, Gozde
  • Yanik, Jale
This study focused on identifying the effect of pyrolysis temperature and pressure for lignocellulosic biomass on agronomic properties of biochar. For this purpose, two biomasses (vine shoots -VS and corn stover -CS) were pyrolyzed at different temperatures (350 and 500 °C) under different pressures (0.1 and 0.5 MPa) for a residence time of 60 min. Agronomic properties of biochars (including stability, pH, CEC, EC, bulk density, surface properties, and water holding capacity) were determined. Pyrolysis temperature impacted greatly on the biochar stability and the textural properties. The dependence of other properties of biochars on pressure and temperature varied as a function of the type of feedstock. In addition, the effects of pyrolysis temperature and pressure on 16 US EPA PAH concentration in biochar were also investigated. The PAH concentrations ranged between 0.822 and 5.112 mg kg−1. On average, VS-derived biochar had higher PAH concentrations than CS-derived one. The structural differences in biomass played a key role in determining the effect of pyrolysis conditions on total PAH concentration.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Influence of feedstock and final pyrolysis temperature on breaking strength and dust production of wood-derived biochars

  • Videgain, M.
  • Manyà, J.J.
  • Vidal, M.
  • Correa, E.C.
  • Diezma, B.
  • García-Ramos, F.J.
The susceptibility to fragmentation of biochar is an important property to consider in field applications. Physical and mechanical properties of wood-derived biochars from vine shoots and holm oak were studied to evaluate the effect of biomass feedstock, final pyrolysis temperature and application conditions. Vine shoots and holm oak pruning residues were selected for biochar production. Slow pyrolysis experiments were conducted at two different final temperatures (400 and 600¿C). Physical and chemical characteristics of biomass and biochars were determined. Impact strength was evaluated through the measurement of the gravitational potential energy per unit area (J mm-2 ) necessary for the breakage of biochar fragments. Shear strength (N mm-2 ) and a combination of shear/compression strengths (N) were analyzed using a Universal Texture Analyzer. A particular mechanical treatment was carried out on biochar samples to simulate the processing bodies of a commercial manure spreader, under two gravimetric moisture contents. Holm oak-derived biochar was more resistant than vine shoot-derived biochar to the applied forces. Vine shoots-derived biochar did not show a significantly different mechanical behavior between temperatures. Holm Oak-derived biochar produced at the higher final pyrolysis temperature showed higher resistance to be broken into smaller pieces. Moistening resulted in an adequate practice to improve mechanical spreading. © 2021 by the authors. Licensee MDPI, Basel, Switzerland.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

The effects of biochar on indigenous arbuscular mycorrhizae fungi from agroenvironments

  • Videgain-Marco M.
  • Marco-Montori P.
  • Martí-Dalmau C.
  • Jaizme-Vega M.C.
  • Manyà-Cervelló J.J.
  • García-Ramos F.J.
The effects of biochar on soil–plant–microorganisms systems are currently being extensively investigated. Considering that arbuscular mycorrhizal fungi (AMF) play an essential role in nutrient dynamics, the present study aims at understanding vine shoot-derived biochar effects on AMF activity and the impact of their multiplication in soils on water-stress resistance of plants. Three agronomic tests were performed in greenhouse pots. The first experiment evaluated the effects of three factors: final pyrolysis temperature for biochar production (400 °C and 600 °C), application rate (0 weight-wt.- % as a control, 1.5 wt. %, and 3.0 wt. %) and texture of the growing media (sandy-loam and clay-loam origin) on AMF, microbial communities and phosphatase activity. In the second experiment, an indigenous consortium of AMF was multiplied through the solid substrate method and sorghum as a trap plant with biochar addition. This process was compared to a control treatment without biochar. Obtained inocula were tested in a third experiment with lettuce plants under different water irrigation conditions. Results from the first experiment showed a general increase in AMF activity with the addition of the biochar produced at 400 °C in the sandy-loam texture substrate. Results of the second experiment showed that the biochar addition increased AMF root colonization, the number of AMF spores and AMF infective potential. Results of the third experiment showed that biochar-derived AMF inoculum increased AMF root colonization, AMF spores, dry biomass and the SPAD index in a lettuce crop under low-water irrigation conditions.