UPCommons. Portal del coneixement obert de la UPC
Publicación
Artículo científico (JournalArticle)
Effective current-driven memory operations for low-power ReRAM applications
© 2023 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes,creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works.
Al document ha d’aparèixer l’enllaç a la publicació original a IEEE, o bé al Digital Object Identifier (DOI)., Resistive switching (RS) devices are electronic components which exhibit a resistive state that can be adjusted to different nonvolatile levels via electrical stressing, fueling the development of future resistive memories (ReRAM) and enabling innovative solutions for several applications. Most works so far have used voltage-based driving schemes for both WRITE and READ operations. However, results from current-driven WRITE operations have shown high uniformity in switching performance, and thus constitute a valid alternative to consider, but current-driven READ operations have rarely been explored. In this context, here we tested a current-based READ/WRITE memory driving scheme on commercial self-directed channel (SDC) devices, while operating constantly at low current levels between tenths of nA and 1.5 uA. We propose a novel method to carry out efficient READ operations exploiting the transient response of the voltage on the current-driven ReRAM memory cells. For READ operations performed at 100 nA, we calculated the cumulative probability distribution of the standard deviation of the measured voltage ( σV ) on the devices and we observed a ratio σV−HRS/σV−LRS∼10× . Moreover, the HRS and LRS states were distinguishable in all the tested devices with less than 0.5% error. Finally, the calculated energy consumption ( ESET≈10 nJ, ERESET≈30 nJ, and EREAD between 80–400 pJ) was competitive even when the duration of the READ/WRITE current pulses was suboptimal in the millisecond range. Therefore, the presented results validate the promising characteristics and the power-efficiency of the proposed READ method for current-driven ReRAM circuits and applications., This work was supported in part by the Chilean Government through the National Fund for Scientific and Technological Development
(FONDECYT) under Grant 1221747; in part by the National Agency for Research and Development (ANID)-Basal under Grant FB0008;
in part by the MICINN, Spain, through PRITES Project under Grant PID2019-105658RB-I00; and in part by FLEXRRAM Project under
Grant TED2021-129643B-I00., Peer Reviewed