Pasar al contenido principal

TRATAMIENTO DE PURINES PARA LA RECUPERACION DE ENERGIA Y AMONIACO. AVANZANDO HACIA LA SOSTENIBILIDAD DEL SECTOR AGROALIMENTARIO

PID2022-137016OB-I00

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal para Impulsar la Investigación Científico-Técnica y su Transferencia
Subprograma Subprograma Estatal de Generación de Conocimiento
Convocatoria Proyectos de I+D+i (Generación de Conocimiento y Retos Investigación)
Año convocatoria 2022
Plan Estatal 2021-2023 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSIDAD DE ZARAGOZA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

The role of biogenic waste composition on pyrolysis: Part I – Char properties

  • Navarro, África
  • Fonts, Isabel
  • Ruiz, Joaquín
  • Ceamanos, Jesús
  • Gil-Lalaguna, Noemí
  • Murillo, María Benita
  • Gea, Gloria
The yield and properties of char derived from the co-digested manure and its main macro-components, including organic (cellulose, lignin, and protein) components and an inorganic component (CaCO3), produced at different pyrolysis temperatures (350, 550, and 750 °C) have been studied. Experimental results obtained from a surrogate co-digested manure were compared with the theoretically calculated values to explore potential interactions between these macro-components. The char properties analyzed included elemental analysis, pH, FTIR, XPS, and specific surface area. The effect of pyrolysis temperature on many properties was similar, regardless of the precursor (macro-component). Increasing pyrolysis temperature led to higher C content (>90 wt% for cellulose char at 750 °C), pH (from (∼7 for cellulose at 350 °C to ∼13 for co-digested manure), and specific surface area, observing a marked development of ultramicroporosity and microporosity, especially at the highest pyrolysis temperature studied, 750 °C. An exception was observed for the char derived from proteins due to melting during pyrolysis. By far, the solids from the pyrolysis of cellulose and lignin exhibited the most microporosity development (SSDR ≥ 650 m2 g-1), reaching, at the highest temperature studied, values close to those of physically activated carbons. Pyrolysis of the surrogate co-digested manure revealed the occurrence of Maillard reactions and also showed an interesting interaction involving CaCO3. The CaCO3 thermal decomposition is promoted when it is embedded into the organic matrix, where the CO2 generated during decomposition favored the Boudouard reaction of C from the organic components. This results in a lower biochar yield, 32 wt% versus 37 wt% (expected value), and a higher development of microporosity in the char.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

The role of biogenic waste composition on pyrolysis: Part II – Char CO2 adsorption capacity

  • Navarro, África
  • Fonts, Isabel
  • Ruiz, Joaquín
  • Ceamanos, Jesús
  • Gil-Lalaguna, Noemí
  • Ábrego, Javier
  • Gea, Gloria
The CO2 adsorption capacities (AC) of biochars obtained at 350, 550, and 750 °C from the main organic (cellulose, lignin, and protein) and inorganic (CaCO3) macro-components of biogenic waste, as well as from co-digested manure (CDM), have been determined for different CO2 concentrations (2–83 vol%) at 25 °C and atmospheric pressure. CO2 adsorption isotherms have been determined using two different experimental methodologies: thermogravimetric and fixed-bed dynamic adsorption tests, yielding similar results. The composition effect has been analyzed by comparing the adsorption performance of the chars derived from individual macro-components and the potential interactions occurring during their co-pyrolysis. Lignin and cellulose-derived chars showed higher CO2 retention (≈77 mg gbiochar−1) than those produced from protein (≈40 mg gbiochar−1). Pyrolyzed CaCO3 exhibited negligible CO2 adsorption. For surrogate_CDM chars, prepared at pyrolysis temperatures high enough to decompose CaCO3 in the organic matrix, experimental results showed a synergistic effect, with AC between 14 % and 47 % higher than theoretical predictions. This decomposition promoted the reverse Boudouard reaction and enhanced char microporosity. However, the improvement was insufficient to offset the dilution effect caused by the high CaCO3 content. AC results have been discussed based on the biochar textural and chemical properties, with ultramicroporosity being the key factor determining adsorption capacity. The AC of CDM-derived sorbents is similar to that of cellulose-derived, expressed per gram of waste (7–13 mg gwaste−1). Furthermore, the biochars retained at least 80 % of their initial AC after 3 adsorption-desorption cycles, indicating their potential for stable CO2 capture.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Estudio de la Descomposición Térmica del Amoníaco en un Reactor de Acero Inoxidable: Producción de amoníaco y perspectivas sostenibles

  • Zambrano Bedón, Guisela
  • Gea, Gloria
  • Fonts, Isabel
  • Ramos, Cristina
  • Millera, Angela
  • Gil-Lalaguna, Noemí
Este estudio analiza cómo la temperatura influye en la descomposición del amoníaco (NH₃) durante procesos de gasificación, utilizando un reactor tubular de acero inoxidable. En particular, se investiga el impacto del material del reactor en la conversión del amoníaco, con el objetivo de comprender cómo sus propiedades pueden afectar el comportamiento térmico de la reacción.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Rice husk pristine biochar for dynamic gas-phase NH3 adsorption: impact of pyrolysis temperature and mechanism

  • Lete, Alejandro
  • Navarro-Gil, África
  • Millera, Ángela
  • Fonts, Isabel
  • Ceamanos, Jesús
  • Gil-Lalaguna, Noemí
  • Gea, Gloria
Ammonia (NH3) is a key atmospheric pollutant emitted from livestock housing and manure management, that contributes to PM2.5 formation, ecological eutrophication, and health risks. Developing economically feasible technologies based on low-cost adsorbents for NH3 capture is therefore crucial. Rice husk (RH), an abundant agro-industrial residue, represents a sustainable carbon precursor. In this work, RH-biochars were synthesized at three pyrolysis temperatures (350, 550, and 750 °C) and were systematically assessed for continuous NH3 adsorption. Comprehensive characterization was performed to establish properties-adsorption relationships. Pyrolysis temperature exerted a dual influence: higher temperatures enhanced surface area and microporosity, while simultaneously reducing surface acidity due to the progressive loss of oxygenated groups. NH3 adsorption capacities ranged from 3.8 ± 0.1 to 7.5 ± 0.3 mg NH3 g−1 at 1,000 ppm of NH3 and 25 °C (conditions selected as representative of those encountered in pig manure storage and air stripping management), with RH-350 being the most efficient biochar, achieving capacities comparable to many activated carbons without requiring chemical activation or metal impregnation. Characterization and thermodynamic analyses revealed that this superior uptake derives from the prevalence of oxygen-containing functionalities which promote NH3 binding through hydrogen-bonding, outweighing the influence of textural properties. The calculated adsorption enthalpy (−31 ± 4 kJ mol−1) using the Sips model confirmed this interaction, which enabled the complete regeneration of RH-350 sample at 150 °C across consecutive cycles. These findings provide mechanistic insight into gas-solid interactions on oxygen-rich carbon surfaces and support the use of pristine RH-biochars as competitive and regenerable adsorbents for NH3 capture.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Contribución de congreso (ConferenceOutput)

Influencia de la temperatura y del CaO en la descomposición térmica de NH3

  • Zambrano B., Guisela
  • Gea, Gloria
  • Fonts, Isabel
  • Sampayo, Manuel
  • Gil-Lalaguna, Noemí
Como estudio preliminar para la producción de amoníaco (NH₃) mediante gasificación de residuos agroganaderos, se analiza la descomposición de NH3 a 600–800 °C con y sin CaO. El CaO incrementa la conversión, aunque la temperatura domina: 600–700 °C con CaO no alcanzan las conversiones obtenidas a 800 °C sin lecho.