DIGITAL.CSIC. Repositorio Institucional del CSIC
Datos de investigación
Set de datos (Dataset)
Reversible low-pressure barocaloric effect from mixed‑phase stabilization in a hybrid cadmium perovskite [Dataset]
[Sample preparation and characterization] The layered hybrid organic–inorganic perovskite (C9H19NH3)2CdCl4 (C9CdCl) was synthesized following the procedure described in the associated manuscript. Phase purity was verified by powder X-ray diffraction (PXRD)., [Adiabatic calorimetry] Heat-capacity measurements were performed using an AK-6-25 adiabatic calorimeter (AOZT Termis). Measurements were carried out over the temperature range encompassing the structural phase transitions. The transition entropy and enthalpy changes were determined from the temperature dependence of the heat capacity., [Differential scanning calorimetry] Differential scanning calorimetry (DSC) measurements were conducted using a TA Instruments DSC Q2000 calorimeter equipped with a Refrigerated Cooling System (RCS90) and a standard DSC cell. Approximately 4 mg of sample was sealed in Tzero Aluminum Hermetic pans and measured under a continuous nitrogen flow. Heat-capacity measurements were calibrated using sapphire standards. Additional DSC experiments were performed at different heating and cooling rates to evaluate the kinetic dependence of the phase transitions., [Powder X-ray diffraction] Laboratory PXRD measurements were carried out using a Rigaku D-Max diffractometer with Cu Kα₁,₂ radiation over the 2θ range 2.5–50°. Temperature-dependent PXRD data were collected using a Rigaku variable-temperature stage, allowing in situ measurements between 93 and 573 K., [Synchrotron X-ray powder diffraction] High-resolution synchrotron X-ray powder diffraction (SXRPD) measurements were performed at the MSPD beamline of the ALBA Synchrotron (Spain) and at beamline I15 of Diamond Light Source (United Kingdom). Temperature-dependent and pressure-dependent diffraction patterns were collected to investigate the structural evolution across the phase transitions.
At Diamond Light Source, high-pressure diffraction experiments were performed using a high-pressure jump cell enabling continuous pressure variation up to approximately 3.5 kbar. Powder samples were loaded into sealed Kapton capillaries, while pressure was transmitted hydrostatically through deionized water surrounding the capillary. Both isothermal and isobaric diffraction measurements were carried out over the ranges 278–330 K and 0.4–2.0 kbar., [High-pressure calorimetry] Barocaloric measurements were performed using a custom-built high-pressure calorimetric setup incorporating a calorimeter within a Be–Cu pressure cell. A surface-mount resistor served simultaneously as sample holder and temperature sensor, while Daphne 7373 oil was employed as the hydrostatic pressure-transmitting medium. Measurements were conducted in an Oxford Instruments OptistatDN cryostat operating between 77 and 400 K., Pressure‑driven phase transitions provide a means to modulate entropy in solids, although achieving large and reversible caloric responses remains a central challenge. The layered hybrid organic-inorganic perovskite (C9H19NH3)2CdCl4 exhibits two first-order transitions near room temperature that underpin its barocaloric response. High‑pressure calorimetry combined with synchrotron X‑ray diffraction shows that compression stabilizes a mixed‑phase region over a wide pressure-temperature range rather than inducing a complete transformation. Consequently, the effective entropy change decreases with pressure, while a substantial reversible contribution is preserved, yielding reversible entropy and temperature changes of ΔSᵣₑᵥ ≈ 136 J kg⁻1 K⁻1 and ΔTᵣₑᵥ ≈ 17 K for a pressure change of 0.8 kbar. This leads to a refrigerant capacity exceeding 4 kJ kg⁻1 with a favorable coefficient of performance in the low-pressure regime. Notably, the large reversible temperature changes achieved at comparatively low pressures and close to room temperature highlight the potential of this material for solid-state cooling. Overall, these results demonstrate that high caloric performance can be achieved without complete phase transformation, reflecting a trade-off between entropy change and reversibility in soft hybrid lattices., This work was supported by Spanish MICIU/AEI/10.13039/501100011033/ and ERDF/EU (PID2024-159457OB-C21, CEX2023-001286-S). This work was carried out with the support of Diamond Light Source, instrument I15 (proposal CY40151) and ALBA Synchrotron, MSPD beamline (proposal 2024098680). E.K.C. acknowledges financial support from MICIU through a doctoral fellowship (PRE2022-103760). The authors acknowledge the Servicio General de Apoyo a la Investigación from Universidad de Zaragoza., With funding from the Spanish government through the "Severo Ochoa Centre of Excellence" accreditation (CEX2023-001286-S)., No
Proyecto:
AEI / Plan Estatal de Investigación Científica y Técnica y de Innovación 2024-2027 PID2024-159457OB-C21
,
AEI / Plan Estatal de Investigación Científica y Técnica y de Innovación 2021-2023 CEX2023-001286-S
,
AEI / Plan Estatal de Investigación Científica y Técnica y de Innovación 2021-2023 PRE2022-103760