Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Improved photoenergy properties of low-emissivity coatings deposited by sputtering with an ion gun treatment

  • Carretero, E.
  • Cueva, A.
  • Preciado-Garbayo, J.
  • Sevillano, P.
This work studies the effect of ion treatment on low-emissivity (low-e) coatings deposited by magnetron sputtering. Specifically, we have investigated the application of an ion treatment in the dielectric layer before deposition of a layer of silver. This reduces layer roughness which means the silver layer can be deposited with enhanced characteristics. We have also evaluated the etching rate on the SnOx layer due to the ion treatment on already deposit coatings of equal thicknesses. Subsequently, we studied the effects on the coating's photoenergy properties. For equivalent coatings, we found that those treated with ions were more transparent in the visible region, more reflective, and had a lower emissivity, which are essential requirements for low-e coatings applied in architectural glass.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Comparison of the optical properties of different dielectric materials (SnO2, ZnO, AZO, or SiAlNx) used in silver-based low-emissivity coatings

  • Cueva, Ana
  • Carretero, Enrique
This work analyzed and compared the optical and photoenergetic properties of low-emissivity coatings made from various dielectric materials deposited through magnetron sputtering following a systematic, comparable method. Different multilayer structures of silver-based low-emissivity coatings were studied using SnO2, ZnO, SiAlNx, and aluminum-doped zinc oxide (AZO, which is inherently a semiconductor, but it fulfils an optical dielectric function in this type of structure). The properties of the coatings were determined by spectrophotometric and sheet resistance measurements. Coatings with AZO as the dielectric layers obtain the best photoenergetic performance because silver growth is more efficient on AZO. We also studied the effect of ion bombardment on AZO and SiAlNx in an attempt to obtain a better low-emissivity coating, achieving better results when etching the dielectric layer with an ion gun. Regarding the structures’ visible transmission, the oxides produced better transmission results. Based on the above, we concluded that AZO had the best optical and photoenergetic properties in our deposition system, observing, in the best-case scenario, improvements in emissivity from 0.083 with SnO2 to 0.058 with AZO and to 0.052 using an ion beam on AZO and improvements in visible transmission from 81.9% with SnO2 to 86.8% with AZO.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Evaluation of low-emissivity coatings with single, double, and triple silver layers

  • Herguedas, Natalia
  • Carretero, Enrique
n this work, a detailed study is conducted on the visible transmittance, solar reflectance, and emissivity properties of low-emissivity coatings composed of one, two, and three layers of silver. The results demonstrate significant enhancements in both optical and thermal properties achievable by increasing the number of silver layers, leading to coatings that are more transparent in the visible spectrum, more reflective in the near-infrared, with lower emissivity and lower sheet resistance. The aesthetic adjustment possibilities of the different structures are also examined, with coatings composed of three layers of silver being more flexible.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Radiofrequency transmission through rectangular apertures in perimetrally uncoated low emissivity windows

  • Chueca, Rocío
  • Alcain, Raúl
  • Heras, Carlos
  • Salinas, Iñigo
Perimetrally uncoated windows can be a simple and low cost solution to the problem of radio frequency (RF) transmission in low-e glass when the requirements are not too demanding. However, this kind of non-uniform and relatively large structures are difficult to characterize experimentally. The aim of this work is to develop and experimentally verify a method for the simulation of the RF transmission of perimetrally uncoated windows. We propose to study these windows as a composition of four rectangular apertures in a metallic sheet. Using numerical simulations, we are able to obtain the transmission coefficient of these apertures. Then, a multilayer model based on transmission line theory is used to consider the effect of the different glazings and cameras which can be part of a window. Finally, the results of this study are compared to the measurements of complete windows in the 1000 MHz–6000 MHz frequency range.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Improving communication signal transmission in multiple low-e windows using frequency selective surfaces

  • Chueca, Rocío
  • Muñoz, María
  • Cueva, Ana
  • Alcain, Raúl
  • Heras, Carlos D.
  • Salinas, Íñigo
The use of low-emissivity and solar control glass for thermal insulation in transportation and architecture poses a problem for communications, since the metallic coatings used in this glass attenuate radiofrequency (RF) signals. One solution to this problem is to define Frequency Selective Surfaces (FSS) on the coatings to ensure the transmission of RF signals while maintaining the thermal properties of the glazing. On windows with multiple coated panes, the interaction between the different surfaces grows more complex, as the dimensions of the structure are in the order of the wavelength of the signals involved. This is also an opportunity for the design of windows with specific transmission properties. The aim of this work is to present a design method for windows with multiple low-e coatings and multiple FSS based on the optimization of the RF transmission using an equivalent transmission line model. As a validation of our method, we show designs for windows with attenuation minima at 1, 1.8 and 5.8 GHz. Window samples according to these designs have been fabricated and measured, showing good correlation between simulation and experiment.