Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Processing and characterisation of BaZr0.8Y0.2O3- δ proton conductor densified at 1200 °c

  • Triviño Peláez, Ángel
  • Pérez-Coll, Domingo
  • Aparicio, Mario
  • Fagg, Duncan P.
  • Mosa Ruiz, Jadra
  • Mather, Glenn C.
[EN] Barium zirconate-based perovskites (BZY) are intensely studied proton conductors for high-temperature electrochemical applications; however, their refractory nature means excessive temperatures are required for sintering (∼1700 °C). Although different strategies have been employed to improve densification, a high-temperature step (1300-1700 °C) is generally required to achieve sufficient grain growth and good electrical properties. Here, sol-gel synthesis using alkoxide precursors is employed to obtain BaZr0.8Y0.2O3-δ sinter-reactive powders with Ba excess at 750 °C. High relative densities (∼98%) of ceramic bodies with an average grain size ∼190 nm were obtained on sintering isostatically-pressed pellets at the uniquely low temperature of 1200 °C for 4 hours on addition of 4% mol ZnO as a sintering agent to the Ba-excess sol-gel powders. Impedance spectroscopy indicates that the resistance of the greater grain-boundary volume arising from the low densification temperature is largely offset by a higher specific grain-boundary conductivity than that of the same composition sintered at 1650 °C with larger grain size. Conductivity measurements for prolonged periods in dry and wet (pH2O ∼ 0.022 atm) 90% N2 : 10% H2 and 90% Ar : 10% CO2 atmospheres at 500 °C verified that Ba excess in the starting composition did not contribute to deteriorating chemical stability. Processing of sol-gel BZY nanopowders with Ba excess combined with ZnO sintering aid is thus demonstrated as a successful low-temperature route for obtaining BZY with high density, stability and sufficient grain growth for electrochemical applications. This journal is, We thank MICINN in Spain for financial support through projects RTI2018-095088-B-I00, RTI2018-095373-J-100 and predoctoral grant BES-2016-077023. DPF also thanks the FCT (Fundação para a Ciência e a Tecnologia, grants numbers PTDC/QUI-ELT/3681/2020, POCI-01-0145-FEDER-032241, UIDB/00481/2020 and UIDP/00481/2020) and the Centro Portugal Regional Operational Programme (Centro2020), under the PORTUGAL 2020 Partnership Agreement, through the European Regional Development Fund (ERDF), grant number CENTRO-01-0145-FEDER-022083. We acknowledge support of the publication fee by the CSIC (Spain) Open Access Publication Support Initiative through its Unit of Information Resources for Research (URICI).
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Sol-Gel Synthesis of Nanocrystalline Mesoporous Li4Ti5O12 Thin-Films as Anodes for Li-Ion Microbatteries

  • Mosa Ruiz, Jadra
  • Aparicio, Mario
This article belongs to the Section Energy and Catalysis., The development of anodes based on Li4Ti5O12 (LTO) for lithium ion batteries has become very important in recent years on the basis that it allows a long service life (stability in charge-discharge cycling) and safety improvements. The processing of this material in the form of thin film allows for greater control of its characteristics and an improvement of its disadvantages, namely reduced electrical conductivity and low diffusion of lithium ions. In this work, we try to limit these disadvantages through the synthesis of a mesostructured carbon-doped Li4Ti5O12 thin-film with a pure spinel phase using a combination of a block-copolymer template and in situ synthesis of Li-Ti double alkoxide. Structural and electrochemical characterization has been carried out to determine the best conditions (temperature, time, atmosphere) for the thermal treatment of the material to reach a compromise between crystallinity and porosity distribution (pore size, pore volume, and interconnectivity)., This research was funded by the JST (Japan Science and Ministry of Science and Innovation (RTI2018-095373-J-100) for financial support. Technology Agency), ERA-NET European program and Spanish Science and Innovation Ministry under project PCI2018-092982 EIG-Concert Japan. J. Mosa acknowledges Ministry of Science and Innovation (RTI2018-095373-J-100) for financial support., Peer reviewed