Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Energy balance and environmental impact analysis of marine microalgal biomass production for biodiesel generation in a photobioreactor pilot plant

  • Sevigné Itoiz, Eva|||0000-0002-7356-4048
  • Fuentes Grunewald, Claudio|||0000-0002-3122-9452
  • Martínez Gasol, Carles|||0000-0003-3002-9229
  • Garcés, Esther|||0000-0002-2712-501X
  • Alacid, Elisabet|||0000-0003-0777-1855
  • Rossi Heras, Sergio|||0000-0003-4402-3418
  • Rieradevall, Joan|||0000-0003-3360-6829
A life cycle assessment (LCA) and an energy balance analysis of marine microalgal biomass production were conducted to determine the environmental impacts and the critical points of production for large scale planning. The artificial lighting and temperature conditions of an indoor bubble column photobioreactor (bcPBR) were compared to the natural conditions of an equivalent outdoor system. Marine microalgae, belonging to the dinoflagellate and raphidophyte groups, were cultured and the results were compared with published LCA data obtained from green microalgae (commonly freshwater algae). Among the species tested, Alexandrium minutum was chosen as the target marine microalgae for biomass production under outdoor conditions, although there were no substantial differences between any of the marine microalgae studied. Under indoor culture conditions, the total energy input for A. minutum was 923 MJ kg¯¹ vs. 139 MJ kg¯¹ for outdoor conditions. Therefore, a greater than 85% reduction in energy requirements was achieved using natural environmental conditions, demonstrating the feasibility of outdoor culture as an alternative method of bioenergy production from marine microalgae. The growth stage was identified as the principal source of energy consumption for all microalgae tested, due to the electricity requirements of the equipment, followed by the construction material of the bcPBR. The global warming category (GWP) was 6 times lower in outdoor than in indoor conditions. Although the energy balance was negative under both conditions, this study concludes with suggestions for improvements in the outdoor system that would allow upscaling of this biomass production technology for outdoor conditions in the Mediterranean.
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Environmental consequences of recycling aluminum old scrap in a global market

  • Sevigné Itoiz, Eva|||0000-0002-7356-4048
  • Martínez Gasol, Carles|||0000-0003-3002-9229
  • Rieradevall, Joan|||0000-0003-3360-6829
  • Gabarrell Durany, Xavier|||0000-0003-1730-4337
For decades, aluminium recycling was a regional concern traditionally concentrated in the regions with high aluminium demand and a well-organized aluminium recycling industry. Today, however, aluminium scrap is a global raw material commodity. This change has increased the need to analyze the flows of aluminium scrap, as well as to determine the environmental consequences from aluminium recycling. The objective of this work is to determine the environmental consequences of the old scrap aluminium collection for recycling, considering the market interactions. The study focused on Spain as a representative country for Europe. We integrate material flow analysis (MFA) with consequential life cycle assessment (CLCA) in order to determine the most likely destination for the old scrap and the most likely corresponding process affected. Based on this analysis, it is possible to project some scenarios and to quantify the environmental impacts (generated and avoided) associated with aluminium recycling within a global market. From the MFA results, we projected that the demand for aluminium products will be met mainly with an increase in primary aluminium imports, and the excess of old scrap not used in Spain will be exported in future years, mainly to Asia. Depending on the marginal source of primary aluminium considered, the greenhouse gases (GHG) emission estimates varied between -17,088 kg of CO2 eq. t-1 of old scrap collected to -10,305 of CO2 eq. t-1 of old scrap collected for the global or local scenario, respectively. More GHG emissions are avoided with an increase in export flows, but the export of old scrap should be considered as the loss of a key resource, and in the long term, it will also affect the semifinished products industry. Mapping the flows of raw materials and waste, as well as quantifying the environmental impacts derived from recycling, has become an essential prerequisite to consistent development from a linear towards a circular economy.
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Determination of the energy and environmental burdens associated to the biological treatment of source-separated municipal solid wastes

  • Colón Jordà, Joan|||0000-0003-1677-7239
  • Cadena, Erasmo|||0000-0003-3628-3041
  • Pognani, Michele
  • Barrena, Raquel|||0000-0002-6077-7765
  • Sánchez, Antoni|||0000-0003-4254-8528
  • Font, Xavier|||0000-0003-4981-7436
  • Artola, Adriana|||0000-0002-0524-2119
Environmental burdens of four different full-scale facilities treating source-separated organic fraction of Municipal Solid Wastes (OFMSW) have been experimentally evaluated. The studied facilities include different composting technologies and also anaerobic digestion plus composting. Home composting, as an alternative to OFMSW management, was also included in the study. Energy (electricity and diesel), water consumption and emissions of volatile organic compounds (VOC), ammonia, methane and nitrous oxide have been measured for each process. Energy consumption ranged between 235 and 870 MJ Mg OFMSW⁻¹ while the emissions of the different contaminants considered per Mg OFMSW were in the range of 0.36-8.9 kg VOC, 0.23-8.63 kg NH₃, 0.34-4.37 kg CH₄ and 0.035-0.251 kg N₂O, respectively. Environmental burdens of each facility are also analyzed from the point of view of process efficiency (i.e. organic matter stabilization degree achieved, calculated as the reduction of the Dynamic Respiration Index (DRI) of the waste treated). This study is performed through two new indices: Respiration Index Efficiency (RIE), which includes the reduction in the DRI achieved by the treatment process and Quality and Respiration Index Efficiency (QRIE), which also includes the quality of the end product. Finally, a Life Cycle Assessment is performed using the Respiration Index Efficiency (RIE) as the novel functional unit instead of the classical LCA approach based on the total mass treated.
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Home and vermicomposting as sustainable options for biowaste management

  • Lleó Leida, Thais
  • Albacete, Eloisa
  • Barrena, Raquel|||0000-0002-6077-7765
  • Font, Xavier|||0000-0003-4981-7436
  • Artola, Adriana|||0000-0002-0524-2119
  • Sánchez, Antoni|||0000-0003-4254-8528
Home composting (also known as backyard composting) presents some potential benefits for the industrial treatment of the organic fraction of municipal solid waste or biowaste. Home composting avoids the collection of biowaste, reduces the impurities present in the waste being treated and, consequently, in the resulting compost, and theoretically decreases the material and energy needs of the process. However, self-composting requires a composting bin and pruning waste as bulking material as well as space in a garden or on a roof that is not always available. An alternative for the self-management of biowaste is vermicomposting, which requires less space and no bulking material. Both the home composting and vermicomposting methods were studied over an eight-month period to determine the quality of the compost produced, the capacity of the methodology and the resulting gaseous emissions. The treatment capacity of the composters used in this work was determined on a weekly basis. The vermicomposter had a treatment capacity of 50 g biowaste per L, whereas the home composter had a treatment capacity of 16 g biowaste per L. The home composter required the addition of 6.3 g of bulking agent per L of composter. The quality of the final product, compost, was similar in both cases, with each batch of compost having low metal content and a high degree of stability, with Dynamic Respiration Indices of 0.43 and 0.89 mg O2 g⁻¹ Organic Matter h⁻¹ for compost and vermicompost, respectively. Gaseous emissions from home composters show the presence of 1.3 kg NH₃ Mg⁻¹ biowaste and 1.35 kg CH₄ Mg⁻¹ biowaste, values that are within the range reported in the literature for home and industrial composting, although N2O emissions, 1.16 kg Mg⁻¹ biowaste, were higher. Gaseous emissions from the vermicomposters were lower than from the home composters: 3.33 × 10⁻³, 2.19 × 10⁻³ and 3.66 × 10⁻³ kg of pollutant Mg⁻¹ biowaste for NH₃, CH₄ and volatile organic compounds, respectively. No odours were detected for either system. Home and vermicomposting can be considered suitable alternatives to divert a portion of the biowaste from the traditional waste-management system.