Pasar al contenido principal

ESTRATEGIAS DE DISEÑO DE FRONT-ENDS PARA COMUNICACIONES OPTICAS

TEC2008-05455

•
Nombre agencia financiadora Ministerio de Ciencia e Innovación
Acrónimo agencia financiadora MICINN
Programa Programa Nacional de Proyectos de Investigación Fundamental
Subprograma Subprograma de Proyectos de Investigación Fundamental no Orientada
Convocatoria Proyectos I+D
Año convocatoria 2008
Plan Estatal 2008-2011 Plan Nacional de Investigación Científica, Desarrollo e Innovación Tecnológica
Unidad de gestión Subdirección General de Proyectos de Investigación
Centro beneficiario UNIVERSIDAD DE ZARAGOZA
Identificador persistente http://dx.doi.org/10.13039/501100004837

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

1-V continuous-time equalizers for multi-gigabit short-haul optical fiber communications

  • Gimeno, C.
  • Aldea, C.
  • Aznar, F.
  • Sánchez-Azqueta, C.
  • Celma, S.
Two new CMOS analog continuous‐time equalizers for high‐speed short‐haul optical fiber communications are presented in this paper. The proposed structures compensate the limited bandwidth‐length product of 1‐mm step‐index polymer optical fiber channels (45 MHz, 100 m) and have been designed in a standard 0.18‐µm CMOS process. The equalizers are aimed for multi‐gigabit short‐range applications, targeting up to 2 Gb/s through a 50‐m step‐index polymer optical fiber. The prototypes operate with a single supply voltage of only 1 V and overcome the severe limitations suffered by the widely used degenerated differential pair caused by the low supply voltage.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Gigabit Receiver over 1-mm SI-POF for Home Area Networks

  • Aznar, F.
  • Sánchez-Azqueta, C.
  • Celma, S.
  • Calvo, B.
A novel receiver front-end is proposed for short-range optical communications over low-cost polymer optical fiber and, in particular, for home area networks. This paper focuses on the experimental verification of the IC prototype POFchip-II, implemented in a standard 0.18- μ m CMOS technology plus a commercial Si-PIN photodetector and a 1 mm step-index plastic optical fiber (POF) transmission channel. A 1.25 Gb/s data transmission rate is attained for POF lengths ranging from 10 to 50 m thanks to a continuous-time adaptive equalizer included in the receiver chain that compensates the limited and length-dependent speed of POF. The measured sensitivity of the receiver leads to an eye-safety approach up to almost 30 m reach.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

A 0.18 µm CMOS linear-in-dB AGC post-amplifier for optical communications

  • Aznar, F.
  • Celma, S.
  • Calvo, B.
This paper presents a fully integrated 10GBase-LX4 Ethernet receiver front-end automatic gain control amplifier realized in a 0.18 μm CMOS process. Based on a very compact and reliable inductorless design, the proposed differential post-amplifier, comprises three main digitally programmable gain stages, a DC offset cancellation network and an automatic gain feedback control loop. Experimental results demonstrate a −3 dB cut-off frequency above 2.3 GHz over a −3 to 33 dB linear-in-dB controlled gain range with a sensitivity of 2.0 mVp–p with a BER of 10−12 at 2.5 Gb/s. For the aforementioned standard, 3.125 Gb/s, an input dynamic range above 50 dB is achieved, from 2.5 mVp–p to 800 mVp–p, indicating a BER of 10−12. The chip core area is 0.3 × 0.3 mm2 and it consumes 58 mW with a single supply voltage of 1.8 V
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

A 0.18 mm CMOS transimpedance amplifier with 26 dB dynamic range at 2.5 Gb/s

  • Aznar, Francisco
  • Gaberl, Wolfgang
  • Zimmermann, Horst
A new transimpedance amplifier (TIA) for 2.5 Gb/s optical communications fabricated in a standard 0.18 μm CMOS process is presented. The proposed TIA is based on a conventional structure with an inverting voltage amplifier and a feedback resistor, but incorporates a new technique to enhance the input dynamic range and to prevent the TIA from saturation at high input currents. According to electrical characterization the receiver shows an optical sensitivity of −26 dB m for a BER=10−12, assuming a responsivity of 1 A/W, and an optical power dynamic range above 26 dB. The power consumption of the core is only 10.6 mW at a single supply voltage of 1.8 V.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Cost-effective 1.25-Gb/s CMOS receiver for 50-m large-core SI-POF links

  • Gimeno, C.
  • Aldea, C.
  • Celma, S.
  • Aznar, F.
This letter proposes a new analog front end for short-reach high-speed optical communications that compensates the limited bandwidth of 1-mm step-index polymer optical fiber (SI-POF) transmission systems. In particular, the front end has been fabricated using a cost-effective digital 0.18- complementary metal-oxide-semiconductor (CMOS) technology and fed with only 1 V. The prototype contains a transimpedance amplifier, a continuous-time equalizer, and an output driver. Experimentally, we have obtained 1.25-Gb/s transmission for a simple nonreturn-to-zero modulation in an optical link composed of 50 m of SI-POF and a large area Si PIN photodetector.