Pasar al contenido principal

APROXIMACION MULTINIVEL AL DISEÑO ORIENTADO A LA FIABILIDAD DE CIRCUITOS INTEGRADOS ANALOGICOS Y DIGITALES

TEC2013-45638-C3-3-R

•
Nombre agencia financiadora Ministerio de Economía y Competitividad
Acrónimo agencia financiadora MINECO
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos I+D+i Retos de Investigación
Año convocatoria 2013
Plan Estatal 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Unidad de gestión Secretaría de Estado de Educación, Formación Profesional y Universidades
Centro beneficiario UNIVERSIDAD DE SEVILLA
Identificador persistente http://dx.doi.org/10.13039/501100003329

Resultados relacionados

Resultados totales (Incluyendo duplicados): 1
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Calibration of offset via bulk for Low-power HfO2 based 1T1R memristive crossbar Read-Out System

  • Mohan, Charanraj
  • Camuñas-Mesa, Luis A.
  • Vianello, Elisa
  • Periniolla, L.
  • Reita, Carlo
  • Rosa, José M. de la
  • Serrano-Gotarredona, Teresa
  • Linares-Barranco, Bernabé
Neuromorphic RRAM circuits typically need currents of several mA when many binary memristive devices are activated at the same time. This is due to the low resistance state of these devices, which increases the power consumption and limits the scalability. To overcome this limitation, it is vital to investigate how to minimize the amplitude of the read-out inference pulses sent through the crossbar lines. However, the amplitude of such inference voltage pulses will become limited by the offset voltage of read-out circuits. This paper presents a three-stage calibration circuit to compensate for offset voltage in the wordlines of a memristor-array read-out system. The proposed calibration scheme is based on adjusting the bulk voltage of one of the input differential pair MOSFETs by means of a switchable cascade of resistor ladders. This renders the possibility to obtain calibration voltage steps less than 0.1 mV by cascading a few number of stages, whose results are only limited by mismatch, temperature, electrical noise and other fabrication defects. The system is built using HfO2-based binary memristive synaptic devices on top of a 130-nm CMOS technology. Layout-extracted simulations considering technology corners, PVT variations and electrical noise are shown to validate the presented calibration scheme., This work was supported in part by the EU H2020 grants 644096 “ECOMODE” and 687299 “NeuRAM3”, by Spanish grants from the Ministry of Economy and Competitiveness – TEC2013-45638-C3-3-R (MARAGADA), TEC2015-63884-C2-1-P (COGNET) and TEC2016-75151-C3-3-R (TOGETHER) (with support from the European Regional Development Fund) and by the International Consortium of Nanotechnology of the Lloyd's Register Foundation under Grant Reference G0086. CSIC acknowledges CMP for design assembly and guidance.