Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Characterization of the interface between highly conductive Ga:ZnO films and the silicon substrate

  • Gabàs, Mercedes
  • Ochoa-Martínez, E.
  • Navarrete-Astorga, E.
  • Landa Cánovas, Ángel
  • Herrero, Pilar
  • Agulló Rueda, F.
  • Palanco, S.
  • Martínez-Serrano, J. J.
  • Ramos-Barrado, J. R.
Gallium-doped zinc oxide films are an interesting alternative for transparent conductive materials. To improve their performance, the interface between the grown layer and the substrate must be fully understood. Accordingly, ZnO and Ga:ZnO films have been deposited onto p-type doped Si (111) substrates by magnetron sputtering for 1, 2, 3 and 20 min and their interfaces characterized by transmission electron microscopy, photoelectron spectroscopy, spectroscopic ellipsometry and impedance spectroscopy. The combination of transmission electron microscopy techniques suggested a more complex interface chemistry in the Ga:ZnO/Si case, a point confirmed by x-ray photoelectron spectroscopy measurements on very thin films. While the ZnO/Si interface consists mostly of silicon oxides, zinc silicates and some Zn0, the Ga:ZnO/Si interface, besides these constituents, has a noticeable amount of Ga:ZnO and small quantities of Ga0. The band alignment deduced from the photoelectron spectroscopy measurements, together with the layers and Si band gap values, evidences a higher work function for the doped film and a smaller conduction band barrier for the Ga:ZnO/Si interface. Concerning the optical and electrical characteristics, spectroscopic ellipsometry revealed no significant differences between the two interfaces, while impedance spectroscopy measurements demonstrated that the Ga:ZnO/Si interface is less resistive than the ZnO/Si one., Authors gratefully acknowledge financial support from the Spanish Ministerio de Economía & Competitividad (MINECO) and E.U. FEDER funds through the projects FUNCOAT-CSD2008-00023-CONSOLIDER INGENIO, TEC2014-53906-R, TEC2014-54260-C3-3-P, RYC-2010-06711 and MAT2014-57547-R, and from the Junta de Andalucía (FQM-192).
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Ga-doped IZO films obtained by magnetron sputtering as transparent conductors for visible and solar applications

  • Solís-Cortés, Daniel
  • Navarrete-Astorga, E.
  • Costa Krämer, José Luis
  • Salguero, Joaquín
  • Schrebler, R.
  • Leinen, Dietmar
  • Dalchiele, Enrique Ariel
  • Ramos-Barrado, J. R.
  • Martín, F.
C-axis textured thin films of gallium-doped indium zinc oxide (GIZO) with a 2% ratio of Ga/Zn, were obtained via RF-magnetron sputtering with high transparency and electrical conductivity. A Box-Behnken response surface design was used to evaluate the effects of the deposition parameters (InO target power, deposition time, and substrate temperature) on the chemical composition, optical, electrical, and structural properties of the GIZO films. The optical constants and the electrical properties were obtained using optical models. The GIZO stoichiometry, and therefore the In/Zn atomic ratio, affected the crystallinity, crystalline parameters, band gap, and charge carrier mobility of the GIZO films. The charge carrier density was related to the change in the crystalline parameters of the hexagonal structure and the In/Zn atomic ratio. The best electrical conductivity values (1.75 × 10 Ω cm) were obtained for GIZO films with In/Zn ratio ≥ 1. Several figures of merit (FOM) defined for the visible and solar regions were comparatively used to select the optimal In/Zn atomic ratio that provided the best balance between the conductivity and the transparency. The optimal In/Zn ratio was in a range of 0.85–0.90 for the GIZO films., This work was supported by projects RNM1399 and TEC 2014-53906-R, Junta de Andalucía and Ministry of Economy and Competitiveness of Spain respectively. The authors are grateful to CSIC (Comisión Sectorial de Investigación Científica) of the Universidad de la República, in Montevideo, Uruguay, PEDECIBA- Física, ANII (Agencia Nacional de Investigación e Innovación), Uruguay; and to SCAI –Unidad de Nanotecnología of the University of Malaga. DII of PUCV (Pontifical Catholic University of Valparaiso) of Chile and FODECYT of Chile Grant no. 1160485, Chile, are also acknowledged.
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Nanostructural changes upon substitutional Al doping in ZnO sputtered films

  • Landa Cánovas, Ángel R.
  • Santiso, José|||0000-0003-4274-2101
  • Agulló Rueda, Fernando|||0000-0001-9211-1987
  • Herrero, Pilar
  • Navarrete Astorga, Elena
  • Ochoa Martínez, E.
  • Ramos Barrado, José R.
  • Gabás, M.
Al:ZnO layers, with low and high Al content, 0.2% and 2.1% cat. respectively, have been prepared using the RF magnetron sputtering technique. Noticeable differences in the optical and electrical properties have been detected in these films. With doping, the resistivity decreases and the band-gap increases. The alterations in the films crystalline structure are explained in terms of the nanostructural changes induced by Al substitutional doping, such as a higher concentration of edge dislocation defects and a higher rotation of crystalline nanodomains in the plane of the films (normal to the preferential orientation c-axis) for the high content Al:ZnO layer. A complete description of such effects has been accomplished using several characterization techniques, such as X-ray diffraction, Raman spectroscopy and transmission electron microscopy. The combination of these techniques provides an exhaustive understanding of the films nanostructure.