Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Subcritical water extraction for recovering cellulose fibres from Posidonia oceanica waste

  • Camarena-Bononad, Paula|||0009-0002-8543-4045
  • Vieira-De Freitas, Pedro Augusto
  • Chiralt, Amparo|||0000-0003-1134-8144
  • Vargas, Maria|||0000-0001-6024-0952
[EN] In this study, cellulose extraction from Posidonia oceanica (PO) waste was studied in order to reduce chemicals in the process, in line with the green chemistry principles. Thus, subcritical water extraction (SWE) was applied to promote the separation of non-cellulosic compounds, such as hemicellulose and lignin, followed by bleaching treatments using hydrogen peroxide, alternatively to the usual sodium chlorite. Two SWE temperatures (150 and 170 °C) were tested, while hydrogen peroxide was used at 4 and 8 % (v/v) at pH 12 in four one-hour bleaching cycles. This treatment was also carried out with sodium chlorite for comparison purposes. SWE efficiently reduced hemicellulose and lignin content in the solid extraction fraction, mainly at 170 °C, which yielded 63 wt.% of solid fraction, with 51 % of cellulose content. This highest temperature also promoted the efficiency of the subsequent bleaching step. Using H2O2 as the bleaching agent, alternatively to chlorine agents, was effective at purifying cellulose but partially altered the cellulose structure through oxidative mechanisms. A combination of SWE at 170 °C and bleaching with H2O2 at 4 or 8 % (v/v) yielded 24 wt.% bleached material from PO waste, with a high cellulose richness (near 90 %)., Agencia Estatal de Investigacion of Spain through the Project TED2021-132295B-I00 and by Generalitat Valenciana (Project CIPROM/2021/071) .
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Use of Cellulose Fibres from Posidonia oceanica to Obtain Chitosan Biocomposites and Poly(lactic Acid) Laminates

  • Camarena-Bononad, Paula|||0009-0002-8543-4045
  • Chiralt, Amparo|||0000-0003-1134-8144
  • Vargas, Maria|||0000-0001-6024-0952
  • Freitas, Pedro A. V.
[EN] New sustainable materials have been developed to replace conventional plastics obtained from non-renewable sources. In this study, cellulose fibres from Posidonia oceanica (PO) were obtained by applying subcritical water extraction and bleaching with hydrogen peroxide or sodium chlorite. The PO fibres were used to obtain cellulose films, chitosan¿cellulose composites, and PLA¿cellulose laminates. These films were characterised as to their optical properties, mechanical performance, oxygen and water vapour permeability, thermal stability, and microstructure. The cellulose films exhibited low mechanical resistance, with different colouration depending on the degree of delignification. The composites had lower mechanical strength than pure chitosan films. The PO cellulose fibres had a similar, but attenuated, effect when laminated with PLA layers. The fibres improved the oxygen barrier capacity of chitosan films, although this effect only occurred in PLA laminates for cellulose purified with sodium chlorite. In no case did cellulose improve the water vapour barrier of the films compared to pure polymers. The thermal stability was not notably altered by the blending effect, thus reflecting the absence of significant interactions between the fibres and polymer. However, there is a need to improve the functionality of cellulose fibres from PO waste for their incorporation as fillers or laminates in biodegradable food packaging materials., This research was funded by Agencia Estatal de Investigacion of Spain through the Project TED2021-132295B-I00 and by Generalitat Valenciana (Project CIPROM/2021/071).
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Valorización de residuos agroalimentarios en la producción de envases biodegradables activos para la conservación de alimentos

  • Cháfer Nácher, Maite|||0009-0009-5727-8306
  • Vargas, Maria|||0000-0001-6024-0952
  • Atarés Huerta, Lorena María|||0000-0002-7172-3666
  • Martín-Esparza, M.E.|||0000-0002-0066-6748
  • González Martínez, María Consuelo|||0000-0001-9993-8303
  • Chiralt, Amparo|||0000-0003-1134-8144
[ES] En el proceso de transición hacia un aprovechamiento y valorización integral en la cadena agroalimentaria, la economía circular del sector y la mejora global de su sostenibilidad, se presentan los proyectos de investigación desarrollados por el grupo de Biopolímeros del Instituto Univeristario de Ingeniería de Alimentos-FoodUPV de la Univeristat Politènica de València se centran en el aprovechamiento integral de subproductos agroalimentarios para la obtención de materiales biodegradables avanzados para el envasado de alimentos.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Tesis de maestría (MasterThesis)

Propiedades de films de micro-celulosa obtenida de Posidonia oceanica y sus mezclas con quitosano, Properties of films based on Posidonia oceánica micro-cellulose and their blends with chitosan, Propietats de films de micro-cel·lulosa obtinguda de Posidonia oceanica i les seves mescles amb quitosà

  • Granado Santana, Laura
[ES] La Posidonia oceanica (PO) es una planta acuática abundante en el mediterráneo que produce una gran acumulación de hojas desprendidas de la planta en la costa. Los residuos de PO recogidos en vertederos podrían utilizarse como fuente de celulosa debido al alto contenido en este componente (30-40 %). En estudios previos se ha obtenido celulosa a partir de residuos de PO combinando la extracción en agua subcrítica (SWE) con el blanqueado con peróxido de hidrógeno o clorito sódico. En este trabajo se han obtenido fibras de PO mediante el mismo procedimiento, que se han utilizado para la obtención de films de celulosa, films mixtos de quitosano celulosa (1:1) y laminados de PLA-celulosa. Los films se han caracterizado en su microestructura, propiedades ópticas y de barrera al vapor de agua y al oxígeno y en sus propiedades mecánicas y estabilidad térmica. Los films de celulosa presentaron baja resistencia mecánica y una estructura porosa de fibras adheridas, con diferente coloración dependiendo del grado de deslignificación obtenido en el blanqueado. Las films mixtos y laminados presentaron menor resistencia mecánica que los de los polímeros puros, pero las fibras mejoraron la capacidad de barrera al oxígeno del quitosano, aunque este efecto solo se dio en los laminados de PLA para la celulosa purificada con clorito sódico. En general, el tratamiento de blanqueado aplicado afectó en todos los casos a las propiedades de los films., [EN] Posidonia oceanica (PO) is an abundant aquatic plant in the Mediterranean that produces a large accumulation of leaves detached from the plant on the coast. PO waste collected from landfills could be used as a source of cellulose due to the high content of this component (30-40%). In previous studies, cellulose has been extracted from PO waste by combining subcritical water extraction (SWE) with bleaching with hydrogen peroxide or sodium chlorite. In this work, PO fibers have been obtained by the same procedure, which have been used to obtain cellulose films, mixed chitosan-cellulose films (1:1) and PLA-cellulose laminates. The films have been characterized in terms of their microstructure, optical properties and water vapor and oxygen barrier, and in their mechanical properties and thermal stability. The cellulose films presented low mechanical resistance and a porous structure of adhered fibres, with different coloration depending on the degree of delignification obtained in the bleaching. The mixed and laminated films had lower mechanical strength than those of pure polymers, but the fibres improved the oxygen barrier capacity of chitosan, although this effect only occurred in PLA laminates for cellulose purified with sodium chlorite. In general, the bleaching treatment applied affected the properties of the films in all cases.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Influence of the Purification Degree of Cellulose from Posidonia oceanica on the Properties of Cellulose-PLA Composites

  • Camarena-Bononad, Paula|||0009-0002-8543-4045
  • Vieira-De Freitas, Pedro Augusto
  • González Martínez, María Consuelo|||0000-0001-9993-8303
  • Chiralt, Amparo|||0000-0003-1134-8144
  • Vargas, Maria|||0000-0001-6024-0952
[EN] PLA biocomposites, incorporating 5% wt. of lignocellulosic fibres (LF) from Posidonia oceanica waste with different degrees of cellulose purification, were obtained by melt blending and compression moulding. The LF were obtained after removing part of the non-cellulosic components by subcritical water extraction at 150 and 170 °C and after bleaching the extracted residues with hydrogen peroxide or sodium chlorite. The non-bleached LF provided the composites with a brown colour and opacity, while the bleached LF impacted the optical properties of composites to a lower extent, depending on their whiteness. The LF composition had a noticeable effect on the composites¿ mechanical and barrier properties. All LF reduced the water vapour barrier capacity while promoting the oxygen barrier of the films. Bleached LF enhanced the film stiffness and reduced extensibility and resistance to break, whereas non-bleached LF had lower impacts on the tensile parameters. Considering the mechanical and barrier performance of the composites, the fibres obtained at 170 °C and bleached with sodium chlorite exhibited the best behaviour. Nevertheless, if transparency and colour are not limiting for the use of the films, untreated LF allowed for good preservation of the water vapour permeability of PLA films and enhanced the oxygen barrier capacity, with a similar mechanical response as the other non-bleached fractions., This research was funded by Agencia Estatal de Investigación of Spain through the Project TED2021-132295B-I00 and by Generalitat Valenciana (Project CIPROM/2021/071).
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Beer Bagasse as Filler for Starch-Based Biocomposite Films for Food Packaging Applications

  • Gómez-Contreras, Paula Andrea|||0000-0002-2185-7607
  • Cháfer Nácher, Maite|||0009-0009-5727-8306
  • Chiralt, Amparo|||0000-0003-1134-8144
  • González Martínez, María Consuelo|||0000-0001-9993-8303
[EN] Development of biodegradable packaging materials and valorization of agri-food waste are necessary to produce more sustainable materials while reducing the environmental impact. Starch-based biocomposite films reinforced with beer bagasse fractions with different purification degrees were developed and characterized in structural, mechanical, thermal and optical properties. To this aim, 5% and 10% (w/w) of either beer bagasse (BB) or its lignocellulosic-rich fibers (LF), obtained by subcritical water extraction at temperatures between 110 and 170 degrees C, were incorporated into starch matrices. Elastic modulus and tensile strength values increased by up to eight-fold and 2.5-fold, respectively, compared to the control film. The incorporation of BB or LF significantly enhanced the mechanical resistance of the films. In general, the increment in the filler:polymer ratio significantly increased the EM values (p < 0.05), while decreasing the stretchability of the films around 80-85%, regardless of the type of filler. This effect suggests a good interfacial adhesion between the fillers and the polymeric matrix, as observed by FESEM. The biocomposite films exhibited a dark reddish appearance, reduced transparency, light blocking barrier capacity and remarkable antioxidant activity due to the presence of phenolic compounds in the fibers. The water vapor and oxygen barrier properties were better preserved when using the more purified LF obtained at 170 degrees C. Overall, starch films reinforced with beer bagasse fractions showed strong potential for the development of biodegradable food packaging materials., This research was supported by MCIN/AEI/10.13039/501100011033 and by the European Union NextGenerationEU/PRTR (project TED2021-132295B-I00). The authors also thank the Generalitat Valenciana (GVA) for the grant received through the GRISOLIA program (CIGRIS/2021/033).