Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publication Artículo científico (JournalArticle)

Multiparameter sensor based on a multiinterferometric serial configuration for temperature and strain measurements

  • Pérez Herrera, Rosa Ana
  • Bravo Acha, Mikel
  • Leandro González, Daniel
  • Novais, Susana
  • Pradas Martínez, Javier
  • López-Amo Sáinz, Manuel
In this work, a multi-parameter point sensor based on the combination of Fabry-Perot (FP) and the anti-resonant (AR) reflecting guidance in cascade configuration is proposed and experimentally demonstrated. This structure, based on FP interference and AR reflecting guidance, was fabricated with two different air micro-cavities. The attained experimental results showed different strain and temperature sensitivities for the antiresonance contribution. However, when analyzing the FP interference, only strain sensitivity was observed, demonstrating that this air micro-cavity was also insensitive to temperature variations., This work was supported by the Spanish AEI projects TEC2016-76021-C2 and PID2019-107270RB-C22, FEDER Funds, the European Union’s Horizon 2020 research and innovation programme under the Marie Skłodowska-Curie grant agreement No 838143, Projects for young researches UPNA 2019, “Caja Navarra” and “la Caixa” foundations under agreement LCF/PR/PR13/51080004 and the grant BGP18/00180 of the “Beatriz Galindo” programme from the Spanish Ministry of Science, Innovation and Universities.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publication Artículo científico (JournalArticle)

Microdrilled tapers to enhance optical fiber lasers for sensing

  • Pérez Herrera, Rosa Ana
  • Bravo Acha, Mikel
  • Roldán Varona, Pablo
  • Leandro González, Daniel
  • Rodríguez Cobo, Luis
  • López Higuera, José Miguel
  • López-Amo Sáinz, Manuel
In this work, an experimental analysis of the performance of different types of quasi-randomly distributed reflectors inscribed into a single-mode fiber as a sensing mirror is presented. These artificially-controlled backscattering fiber reflectors are used in short linear cavity fiber lasers. In particular, laser emission and sensor application features are analyzed when employing optical tapered fibers, micro-drilled optical fibers and 50 μm-waist or 100 μm-waist micro-drilled tapered fibers (MDTF). Single-wavelength laser with an output power level of about 8.2 dBm and an optical signal-to-noise ratio of 45 dB were measured when employing a 50 μm-waist micro-drilled tapered optical fiber. The achieved temperature sensitivities were similar to those of FBGs; however, the strain sensitivity improved more than one order of magnitude in comparison with FBG sensors, attaining slope sensitivities as good as 18.1 pm/με when using a 50 μm-waist MDTF as distributed reflector., This work is part of the project PID2019-107270RB, funded by MCIN/ AEI/10.13039/501100011033 and FEDER 'A way to make Europe', the Ministerio de Educación, Cultura y Deporte of Spain (PhD grant FPU2018/02797), the European Union’s Horizon 2020 research and innovation programme under the Marie Skłodowska-Curie grant agreement No 838143, the Beatriz Galindo BEAGAL18/00116 fellowship, the 'Fundación Caja Navarra' and 'Fundación la Caixa' with the proyect LCF/PR/PR13/51080004 and Projects for young researchers UPNA 2019.