DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication
Artículo científico (JournalArticle)
Anisotropic Resistivity Surfaces Produced in ITO Films by Laser‐Induced Nanoscale Self‐organization
11 pags., 8 figs., 2 tabs., Highly anisotropic resistivity surfaces are produced in indium tin oxide (ITO) films by nanoscale self‐organization upon irradiation with a fs‐laser beam operating at 1030 nm. Anisotropy is caused by the formation of laser‐induced periodic surface structures (LIPSS) extended over cm‐sized regions. Two types of optimized structures are observed. At high fluence, nearly complete ablation at the valleys of the LIPSS and strong ablation at their ridges lead to an insulating structure in the direction transverse to the LIPSS and conductive in the longitudinal one. A strong diminution of In content in the remaining material is then observed, leading to a longitudinal resistivity ρL ≈ 1.0 Ω·cm. At a lower fluence, the material at the LIPSS ridges remains essentially unmodified while partial ablation is observed at the valleys. The structures show a longitudinal conductivity two times higher than the transverse one, and a resistivity similar to that of the pristine ITO film (ρ ≈ 5 × 10−4 Ω·cm). A thorough characterization of these transparent structures is presented and discussed. The compositional changes induced as laser pulses accumulate, condition the LIPSS evolution and thus the result of the structuring process. Strategies to further improve the achieved anisotropic resistivity results are also provided., This research was funded by the Spanish Ministry of Science, Innovation
and Universities, the Spanish Research Agency (AEI, Ministry of Research
and Innovation), and the European Regional Development Fund (ERDF)
(grant numbers TEC2017-82464-R, PID2019-109603RA-I00, and PID2019-
110430GB-C21), the “Consejería de Economía y Conocimiento de la Junta
de Andalucía” (PAIDI-2020 projects P18-RT-3480 and -6079). The authors
also acknowledge the Consejo Superior de Investigaciones Científicas for
the “Intramural Project” (201850E057). C.L.-S. acknowledges the funding
of the University of Seville through the “VI Plan Propio de Investigación
y Transferencia de la US” (VI PPIT-US). M.M.-M. acknowledges the
postdoctoral Juan de la Cierva Incorporación grant (IJCI-2017-33317))
of the same ministry. C.F. thanks the support from the European
Commission through the Marie Curie Global Fellowship grant number
844977. V.L.-F. thanks the support from European Commission/Junta
de Andalucía Talent-Hub Program. The authors thank the Research,
Technology, and Innovation Center of the University of Seville (CITIUS)
and Microscopy Service of the University Pablo de Olavide (Seville) for
access to several material characterization facilities, Peer reviewed
Project:
AEI / Plan Estatal de Investigación Científica y Técnica y de Innovación 2017-2020 TEC2017-82464-R
,
AEI / Plan Estatal de Investigación Científica y Técnica y de Innovación 2017-2020 PID2019-109603RA-I00
,
AEI / Plan Estatal de Investigación Científica y Técnica y de Innovación 2017-2020 PID2019- 110430GB-C21
,
EC / H2020 844977
View at: http://hdl.handle.net/10261/223554