Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Analysis of the Core Exit Temperature and the Peak Cladding Temperature during a SBLOCA. Application to a scaled-up model

  • Querol, A.
  • Gallardo Bermell, Sergio|||0000-0002-3703-9983
  • Verdú Martín, Gumersindo Jesús|||0000-0001-5098-080X
[EN] During Loss-Of-Coolant Accidents (LOCA), operators may start Accident Management (AM) actions when the Core Exit Temperature (CET) measured by thermocouples exceeds a certain value. However, a significant time delay and temperature discrepancy in the superheat detection was observed in several facilities. This work is focused on clarifying CET thermocouple responses versus Peak Cladding Temperature (PCT) and to study if the same physical phenomena are reproduced in two TRACE5 models with different geometry (a Large Scale Test Facility (LSTF) and a scaled-up LSTF) during a pressure vessel upper head Small Break LOCA (SBLOCA). Results obtained show that the delay between the core uncover and the CET excursion is reproduced in both cases., The authors are grateful to the Management Board of the OECD-NEA ROSA Project; thus, this work contains findings produced within this project. This work is partially supported by the Grant-in-Aid for Scientific Research of the Spanish Ministerio de Educacion (Grant number: AP2009-2600), the Spanish Ministerio de Ciencia e Innovacion under Projects ENE2011-22823 and ENE2012-34585, and the Generalitat Valenciana under Projects PROMETEOII/2014/008 and ACOMP/2013/237.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Simulation of a SBLOCA in a hot leg. Scaling considerations andapplication to a nuclear power plant

  • Querol Vives, Andrea
  • Gallardo Bermell, Sergio|||0000-0002-3703-9983
  • Verdú Martín, Gumersindo Jesús|||0000-0001-5098-080X
The main goal of this work is to study the physical phenomena observed during a Small Break Loss-Of-Coolant Accident transient performed in a small-scale Integral Test Facility and to determine the capabilityof the thermal hydraulic code TRACE5 to reproduce these phenomena in a scale-up model. The accidentscenario analyzed is based on Test 1.2 in the frame of the OECD/NEA ROSA Project, which simulatesa 1% hot leg Small Break Loss-Of-Coolant Accident in the Large Scale Test Facility of the Japan AtomicEnergy Agency. During this test, natural circulation in primary loops occurs, cooling the core during someminutes. This is an important phenomenon, which needs to be checked by means of different TRACE5models. With this aim, Test 1 2 has been simulated using a TRACE5 model reproducing the geometricaland thermal hydraulic features of Large Scale Test Facility. In order to determine if this phenomenon canbe reliably extrapolated to a scale-up plant, a new TRACE5 model has been developed. The geometricalfeatures of this scale-up model are determined using a fixed scaling ratio respect to the original LSTFfeatures. On the other hand, 4 and 3-loop standard Westinghouse PWR models are used in order tosimulate the same transient and compare the behaviour of the main thermal hydraulic variables withthose obtained in the Large Scale Test Facility model and in the Large Scale Test Facility scale-up model.Results show that both Large Scale Test Facility and the scale-up models present the same behaviourduring the whole transient. Important discrepancies are found in the results corresponding to 4 and3-loop PWR TRACE5 models. In both models, natural circulation is not properly reproduced. Trying toimprove the simulation results, the nodalizations of U-tubes and pressure vessel were tested. Resultsstate that the nodalization of U-tubes clearly affects the natural circulation simulation. However, thevessel nodalization effect is not as important., This work contains findings produced within the OECD-NEA ROSA Project. This work is partially supported by the Grant-in-Aid for Scientific Research of the Spanish Ministerio de Educacion (Grant number: AP2009-2600), the Spanish Ministerio de Ciencia e Innovacion under Projects ENE2011-22823 and ENE2012-34585 and the Generalitat Valenciana under Projects PROMETEO/2010/039 and ACOMP/2013/237.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Application of the Monte Carlo codes PENELOPE and MCNP5 to unfold X-ray spectra in the diagnostic energy range

  • Gallardo Bermell, Sergio|||0000-0002-3703-9983
  • Verdú Martín, Gumersindo Jesús|||0000-0001-5098-080X
  • Ródenas Diago, José|||0000-0003-3283-9188
  • Querol Vives, Andrea
  • Pozuelo Navarro, Fausto
Obtaining primary X-ray spectra is a complex task mainly due to the high fluence of X-rays. In order to avoid the pile up effect in the detector, an indirect method based on the Compton scattering interactions in a low density rod material can be successfully applied in the diagnostic energy range. In this work, the Monte Carlo codes PENELOPE and MCNP5 have been used to simulate the indirect method based on a simplified Compton spectrometry technique. Both models include the X-ray focus, a poly(mehtylmethacrylate) (PMMA) rod and an HPGe detector. Because the probability that primary photons scattered in the PMMA will be emitted towards the detector is small, it is necessary to consider appropriate values for cut-offs and other simulation parameters. With these models, a response function can be determined, relating the response of the detector to the primary X-ray spectrum. This function can be normally expressed as a matrix, which can be calculated by simulating the response detector to several monochromatic X-ray beams. The main goal of this work is to test the capability of the Monte Carlo codes PENELOPE and MCNP5 together with unfolding methods to estimate the primary spectrum when the response matrix and the response of the detector for a given conditions are known. The reliability of unfolded X-ray spectra is studied by comparing them with theoretical spectra obtained from the IPEM 78 catalogue and calculating the Root Mean Squared (RMS) and Quality parameters., This work was partially supported by the Grant-in-Aid for Scientific Research of Ministry of Education, Spain. Grant number: AP2009-2600, Project leader: Professor Gumersindo Verdu, Universidad Politecnica de Valencia.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Post-test analysis of the ROSA/LSTF and PKL counterpart tests

  • Carlos Alberola, Sofía|||0000-0002-0637-325X
  • Gallardo Bermell, Sergio|||0000-0002-3703-9983
  • Sanchez Saez, Francisco|||0000-0002-3011-9884
  • Villanueva López, José Felipe|||0000-0002-7684-6884
  • Martorell Alsina, Sebastián Salvador|||0000-0003-1706-4740
  • Verdú Martín, Gumersindo Jesús|||0000-0001-5098-080X
  • Querol, A.
[EN] Experimental facilities are scaled models of commercial nuclear power plants, and are of great importance to improve nuclear power plants safety. Thus, the results obtained in the experiments undertaken in such facilities are essential to develop and improve the models implemented in the thermal-hydraulic codes, which are used in safety analysis. The experiments and inter-comparisons of the simulated results are usually performed in the frame of international programmes in which different groups of several countries simulate the behaviour of the plant under the accidental conditions established, using different codes and models. The results obtained are compared and studied to improve the knowledge on codes performance and nuclear safety. Thus, the Nuclear Energy Agency (NEA), in the nuclear safety work area, auspices several programmes which involve experiments in different experimental facilities. Among the experiments proposed in NEA programmes, one on them consisted of performing a counterpart test between ROSA/LSTF and PKL facilities, with the main objective of determining the effectiveness of late accident management actions in a small break loss of coolant accident (SBLOCA). This study was proposed as a result of the conclusion obtained by the NEA Working Group on the Analysis and Management of Accidents, which analyzed different installations and observed differences in the measurements of core exit temperature (CET) and maximum peak cladding temperature (PCT). In particular, the transient consists of a small break loss of coolant accident (SBLOCA) in a hot leg with additional failure of safety systems but with accident management measures (AM), consisting of a fast secondary-side depressurization, activated by the CET. The paper presents the results obtained in the simulations for both installations using TRACE, observing, in general, a good agreement with the experiments. However, ROSA/LSTF calculations underestimated the maximum PCT value, what might be explained by the higher core level predicted in the simulation compared with the experiment. In PKL calculations, PCT maximum value is slightly higher than in the experiment, and the core level predicted is lower. In the comparison of the evolution of both installations a different timing in the transient events is observed, due to the difference in the pressure vessel design. Thus, when PKL vessel is modified with some of the ROSA/LSTF features, the evolution of the new PKL model behaviour is closer the one observed in ROSA/LSTF calculations. (C) 2015 Elsevier B.V. All rights reserved., This paper contains findings that were produced within the OECD-NEA ROSA and PKL Projects. The authors are grateful to the Management Boards of the ROSA and PKL Projects for their consent to this publication. This work is partially supported by the Grant-in-Aid for Scientific Research of the Spanish Ministerio de Educacion (Grant number: AP2009-2600), the Spanish Ministerio de Ciencia e Innovacion under Project ENE2011-22823, by the Grant-in-Aid for Scientific Research of the Vicerrectorado de Investigacion, Innovacion and Transferencia of the Universitat Politecnica de Valencia, by the Consejo de Seguridad Nuclear under project CSN-SIN/4078/2013/640 and by the Generalitat Valenciana under Project PROMETEOII/2014/008.