Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Synthesis and Properties of Hydrophilic and Hydrophobic Deep Eutectic Solvents via Heating-Stirring and Ultrasound

  • Martín, M. I.
  • García-Díaz, Irene
  • Rodríguez Cea, María Lourdes
  • Gutiérrez, María C.
  • Monte, Francisco del
  • López Gómez, Félix Antonio
Deep eutectic solvents (DESs) have emerged as a greener alternative to other more polluting traditional solvents and have attracted a lot of interest in the last two decades. The DESs are less toxic dissolvents and have a lower environmental footprint. This paper presents an alternative synthesis method to the classical heating–stirring method. The ultrasound method is one of the most promising synthesis methods for DESs in terms of yield and energy efficiency. Therefore, the ultrasound synthesis method was studied to obtain hydrophobic (Aliquat 336:L-Menthol (3:7); Lidocaine:Decanoic acid (1:2)) and hydrophilic DESs based on choline chloride, urea, ethylene glycol and oxalic acid. The physical characterization of DESs via comparison of Fourier transform infrared (FTIR) spectra showed no difference between the DESs obtained by heating–stirring and ultrasound synthesis methods. The study and comparison of all the prepared DESs were carried out via nuclear magnetic resonance spectroscopy (NMR). The density and viscosity properties of DESs were evaluated. The density values were similar for both synthesis methods. However, differences in viscosity values were detected due to the presence of some water in hygroscopic DESs, This work was supported by MCIN/AEI/10.13039/501100011033 (TED2021-130372B-C42, TED2021-131812B-I00 and PID2021-123648OB-I00), by “ERDF A way of making Europe” (PID2021-123648OB-I00) and by “European Union Next Generation EU/PRTR” (TED2021-130372B-C42 and TED2021-131812B-I00), Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Recycling and Reutilization of Metals Aided by Deep Eutectic Solvents: from NMC Cathodes of Spent Li-ion Batteries to Electrolytes for Supercapacitors

  • Xu, Boren
  • Díez Nogués, Noel
  • Sevilla Solís, Marta
  • Ferrer, María L
  • Gutiérrez, María C.
  • Del Monte, Francisco
With the rapidly increasing demand for lithium ion batteries (LIBs), recycling the metals found in spent cathodes is mandatory to both alleviate shortages resulting from the mining of natural metal ores and manage the disposal of spent LIBs. The use of deep eutectic solvents (DESs) for metals recovery from spent cathodes of LIBs (e. g., LCO and NMC types) offers a sustainable yet efficient alternative to conventional hydrometallurgical processes. Nonetheless, g efforts are required to use milder temperatures and higher mass loadings, thus ensuring cost-effectiveness. In this latter regard, addressing the reutilization of DESs in subsequent stages of metal extraction, and streamlining or eliminating the chemical procedures employed for metal separation, is even more crucial to guarantee the economic feasibility of the recycling process. Herein, we have prepared a DES that provides extraction efficiencies of ca. 100 % for every metal of NMC cathodes even at mild experimental conditions (e. g., 60 °C) and for loadings as high as 70 mgNMC/gDES. Moreover, we have pioneered the direct use of leachates containing DESs and metals as electrolytes for supercapacitors. This approach enables the reintroduction of DESs and the recovered metals into the value chain with a minimal economic and environmental impact., This work was supported by MCIN/AEI/10.13039/501100011033 (TED2021-130372B-C42, TED2021-131812B-I00, IDI/2018/000148 and PID2021-123648OB-I00), by “ERDF A way of making Europe” (PID2021-123648OB-I00 and IDI/2018/000148) and by “European Union Next Generation EU/PRTR” (TED2021-130372B-C42 and TED2021-131812B-I00). B.X. acknowledges the China Scholarship Council for a Ph.D. research fellowship (CSC No. 20210842007)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

DES-based leachates containing LCO, NMC or NCA oxides as electrolytes for 2.2 V supercapacitors

  • González-Aguilera, Laura
  • Vicent-Luna, José Manuel
  • Ferrer, M. Luisa
  • Monte, Francisco del
  • Gutiérrez, María C.
Nowadays society is increasingly demanding lithium-ion batteries (LIBs). After their useful life, it will be mandatory to recycle the metals found in the spent cathodes to manage the disposal of spent LIBs. Deep eutectic solvents (DESs) have been successfully used for the recovery of metals from spent cathodes. However, little attention has been paid to the recovery of the DES used for metals recovery. This is of utmost importance as the DES content in the leachate can account for up to 60 % of the leachate cost. However, the process is tedious and time-consuming, and the presence of additional solvents and/or reagents indeed jeopardize the recovery of the DES. Herein, we explored the direct use of the full leachate (i.e., DES plus recovered metals) as the electrolyte of a supercapacitor (SC) cells. In particular, we used ethaline with an additional co-solvent (e.g., sulfolane) to obtain leachates with the three oxides most commonly used as cathodes in LIBs, namely, LCO, NMC and NCA. We found that the presence of metals produced a significant enhancement of the performance of the original DES as electrolyte, widening the ESW from 2.0 to 2.2 V and ultimately allowing an enhancement of nearly 30 % in the energy storage capabilities., This work was supported by MCIN/AEI/10.13039/501100011033 (TED2021-130372B-C42, TED2021-131812B-I00 and PID2021-123648OB-I00), by “ERDF A way of making Europe” (PID2021-123648OB-I00) and by “Next Generation EU/PRTR” (TED2021-130372B-C42 and TED2021-131812B-I00). L. G.-A. acknowledges the grant PRE2019-090008 funded by MCIN/AEI/10.13039/501100011033 and “ESF Investing in your future”. J. M. V.-L. also thanks C3UPO for HPC support. M. L. F. and F. dM. thank Prof. Dónal Leech for the fruitful discussions and the access to the research facilities that helped accomplishing this work. M. L. F. also thanks University of Galway for her appointment as Adjunct Lecturer. The Servicio Interdepartamental de Investigación (SIdI) of the Universidad Autónoma de Madrid and the Thermal Analysis Unit at the Instituto de Ciencia de Materiales (ICMM) are acknowledged for helpful assistance with, respectively, NMR, ICP-MS, TGA and DSC studies., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Phytic Acid-Based Deep Eutectic Solvents for Metal Extraction from Lithium Cobalt Oxide and Nickel Manganese Cobalt and the Use of the Resulting Leachates as Electrolytes for 2.0 V Supercapacitors

  • Xu, Boren
  • Ferrer, M. Luisa
  • Monte, Francisco del
  • Gutiérrez, María C.
Li-ion batteries (LIBs) are essential in modern society but raise environmental concerns due to the intensive use of metals in cathodes and the challenges of end-of-life disposal. Besides traditional pyrometallurgical and hydrometallurgical processes used for metal recovery, deep eutectic solvents (DESs) have recently emerged as greener alternatives for leaching metals from spent cathodes of LIBs. A key drawback is, however, the unresolved recovery of the DES, whose cost can represent 30-60% of the leachate, thereby reducing the overall sustainability of the process. Herein, we used the leachates as electrolytes for supercapacitors. DESs based on phytic acid provided leachates with mass loadings of 40 mg of lithium cobalt oxide (LCO) or lithium nickel manganese cobalt oxide (NMC) per gram of DES. The typically poor performance of acidic leachates as electrolytes was addressed through chemical and solvent treatments. Neutralization with tetramethylguanidine expanded the electrochemical window, while dilution with water and/or water-dimethyl sulfoxide mixtures enhanced ionic mobility and rate capability. As a result, the processed leachates delivered energy densities of ≈17.9 Wh kg-1 at 488.35 W kg-1 and 5.77 Wh kg-1 at 4343.72 W kg-1, in the range of those provided by much less cost-efficient electrolytes such as 21 m LiTFSI., This work was supported by MCIN/AEI/10.13039/501100011033(TED2021-130372B-C42, TED2021-131812B-I00, and PID2021-123648OB-I00), by “ERDF A way of making Europe” (PID2021-123648OB-I00), and by “European Union Next GenerationEU/PRTR” (TED2021-130372B-C42, and TED2021-131812B-I00).M.L.F. and F.dM. thank Prof. Dónal Leech for the fruitful discus-sions and the access to the research facilities that helped accom-plish this work. M.L.F. also thanks the University of Galway forher appointment as Adjunct Lecturer. B.X. acknowledges theChina Scholarship Council for a Ph.D. research fellowship(CSC No. 20210842007). The Servicio Interdepartamental deInvestigación (SIdI) of the Universidad Autónoma de Madrid,the Laboratorio de Análisis Geoquímico y Medioambiental fromthe Unidad de Técnicas Geológicas of the UniversidadComplutense de Madrid, and the Thermal Analysis Unit ofthe Instituto de Ciencia de Materiales (ICMM) are acknowledgedfor helpful assistance with, respectively, FTIR, NMR, TXRF, ICP-OES, and DSC studies, The data that support the findings of this study are available from the corresponding author upon reasonable request., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Anion-rich solvation structures in high entropy aqueous electrolytes for supercapacitors with enlarged potential windows and superior rate capabilities

  • González-Aguilera, Laura
  • Vicent-Luna, José Manuel
  • García-Balaguer, Paula
  • Calero, Sofia
  • Madero-Castro, Rafael M.
  • Raymundo-Piñero, Encarnación
  • Lu, Xuejun
  • Gutiérrez, María C.
  • Ferrer, M. Luisa
  • Monte, Francisco del
The use of aqueous electrolytes as suitable electrolytes for supercapacitors (SCs) largely depends on maintaining a wide operating cell voltage window while ensuring good rate capabilities, thereby achieving high energy and power densities over many cycles. Electrolyte engineering with anion- and/or solvent-rich solvation structures has been recently explored in batteries of any type to enhance the interphase stability at high voltages, typically by the formation of a SEI. This approach has been less explored in SCs to not only extend the range of operational voltage but also balance the inherently distinct electrochemical stability of cations and anions with carbon electrodes. Herein, we prepared electrolytes composed of two ionic liquids with a common cation (e.g., EMIMTFSI and EMIMBF<inf>4</inf>) in solvent mixtures of H<inf>2</inf>O, DMSO and CH<inf>3</inf>CN. We found that the electrolyte with the richest solvation structure (i.e., with many and diverse anions that surrounded the cation) was the most effective at widening the cell voltage at which the electrolyte is capable of operating (e.g., up to 2.2 V). Interestingly, this extremely rich solvation structure also exhibited the best transport properties for different ions that, ultimately, were responsible for an excellent maintenance of the energy density at high power densities., This work was supported by MCIN/AEI/10.13039/501100011033 (TED2021-130372B-C42, TED2021-131812B-I00 and PID2021-123648OB-I00), by “ERDF A way of making Europe” (PID2021-123648OB-I00) and by “European Union Next Generation EU/PRTR” (TED2021-130372B-C42 and TED2021-131812B-I00). Authors also acknowledge the Severo Ochoa Centres of Excellence Program through Grant CEX2024-001445-S. L. G.-A. acknowledges the grant PRE2019-090008 funded by MCIN/AEI/10.13039/501100011033 and “ESF Investing in your future”. P. G.-B. acknowledges the grant PRE2022-101750 funded by MCIN/AEI/10.13039/501100011033 and ESF+. X. L. also acknowledges the National Natural Science Foundation of China (22393961). J. M. V.-L., S. C., and R. M. M.-C. also thank C3UPO for HPC support. The Servicio Interdepartmental de Investigación (SIdI) of the Universidad Autónoma de Madrid and the Thermal Analysis Unit at the Instituto de Ciencia de Materiales de Madrid (ICMM) are acknowledged for helpful assistance with FTIR and NMR spectroscopies and DSC studies, respectively., Data for this article, including data presented in gures and tables have been included as part of the SI. Experimental procedures, tables with different data (physicochemical properties, NMR chemical shis, etc.), NMR, ATR and NIR spectra, RDFs from MD simulations, and electrochemical results (CVs, GCDs, Nyquist plots, etc.). See DOI: https://doi.org/10.1039/d5ta04796j., Peer reviewed