Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Giant Photocaloric Effects across a Vast Temperature Range in Ferroelectric Perovskites

  • Rurali, Riccardo
  • Escorihuela Sayalero, Carlos
  • Tamarit, Josep Lluís
  • Íñiguez, Jorge
  • Cazorla, Claudio
Solid-state cooling presents an energy-efficient and environmentally friendly alternative to traditional refrigeration technologies that rely on thermodynamic cycles involving greenhouse gases. However, conventional caloric effects face several challenges that impede their practical application in refrigeration devices. First, operational temperature conditions must align closely with zero-field phase-transition points; otherwise, the required driving fields become excessively large. However, phase transitions occur infrequently near room temperature. Additionally, caloric effects typically exhibit strong temperature dependence and are sizable only within relatively narrow temperature ranges. In this Letter, we employ first-principles simulation methods to demonstrate that light-driven phase transitions in polar oxide perovskites have the potential to overcome such limitations. Specifically, for the prototypical ferroelectric KNbO_{3} we illustrate the existence of giant "photocaloric" effects induced by light absorption (ΔS_{PC}∼100  J K^{-1} kg^{-1} and ΔT_{PC}∼10  K) across a vast temperature range of several hundred Kelvin, encompassing room temperature. These findings are expected to be generalizable to other materials exhibiting similar polar behavior., We acknowledge financial support by the Spanish Ministry of Science under the Grants No. PID2020–119777 GB-I00, No. TED2021-130265BC22, No. PID2020–112975 GB-I00, No. RYC2018024947-I and by the Generalitat de Catalunya under the Grants No. 2021SGR-00343 and No. 2021SGR-01519. This work is part of the Severo Ochoa Excellence Programme (CEX2023-001263-S). Computational support was provided by the Red Española de Supercomputación under the Grants No. FI-2023-2-0004, No. FI-2023-30043, and No. FI-2024-1-0005. This work is part of Maria de Maeztu Units of Excellence Programme CEX2023-001300-M funded by MCIN/AEI/10.13039/ 501100011033. Work at LIST was supported by the Luxembourg National Research Fund through Grant No. C21/MS/15799044/FERRODYNAMICS., With funding from the Spanish government through the ‘Severo Ochoa Centre of Excellence’ accreditation (CEX2023-001263-S)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Lead-free room-temperature ferroelectric thermal conductivity switch using anisotropies in thermal conductivities

  • Féger, Lucile
  • Escorihuela Sayalero, Carlos
  • Rampnoux, Jean-Michel
  • Kontou, Kyriaki
  • Bah, Micka
  • Íñiguez, Jorge
  • Cazorla, Claudio
  • Monot-Laffez, Isabelle
  • Douri, Sarah
  • Grauby, Stéphane
  • Rurali, Riccardo
  • Dilhaire, Stefan
  • Gomès, Séverine
  • Nataf, Guillaume F.
Materials with on-demand control of thermal conductivity are the prerequisites to build thermal conductivity switches, where the thermal conductivity can be turned ON and OFF. However, the ideal switch, while required to develop novel approaches to solid-state refrigeration, energy harvesting, and even phononic circuits, is still missing. It should consist of an active material only, be environment friendly, and operate near room temperature with a reversible, fast, and large switching ratio. Here, we first predict by ab initio electronic structure calculations that ferroelectric domains in barium titanate exhibit anisotropic thermal conductivities. We confirm this prediction by combining frequency-domain thermoreflectance and scanning thermal microscopy measurements on a single crystal of barium titanate. We then use this gained knowledge to propose a lead-free thermal conductivity switch without inactive material, operating reversibly with an electric field. At room temperature, we find a switching ratio of 1.6 $\pm$ 0.3, exceeding the performances of state-of-the-art materials suggested for thermal conductivity switches., We thank F. Barcella, R. Doineau, and B. Negulescu for technical support for aluminum sputtering. We thank J. C. A. Abanto for technical support for developing 3D simulation for SThM measurement post-treatment. This paper was cofunded by the European Union [European Research Council (ERC), DYNAMHEAT, Grant No. 101077402; European Program FP7-NMP-LARGE-7, QUANTIHEAT, Grant No. 604668]. We acknowledge financial support by MCIN/AEI/10.13039/501100011033 under Grant No. PID2020-119777GB-I00, the “Ramón y Cajal” fellowship RYC2018-024947-I and the Severo Ochoa Centres of Excellence Program (CEX2019-000917-S), by the Generalitat de Catalunya (2021 SGR 01519), and by the Luxembourg National Research Fund (C21/MS/15799044/FERRODYNAMICS). Some of this work has been performed on the CERTeM (microelectronics technological research and development center) technological platform supported by French region Centre Val de Loire, Tours Metropolis and FEDER funds., With funding from the Spanish government through the ‘Severo Ochoa Centre of Excellence’ accreditation (CEX2019-000917-S)., Peer reviewed