Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

e-Archivo. Repositorio Institucional de la Universidad Carlos III de Madrid
Publication Artículo científico (JournalArticle)

Study of the La₁/₂+₁/₂ₓLi₁/₂-₁/₂ₓTi₁-ₓAlₓO₃ (0 ≤ x ≤ 1) solid solution. A new example of percolative system in fast ion conductors

  • Sotomayor Lozano, María Eugenia
  • Levenfeld Laredo, Belén
  • Varez, Alejandro
  • Sanz, Jesús
The synthesis by solid state reaction of new fast ion conductors with perovskite structure was carried out. The crystal structure and electric properties of the La1/2+1/2xLi1/2-1/2xTi1-xAlxO3 (0 ≤ x ≤ 1) solid solution were investigated by powder X-ray diffraction and impedance spectroscopy. All compositions of the La1/2Li1/2TiO3-LaAlO3 system, exhibited a single cubic perovskite structure (ac approximate to 3.87-3.79 angstrom; SG Pm-3m). The progressive decrease in the unit cell parameters agrees with the lower ionic radii of Al3+ in relation to Ti4+, which are allocated in the same octahedra. An upward deviation from the lineal ideal solid solution behavior described by Vegard's law was observed and it was tentatively associated with a volume excess created by solid dilution of non-isovalent cations. Structural features were deduced from Rietveld analysis of XRD patterns. Ti(Al)O6 octahedra are regular and La/vacancies are randomly distributed in A-site of the perovskite. The conductivity decreased almost four orders of magnitude with the Li content. This important decrease on the conductivity was attributed to the charge carrier (Li+) decrease and the blockade of the perovskite conduction pathways by La ions, according to a three dimensional percolative process. In consequence we present here a new example of percolative system of ionic conductors and the results confirm the important role played by effective vacant A-sites, neff = [Li] + nA, on Li conductivity of this fast ion conductors family with perovskite structure., Authors thank financial support received from MINECO (MAT2013-46452-C4-3-R and MAT2016-78362-C4-3-R projects), regional CAM government (MATERYENER 3CM, P2013/MIT-2753 program) and the European Commission (Program-IRSES FP7-PEOPLE Project ID: 247579 (NANOLICOM).
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Structural characterisation and Li conductivity of Li1/2−xSr2xLa1/2−xTiO3 (0<x<0.5) perovskites

  • Sotomayor Lozano, María Eugenia
  • Várez, A.
  • Bucheli, Wilmer
  • Jiménez, Ricardo
  • Sanz Lázaro, Jesús
The crystal structure and electric properties of different compositions of the Li1/2La1/2TiO3–SrTiO3 system, which were prepared by solid-state reaction, were investigated. The limits of the Li1/2−xSr2xLa1/2−xTiO3 solid solution (0.0625≤x≤0.25) were established by X-ray diffraction (XRD) and scanning electron microscopy (SEM) analyses. All compositions exhibited a single cubic perovskite structure (ac≈3.87–3.90 Å; SG Pm-3m), as determined by XRD analysis. Along the solid solution, a positive deviation from Vegard's law was observed. This deviation was related to the occurrence of incipient La and Sr segregation/clustering in apparently homogeneous single phases. The room-temperature Li conductivity ranged from 7.4×10−4 to 2.8×10−5 S cm−1, and the activation energy of the samples was close to 0.33 eV, similar to that of the best Li-ion conductors. The substitution of Li by Sr decreased the number of effective vacancies (nt=[Li]+ϒ, where ϒ is the nominal A-vacancy concentration), which appreciably reduced the Li conductivity when the nt approached the 3D percolation threshold. In this series, the percolation threshold is greater than expected, which reinforces the idea that the incipient segregation is responsible for the deviation from Vegard's law., The authors thank the Regional (CAM) Government (MATERYENER S2009 PPQ-1626), the National Government (MICINN) (MAT2010-19837-CO6), and the European Programme-IRSES (NANOLICOM) for financial support., Peer Reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

The effect of sol–gel preparation conditions on structural characteristics and magnetic properties of M-type barium hexaferrite thin films

  • Solovyova, E. D.
  • Calzada, M. L.
  • Belous, A. G.
© 2015, Springer Science+Business Media New York. Abstract: We have shown the possibility to obtain M-type barium hexaferrite thin films with thickness of ~200–450 nm on the surface of dielectric α-Al<inf>2</inf>O<inf>3</inf> substrates with low microwave dielectric loss (tan δ ~ 10<sup>−4</sup> GHz) by a sol–gel method. For the production of high-dense homogeneous thin films of M-type barium hexaferrite (BaFe<inf>12</inf>O<inf>19</inf>, BHF) with nanorod-like grains and a uniform distribution of iron and barium ions, we have studied the synthesis conditions for thermally stable film-forming solutions with high concentrations of barium ions. Films with a c-axis magnetic texture were obtained by spin-coating the former solutions on α-Al<inf>2</inf>O<inf>3</inf> substrates and annealing at temperatures between 473 and 1073 K. The resulting textured M-type BHF films have demonstrated the following magnetic parameters: H<inf>c⊥</inf> = 334 kA/m, H<inf>c||</inf> = 167 kA/m; M<inf>s⊥</inf> = 0.005 emu, M<inf>s||</inf> = 0.003 emu for the films’ thickness of ~200 nm, and H<inf>c⊥</inf> = 360 kA/m, H<inf>c||</inf> = 338 kA/m; M<inf>s⊥</inf> = 0.009 emu, M<inf>s||</inf> = 0.007 emu for the films’ thickness of ~450 nm. These M-type BHF thin films can serve as a promising basis for further development of multilayer microwave resonant elements. Graphical Abstract: [Figure not available: see fulltext.], We acknowledge the project “NANOLICOM” (FP7-PEOPLE-2009-IRSES program, 2011–2014, Grant agreement No. 247579) and the partial support of the Spanish Project MAT2013-40489-P., Peer Reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

On the influence of the cation vacancy on lithium conductivity of Li1 + xRxTi2 - X(PO4)3 Nasicon type materials

  • Arbi, Kamel
  • Jiménez, Ricardo
  • Šalkus, T.
  • Orliukas, A. F.
  • Sanz Lázaro, Jesús
Structural features responsible for outstanding Li conductivity of Li1 + xRxTi2 − x(PO4)3 (LRTP) Nasicon samples (0 ≤ x ≤ 0.6 and R = Al, Sc, In) prepared by the ceramic route have been analyzed by XRD, ND, MAS-NMR and impedance spectroscopy. The structural analysis showed that all samples display the rhombohedral (S.G. R-3c) symmetry. The structural site occupancy has been investigated by 7Li, 27Al/45Sc and 31P MAS-NMR spectroscopy. The Fourier map differences deduced from high-resolution ND patterns of LAlTP samples revealed that Li ions occupy Li1 sites and to a lower extent Li3/Li3′ sites inside Li2 cavities. The location of Li at 3 sites minimizes electrostatic Li (Li1–Li3) repulsions, enhancing local mobility in LRTP samples. A maximum of conductivity was detected for 0.2 ≤ x ≤ 0.4, when a significant amount of vacant Li1 sites was created at the intersection of conduction pathways. The increment of vacant Li1 sites explains the existence of two Li motion regimes detected by 7Li NMR and impedance spectroscopy. In the low temperature regime, activation energy and migration entropy of Li have been related by the Meyer–Neldel relationship. In the high-temperature regime, further investigation is required to assess the role of vacancy in lithium conductivity., The authors thank MINECO (project MAT2010-19837-C06-02) and the regional Government of Madrid (project S-2009/PPQ 1626) for financial support. The NANOLICOM project (FP7-PEOPLE-2009-IRSES) is also acknowledged. K. Arbi wishes to thank CSIC for the contract JAE-DOC 2009.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Aqueous and non-aqueous Li+/H+ ion exchange in Li0.44La0.52TiO3 perovskite

  • Durán, Teresa
  • Climent-Pascual, Esteban
  • Pérez-Prior, Maria T.
  • Levenfeld, Belén
  • Varez, Alejandro
  • Sobrados, Isabel
  • Sanz Lázaro, Jesús
The topotactic Li/H exchange in LiLaTiO has been studied in different aqueous and non-aqueous media with different acidity. With this purpose, aqueous hydrochloric and nitric acid solutions and benzoic acid/ethanol solution were employed. The pristine and exchanged samples have been characterized by H and Li MAS-NMR, TGA and XRD techniques. Aqueous hydrochloric and nitric acid solutions produce the powders degradation and the subsequent formation of LiTiO and LaTiO phases. A detailed analysis of the H MAS NMR spectra of exchanged samples indicate that Li/H exchange reaction in pure water produced formation of LiOH at the particles surface, band at 0 ppm, that could subsequently carbonated after exposition in air. Furthermore the presence of other OH signals at 8, 6 and 2 ppm has been related to differences on octahedral Ti-O distances, produced by La/vacancy ordering in alternating planes of perovskites. In samples immersed into benzoic acid/ethanol solution results are similar, however the amount of LiOH species in particle surface is considerable lower. The exchange degree improved when increasing exchange temperature. The mechanical grinding of powders decreases the particle size improving exchange reactions; however, grinding treatments eliminated specific NMR bands of perovskite. In ground materials new H NMR bands at 6 and 4 ppm were ascribed to an amorphous phase., This work has been supported by Projects funded by the Regional Government (Comunidad de Madrid through MATERYENER3 CM S2013/MIT-2753) and the Spanish Government, (MICINN through MAT2013-46452-C4-3R Project). The authors also thank the European Programme-IRSES (NANOLICOM) for financial support.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Cation Miscibility and Lithium Mobility in NASICON Li1+xTi2-xScx(PO4)3 (0 ≤ x ≤ 0.5) Series: A Combined NMR and Impedance Study

  • Kahlaoui, Radhouene
  • Arbi, Kamel
  • Sobrados, Isabel
  • Jiménez Riobóo, R. J.
  • Sanz Lázaro, Jesús
  • Ternane, Riadh
Rhombohedral NASICON compounds with general formula LiTiSc(PO) (0 ≤ x ≤ 0.5) have been prepared using a conventional solid-state reaction and characterized by X-ray diffraction (XRD), nuclear magnetic resonance (NMR), and impedance spectroscopy. The partial substitution of Ti by Sc and Li in pristine LiTi(PO) increases unit-cell dimensions and the number of charge carriers. In Sc-rich samples, the analysis of XRD data andLi/Li,P, andSc MAS NMR spectra confirms the presence of secondary LiScO and LiScPO phases that reduce the amount of lithium incorporated in the NASICON phase. In samples with x < 0.3, electrostatic repulsions between Li ions located at M1 and M3 sites increase Li mobility. For x ≥ 0.3, ionic conductivity decreases because of secondary nonconducting phases formed at grain boundaries of the NASICON particles (core-shell structures). For x = 0.2, high bulk conductivity (2.5 × 10 S·cm) and low activation energy (E = 0.25 eV) measured at room temperature make LiTiSc(PO) one of the best lithium ionic conductors reported in the literature. In this material, the vacancy arrangement enhances Li conductivity., R.K. would like to thank the Tunisian Ministry of Higher Education and Scientific Research for financial support. This work was funded by Spanish MINECO MAT2013-46452-C4-2R and MATERYENER3-CAM (S2013/MIT-2753) projects and the European NANOLICOM (FP7-PEOPLE-2009-IRSES) project.