Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Peak forces and lateral resolution in amplitude modulation force microscopy in liquid

  • Vargas Guzmán, Horacio Andrés
  • García García, Ricardo
This is an Open Access article under the terms of the Creative Commons Attribution License., The peak forces exerted on soft and rigid samples by a force microscope have been modeled by performing numerical simulations of the tip motion in liquid. The forces are obtained by using two contact mechanics models, Hertz and Tatara. We present a comparison between the numerical simulations and three analytical models for a wide variety of probe and operational parameters. In general, the forces derived from analytical expressions are not in good quantitative agreement with the simulations when the Young modulus and the set-point amplitude are varied. The only exception is the parametrized approximation that matches the results given by Hertz contact mechanics for soft materials and small free amplitudes. We also study the elastic deformation of the sample as a function of the imaging conditions for materials with a Young modulus between 25 MPa and 2 GPa. High lateral resolution images are predicted by using both small free amplitudes (less than 2 nm for soft materials) and high set-point amplitudes. © 2013 Guzman and Garcia., This work was funded by the Ministerio de Economía y Competitividad (Consolider Force-For-Future, CSD2010-00024, MAT2009-08650) and European Union Seventh Framework Programme [FP7/2007-2013] under grant agreement no. 280772, project iONE-FP7 and the Cost Action TD1002., Peer Reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

On the mechanical and electronic properties of thiolated gold nanocrystals

  • Smaali, K.
  • Foti, Giuseppe
  • Frederiksen, Thomas
  • Sánchez-Portal, Daniel
  • Arnau, Andrés
  • Clément, N.
This article is part of themed collection: 2015 Hot Papers in Nanoscale.-- arXiv:1412.7698v1.-- et al., We present a quantitative exploration, combining experiment and simulation, of the mechanical and electronic properties, as well as the modifications induced by an alkylthiolated coating, at the single nanoparticle (NP) level. We determined the response of the NPs to external pressure in a controlled manner using an atomic force microscope tip. We found a strong reduction in their Young's modulus, as compared to bulk gold, and a significant influence of strain on the electronic properties of the alkylthiolated NPs. Electron transport measurements of tiny molecular junctions (NP/alkylthiol/CAFM tip) show that the effective tunnelling barrier through the adsorbed monolayer strongly decreases by increasing the applied load, which translates in a remarkable and unprecedented increase in the tunnel current. These observations are successfully explained using simulations based on the finite element analysis (FEA) and first-principles calculations that permit one to consider the coupling between the mechanical response of the system and the electric dipole variations at the interface., P.L. is a Senior Research Associate from the Fund for Scientific Research of Belgium (F.R.S. – FNRS). K.S. has been supported by the NordPas-de Calais Council fund and the ANR project SAGE III-V (no. ANR11BS1001203) and S.D. by EU project I-ONE (FP7 no. 280772). The experiments were partly funded by the SINGLEMOL project supported by the Nord-Pas-de Calais council fund. We also acknowledge funding from the Basque Government (Grant No. IT-756-13) and the Spanish MINECO (Grant Nos. MAT2013-46593-C6-2-P and FIS2013-48286-C2-2-P)., Peer Reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

In situ nanomechanical characterization of the early stages of swelling and degradation of a biodegradable polymer

  • Dumitru, Andra C.
  • Espinosa, Francisco M.
  • García García, Ricardo
  • Foschi, G.
  • Tortorella, S.
  • Valle, F.
  • Dallavalle, M.
  • Zerbetto, Francesco
  • Biscarini, F.
The interactions of a biodegradable scaffold with cells or living tissues depend on the time-evolution of the nanoscale properties of the scaffold. We present an in situ quantitative study on the early-stage swelling and degradation of poly(lactic-co-glycolic acid) (PLGA). A novel metrology scheme based on force microscopy measurements of the patterns of PLGA nanostructures is developed to characterize the evolution of topography, volume and nanomechanical properties. The volume and nanoscale roughness show an oscillating behaviour during the first eight days of immersion; at a later stage, we observe a continuous decrease of the volume. The effective Young's modulus exhibits a monotonic decrease from an initial value of about 2.4 GPa down to 9 MPa at day 14. The oscillating behaviour of the volume before the onset of full degradation is explained by a coupled diffusion-swelling mechanism. The appearance of a second maximum in the volume evolution results from the competition between swelling and degradation., This work was founded by the European Union Seventh Framework Programme [FP7/2007–2013] under the grant agreement no. 280772, project iONE-FP7 and MINECO (Spain), project CSD2010-00024.