Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

Recercat. Dipósit de la Recerca de Catalunya
Publication Contribución de congreso (ConferenceOutput)

A fully data-driven approach for leak localization in water distribution networks

  • Romero Ben, Luis
  • Puig Cayuela, Vicenç
  • Cembrano Gennari, Gabriela
  • Blesa Izquierdo, Joaquim
  • Meseguer Amela, Jordi
© 2021 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting /republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works, This paper presents a data-driven technique for the localization of leaks in water distribution networks (WDN). The methodology requires hydraulic data, i.e., pressure measurements from a set of sensors installed throughout the network and topological information. Therefore, the hydraulic model of the WDN is not necessary for its operation. The hydraulic state of the complete set of nodes of the network is approximated by means of a graph-based interpolation technique. Then, a set of candidates where the leak can be located is achieved by comparing the computed states for both the leaky and nominal cases. The methodology is applied to a case study based on a real network, providing and discussing several graphical results and key performance indicators., The authors want to thank the RIS3CAT Utilities 4.0 SENIX project (COMRDI16-1-0055), as well as the Spanish national project DEOCS (DPI2016-76493-C3-3-R) and the Spanish State Research Agency through the María de Maeztu Seal of Excel, Peer Reviewed, Postprint (author's final draft)
Recercat. Dipósit de la Recerca de Catalunya
Publication Contribución de congreso (ConferenceOutput)

SOC and diffusion rate estimation in redox flow batteries: An I&I-based high-gain observer approach

  • Clemente Escuin, Antonio
  • Cecilia Piñol, Andreu
  • Costa Castelló, Ramon
© 2021 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting /republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works, This paper presents an adaptive non-linear observer for the state of charge estimation in vanadium redox flow batteries. The study is based directly on the use of non-linear equations that describe the evolution of the species concentration inside the system, and a nonlinear cell voltage expression that takes into account the effect of overpotentials. Moreover, a more realistic approach is used which does not consider that the electrolyte concentration is the same in the catholyte and anolyte sides of the system. It is shown that the state of charge can be estimated through the measurement of the output voltage and a high-gain observer. Nonetheless, the accuracy of the estimation is affected by uncertainty in the system diffusion rates. For this reason, the observer is robustified by means of an immersive and invariance adaptive parameter estimation. The results are validated in a numerical simulation., This research was funded by the CSIC under the PTI FLOWBAT 2021 project (ref. 642 201980E101), the Spanish Ministry of Economy and Competitiveness under Project DOVELAR (ref. RTI2018-096001-B-C32), and by the Spanish State Research Agency through the María de Maeztu Seal of Excellence to IRI (MDM-2016-0656)., Peer Reviewed, Postprint (author's final draft)
Recercat. Dipósit de la Recerca de Catalunya
Publication Artículo científico (JournalArticle)

Inter-comparison of commercial continuous radon monitors responses

  • Radulescu, Ileana
  • Calin, M. R.
  • Luca, A.
  • Röttger, Annette
  • Grossi, Claudia
  • Done, Laurentiu
  • Ioan, M. R.
Indoor and outdoor (atmospheric) radon activity concentrations need to be measured as accurate as possible for radiation protection and for climate applications. Particularly radon concentrations below 100 Bq m -3, useful for the retrieval of radon prone areas and for atmospheric studies, still need a robust metrological chain to ensure their quality. Ones of the most common used commercial continuous radon monitors were compared here under slightly different environmental conditions. The measured data set were divided into two groups (< 100 Bq m -3 and 100 Bq m -3) to assess the monitors responses and their associated uncertainties. Nevertheless, these results should also to point out if commercial monitors are suitable for monitoring low atmospheric radon concentrations with an associated uncertainty of 10% (k=1). This work, carried out within the EMPIR 19ENV01 traceRadon project, aims to offer a starting point for the development of a future radon monitor as transfer standard to increase the metrological capabilities of atmospheric radon monitoring., Peer Reviewed, Postprint (published version)
Recercat. Dipósit de la Recerca de Catalunya
Publication Artículo científico (JournalArticle)

A self-calibrating and multiplexed electrochemical lab-on-a-chip for cell culture analysis and high-resolution imaging

  • Giménez-Gómez, Pablo
  • Rodríguez-Rodríguez, Rosalía
  • Ríos, Juan Manuel
  • Pérez-Montero, Marta
  • González, Estrella
  • Gutiérrez-Capitán, Manuel
  • Plaza, Jose Antonio
  • Muñoz-Berbel, Xavier
  • Jiménez-Jorquera, Cecilia
This work was supported by the Spanish R & D National Program (MEC Project TEC2014-54449-C3-1-R and RTI2018-100773-B-C31)., In vitro analysis requires cell proliferation in conditions close to physiological ones. Lab-on-a-chip (LoC) devices simplify, miniaturize and automate traditional protocols, with the advantages of being less expensive and faster due to their shorter diffusion distances. The main limitation of current LoCs is still the control of the culture conditions. Most LoCs employ off-chip equipment to determine cell culture activity, which confers limited monitoring capacity. The few systems integrating transducers on-chip present important functional problems mostly associated with the attachment of biomolecules to the transducer surface (i.e., biofouling) and the impossibility of re-calibrating the sensors during cell culturing. This limitation is addressed in the present LoC containing a network of micro-channels and micro-chambers, which allows (i) cell seeding and cultivation, avoiding biofouling risk, (ii) multiplexed analysis of cell culture, reactivation and recalibration of the (bio)sensors without compromising cell viability, (iii) cell imaging and (iv) reference electrode compartmentalization to guarantee stability. The activity of the culture is monitored with four independent electrochemical micro-electrodes for glucose, hydrogen peroxide, conductivity and oxidation reduction potential. Electrochemical analysis is complemented with high-resolution confocal microscopy analysis. This paper demonstrates the suitability of the current configuration for cell culture monitoring and future applications in drug screening or organ-on-a-chip development., info:eu-repo/semantics/acceptedVersion
Recercat. Dipósit de la Recerca de Catalunya
Publication Artículo científico (JournalArticle)

Herramientas para la docencia de control digital en grados de ingeniería, Tools for teaching digital control in engineering degrees

  • Lerma Macaya, Eneko
  • Costa Castelló, Ramon
  • Griñó Cubero, Robert
  • Sanchis, Carlos
En este trabajo se describen un conjunto de materiales pedagógicos que han sido desarrollados para dar soporte a la docencia del control digital. En particular, se presentan un conjunto de herramientas interactivas y el proyecto Duino-Based Learning (DBL) pensado para desarrollar prácticas experimentales de control digital utilizando Arduino. Además, se describe el contenido de un curso de control digital, que  se imparte en el marco de una titulación de ingeniería industrial, y como se utilizan las diferentes herramientas desarrolladas en su docencia., Peer Reviewed, Postprint (published version)