Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Understanding the effect of Intake temperature on the f-sensitivity of toluene-ethanol reference fuels and neat ethanol

  • Alemahdi, Nika
  • Tunér, Martin
  • García Martínez, Antonio|||0000-0001-5783-4936
[EN] The low-temperature combustion (LTC) is an attractive concept that enables the modem combustion engines to move toward sustainability mainly by increasing the efficiency and decreasing the emissions. The modern combustion engines which are working based on the LTC concept have specific fuel requirements. Fuel f-sensitivity is a key factor to be considered for tailoring fuels for these engines. Fuel with a high f-sensitivity are more responsive to thermal or fuel stratifications; the auto-ignition properties of different air-fuel mixtures of these fuels, with different equivalence ratio (f), are more diverse. This diversity provide a smoother heat release rate in stratified condition. In this study 11 different toluene¿ethanol reference fuels (TERFs) in three research octane number (RON) groups of 63, 84, and 105 together with neat ethanol are evaluated. The Lund f-sensitivity method is used to evaluate these fuels in a cooperative fuel research (CFR) engine. The effect of variation of intake temperature on pressure sensitivity of fuel at a constant combustion phasing is evaluated. This evaluation is performed at two intake temperature of 373 and 423 K, and the results are compared with the outcome of the Lund f-sensitivity number with the intake temperature of 323 K. This study shows that the CR sensitivity response of different blends to the intake charge temperature variation depends on the fuel composition. Accumulated low temperature heat release and latent heat of vaporization. It proves that the fuel f-sensitivity will vary under different thermodynamic conditions. There was a clear link between the accumulated heat released during the early reaction and CR sensitivity of the blends at different intake temperature of 373 and 423K but the link with the latent heat of vaporization (HoV) found to be inexplicit., The author(s) disclosed receipt of the following financial support for the research, authorship, and/or publication of this article: This research has been co-funded by the Swedish Energy Agency under the project Future Alternative Transportation Fuels'' and the project number 41139-1.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Development of a fast-virtual CFR engine model and its use on autoignition studies

  • García Martínez, Antonio|||0000-0001-5783-4936
  • Monsalve-Serrano, Javier|||0000-0001-8593-095X
  • Lago-Sari, Rafael
  • Fogué-Robles, Álvaro
  • Alemahdi, Nika
  • Tunér, Martin
  • López Pintor, Darío
[EN] Homogenous charge compression ignition engines have been studied as an alternative to the conventional diesel combustion to attain high efficiency with ultra-low NOx and soot emissions for a wide variety of fuels. However, its usage in real applications has been restricted due to the difficulties regarding combustion control and operating range extension. The modification of the fuel characteristics may be a pathway to solve the previous hurdles. Therefore, this research presents a relevant methodology to assess the fuel response to HCCI boundary conditions based on 0-D and 1-D modelling for detailed chemistry solution and state conditions definition, respectively. The results suggest that the methodology can predict the early stages of the fuel oxidation with good accuracy. For the objective of predicting the start of combustion, the best results are obtained using tabulated chemistry when investigating fuels that have pre reactions and a low temperature heat release. As the oxidation process progresses, the deviation of the pressure-temperature trajectory from non-reactive to reactive conditions after the low temperature heat release decreases the predictive capability to some extent. Nonetheless, the methodology outcomes are still valid as a qualitative metric for reactivity determination as well as the intermediate and high temperature ignition delay, This work has been partially funded by Spanish Ministry of Science, Innovation and Universities under the ¿Salvador de Madariaga¿ grant (PRX18/00131) and by the Swedish Energy Agency under the project ¿Future Alternative Transportation Fuels¿ and the project number 41139-1. The project partners were F3, Lantmannen, ¿ Perstorp AB, Preem, Scania AB, st1, Saybolt Sweden AB, Stena Line, Volvo AB, and Volvo Cars
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Development of an empirical test method to quantify the Phi-sensitivity of liquid fuels.

  • Alemahdi, Nika
  • Boufaim, Emma
  • Aferiat, Giulia
  • Tunér, Martin
  • García Martínez, Antonio|||0000-0001-5783-4936
[EN] Several researchers are investigating strategies to lower the emissions and increase the efficiency of combustion engines to reduce the negative impact on the environment and the climate from transportation. The low-temperature combustion (LTC) concept is the basis for some of these high-efficiency, low-emission combustion technologies. To maximize the combustion controllability of engines based on the LTC concept, the combustion behavior of fuel both at different equivalence ratios (¿) and under ¿ sweeps must be understood and planned precisely. The ¿-sensitivity of a fuel explains its behavior at different engine loads or stratification levels. In this study, a new test method for empirically evaluating ¿-sensitivity using a Cooperative Fuel Research (CFR) engine is proposed and the validity of the method is investigated. A modified CFR engine for homogeneous-charge compression ignition (HCCI) combustion is used to investigate the compression ratio (CR) sensitivity of different toluene¿ethanol reference fuels (TERFs) in a research octane number (RON) range of 63¿105. This study suggests a method to quantify the ¿-sensitivity of different fuels and blends by measuring the compression ratio required to keep the CA50 constant while varying ¿. It shows that the fuel composition greatly affects the fuel ¿-sensitivity even for different blends with the same RON. The results also indicate that the coexistence of ethanol and toluene in a blend can generate the highest ¿-sensitivity of the blend compared to other blends with the same RON. Fuel composition has a strong effect on emissions. The simultaneous effect of fuel composition and ¿ variation on the emission and stability parameters is nonlinear., This research was co-funded by the Swedish Energy Agency under the project "Future Alternative Transportation Fuels" and the project number 41139-1. The project partners were f3, Lantmannen, Perstorp AB, Preem, Scania AB, st1, Saybolt Sweden AB, Stena Line, Volvo AB, and Volvo Cars. The authors would like to acknowledge the KCFP Engine Research Centre for providing laboratory facilities. The technicians at the Division of Combustion Engines at Lund University are also acknowledged for their support with the experimental setup.