Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Electroconductivity of Al2O3/graphene nanocomposite processed by SPS technique

  • Sánchez Bolinches, Alejandro|||0000-0003-4149-0918
  • Klyatskina, Elizaveta
  • Segovia-López, Francisco|||0000-0002-4143-5751
  • Zholnin, A.G.
  • Stolyarov, Vladimir V.
[EN] Electrical conductivity (rho), relative dielectric permittivity (epsilon) and dissipation factor (D) measured in graphene-alumina composites. Samples obtained by plasma spark sintering (SPS) from a mixture of raw powders: delta-alumina (36 nm average particle size) and graphene flakes (3 nm thickness and 2-3 microm length). Graphene content in samples was 0, 1 and 2% by weight. The study carried out for frequencies from 50 Hz to 100 kHz. Both rho and epsilon were higher for Al2O3-2% graphene: up to 90 microS/m and 19 respectively; while alumina with 1% graphene showed similar values to the pure alumina samples: 50 microS/m to electrical conductivity and 16 to relative permittivity. The dissipation factor was similar in the three materials tested. D increased with the frequency, reaching high values (0.7) at 100 kHz. Composites with 1 and 2% graphene content showed a dissimilar dielectric behavior with the frequency. Alumina reflected a classical behavior of the permittivity dependence with the frequency. Graphene composites also show the same behavior at frequencies above 100 Hz. Below this frequency, the presence of graphene increases the relative permittivity to exceed that from pure alumina. The graphene content leads to rise of relative permittivity, which means easier polarizability., Authors wishing to acknowledge the financial support of the Ministry of Education and Science of the Russian Federation, project no. 11.1957.2017/4.6 (composite compaction processing); RNF (properties investigation), grant no. 16-19-10213.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Structure Features and Properties of Graphene/Al2O3 Composite

  • Klyatskina, E.
  • Grigoriev, Evgenii
  • Zholnin, Aleksander
  • Stolyarov, V.V.
  • Borrell Tomás, María Amparo|||0000-0003-4292-4538
  • Salvador Moya, Mª Dolores|||0000-0002-4242-478X
[EN] Since its discovery, graphene has attracted worldwide attention in the scientific community owing to its unique combination of properties. Thus, graphene is an ideal second phase to improve the structure and properties of metal, ceramic and polymer composite materials. This work presents a comparative study of two types of alumina-graphene composites fabricated with two sizes of delta-Al2O3 powders, nanometer and submicrometer, reinforced by graphene nanoplatelets (GNPs) and consolidated with the spark plasma sintering technique. The microstructure, mechanical and tribological properties of Al2O3-GNPs composites are influenced by the grain size of the ceramic matrix. Hardness values improve notably. The maximum value reached was 27.4 GPa for a composite fabricated with nanometric alumina powders, which is about 27 % higher than that of the Al2O3 monolithic material. Also, the methodology of powder mixing has a fundamental importance in obtaining materials with high-level properties., This work has been supported by the Competitiveness Program National Research Nuclear University MEPhI (Moscow Engineering Physics Institute), Russian Ministry of Education and Science No. 02. A 03.21.0005; the Russian Science Foundation No16 - 19 - 10213; the Spanish Ministry of Economy and Competitiveness project MAT2015 - 67586-C3-R. E. Klyatskina acknowledges the Valencian Government for her Post-Doc. Contract APOSTD/2014/046 and A. Borrell acknowledges the Spanish Ministry of Economy and Competitiveness for her contract RYC2016 - 20915.