Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

TECNALIA Publications
Publication Artículo científico (JournalArticle)

Purification and concentration of formic acid from formic acid/gluconic acid mixtures by two successive steps of nanofiltration and reactive liquid-liquid extraction

  • Roncal, Tomás
  • Lorenzo, Leire
  • Prieto-Fernández, Soraya
  • Ochoa-Gómez, José R.
A downstream process for the purification and concentration of formic acid (FA) from FA/gluconic acid (GA) mixtures, obtainable by a coupled biocatalytic reaction of CO2 reduction and glucose oxidation, has been developed. The process involved two technologies: i) a first nanofiltration (NF) step to separate FA and GA, and ii) a second reactive liquid-liquid extraction (RLLE) step to concentrate FA. The NF process, using a Synder NFX membrane, consisted of three NF steps separated into two divergent lines, named permeate and retentate pathways. The first NF was common for both pathways, resulting in a permeate strongly enriched in FA and depleted in GA, and a retentate with opposite characteristics. In the permeate pathway, this first permeate was subjected to a second NF to obtain a 99.6% pure FA permeate. In the retentate pathway, an additional NF step on the first retentate resulted in a concentrated 99.4% pure GA retentate. The final diluted FA permeate was concentrated by RLLE using tri-N-octylamine as extractant in n-octanol, and a final back-extraction with NaOH. The optimized RLLE process involved a 100-fold volume decrease and resulted in a final FA solution (as sodium formate) of 174.5 g/L, 78 times more concentrated than the feed.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Cloning, expression, and one-step purification/immobilization of two carbohydrate-binding module-tagged alcohol dehydrogenases

  • Benito, Mario
  • Román, Ramón
  • Ortiz, Garazi
  • Casablancas, Antoni
  • Álvaro, Gregorio
  • Caminal, Glòria
  • González, Gloria
  • Guillén, Marina
The feasibility of biochemical transformation processes is usually greatly dependent on biocatalysts cost. Therefore, immobilizing and reusing biocatalysts is an approach to be considered to bring biotransformations closer to industrial feasibility, since it does not only allow to reuse enzymes but can also improve their stability towards several reaction conditions. Carbohydrate-Binding Modules (CBM) are well-described domains involved in substrate binding which have been already used as purification tags., This project has received funding from the European Union’s Horizon 2020 Research and Innovation programme under Grant Agreement n°761042 (BIOCON-CO2). This output reflects the views only of the author and the European Comission cannot be held responsible for any use which may be made of the information contained therein. The research group is recognized by Generalitat de Catalunya as 2017 SGR 1462., Peer reviewed
Dipòsit Digital de Documents de la UAB
Publication Artículo científico (JournalArticle)

Lactic Acid from CO2, A Carbon Capture and Utilization Strategy Based on a Biocatalytic Approach

  • Carceller, Albert|||0000-0002-6457-747X
  • Guillén, Marina|||0000-0002-9740-9966
  • Álvaro, Gregorio|||0000-0002-2924-8902
The EU low-carbon economy aims to reduce the level of CO emission in the EU to 80% by 2050. High efforts are required to achieve this goal, where successful CCU (Carbon Capture and Utilization) technologies will have a high impact. Biocatalysts offer a greener alternative to chemical catalysts for the development of CCU strategies since biocatalysis conforms 10 of the 12 principles of green chemistry. In this study, a multienzymatic system, based on alcohol dehydrogenase (ADH), pyruvate decarboxylase (PDC), and lactate dehydrogenase (LDH), that converts CO and ethanol into lactic acid leading to a 100% atom economy was studied. The system allows cofactor regeneration, thus reducing the process cost. Through reaction media engineering and enzyme ratio study, the performance of the system was able to produce up to 250 μM of lactic acid under the best conditions using 100% CO, corresponding to the highest concentration of lactic acid obtained up to date using this multienzymatic approach. For the first time, the feasibility of the system to be applied under a real industrial environment has been tested using synthetic gas mimicking real blast furnace off-gases composition from the iron and steel industry. Under these conditions, the system was also capable of producing lactic acid, reaching 62 μM. The use of CO as a feedstock for the synthesis of chemicals can contribute to carbon recycling, with a consequent reduction of fossil fuel needs while reducing greenhouse gas emissions. This study reports a biocatalytic CCU strategy to produce lactic acid.
Dipòsit Digital de Documents de la UAB
Publication Artículo científico (JournalArticle)

Cloning, expression, and one-step purification/immobilization of two carbohydrate-binding module-tagged alcohol dehydrogenases

  • Benito Peinado, Mario|||0000-0001-6305-7424
  • Román, Ramón|||0000-0003-2311-2737
  • Ortiz-Orruño, Garazi|||0000-0001-6013-7920
  • Casablancas, Antoni|||0000-0002-0773-9364
  • Álvaro, Gregorio|||0000-0002-2924-8902
  • Caminal i Saperas, Glòria|||0000-0001-9646-6099
  • González, Gloria
  • Guillén, Marina|||0000-0002-9740-9966
The feasibility of biochemical transformation processes is usually greatly dependent on biocatalysts cost. Therefore, immobilizing and reusing biocatalysts is an approach to be considered to bring biotransformations closer to industrial feasibility, since it does not only allow to reuse enzymes but can also improve their stability towards several reaction conditions. Carbohydrate-Binding Modules (CBM) are well-described domains involved in substrate binding which have been already used as purification tags. In this work, two different Carbohydrate-Binding Modules (CBM3 and CBM9) have been successfully fused to an alcohol dehydrogenase from Saccharomyces cerevisiae, which has been produced in bench-scale reactor using an auxotrophic M15-derived E. coli strain, following a fed-batch strategy with antibiotic-free medium. Around 40 mg·g - 1 DCW of both fusion proteins were produced, with a specific activity of.