Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

Repositorio Institucional de la Universidad de Burgos (RIUBU)
Publication Artículo científico (JournalArticle)

Kinetic study of the semi-continuous extraction/hydrolysis of the protein and polysaccharide fraction of the industrial solid residue from red macroalgae by subcritical water

  • Trigueros Andrés, Ester
  • Alonso Riaño, Patricia
  • Ramos Rodríguez, Cipriano
  • Diop, Cherif Ibrahima Khalil
  • Beltrán Calvo, Sagrario
  • Sanz Díez, Mª Teresa
The valorization of the underexploited solid residue after agar extraction from red marine algae was studied by subcritical water treatment. Experiments were carried out in two different semi-continuous fix-bed reactor configurations at 185 ºC at different subcritical water residence times. The use of a by-pass section allowed to heat the water previous contact to the biomass, avoiding the exposure of the sample to high temperatures during the heating procedure and reducing the formation of degradation products. Higher hydrolysis yields were obtained for the protein fraction (reaching 96.1%) than for the carbohydrate fraction (reaching 45.7%, 11.3%, 27.5% and 57.6% for galactans, glucans, arabinans and uronic acids, respectively). With the decrease of the residence time, by increasing the flow rate, higher initial hydrolysis rates were obtained due to enhancing diffusion of the hydrolysis products into the bulk solution. It was determined a similar dependence of the initial hydrolysis rates on the residence time for the carbohydrate oligomers and total protein fraction, but the release of free amino acids was less dependent on increasing flow rate due to higher diffusion coefficients for small molecules., Agencia Estatal de Investigación (Spain) [grant number PID2019–104950RB-I00 / AEI / 10.13039/501100011033], the Junta de Castilla y León (JCyL) and the European Regional Development Fund (ERDF) [grant numbers BU301P18 and BU050P20] E. Trigueros and P. Alonso-Riaño predoctoral contracts were funded by the JCyL and the European Social Fund (ESF) by ORDEN EDU/574/2018, de 28 de mayo and ORDEN EDU/556/2019, de 5 de junio, respectively. The C. I. K. Diop contract was funded by the European Commission, Horizon 2020 program through the Marie-Curie Individual Fellowship (H2020-MSCA-IF-2019), with regards to the ALGWAS-BIOR project (Grant agreement number 898804).
Repositorio Institucional de la Universidad de Burgos (RIUBU)
Publication Artículo científico (JournalArticle)

Pressurized hot water-assisted recovery of crude residual agar from a never-dried algae industry waste stream: A Box-Behnken design approach

  • Diop, Cherif Ibrahima Khalil
  • Trigueros Andrés, Ester
  • Sanz Díez, Mª Teresa
  • Beltrán Calvo, Sagrario
  • García Tojal, Javier
The potential of using pressurized hot water extraction to valorize the remaining crude agar in Gelidium sesquipedale waste stream after an initial industrial extraction was investigated. In this process, a four-factor Box-Behnken design was coupled with a response surface methodology. The impact of the operating temperature (°C), the internal pressure (bar), the extraction time (min), and the algae concentration (% w: v), as well as their quadratic effects and two-way interactions, on the physicochemical properties of the residual agar, was analyzed. The yield (%), gel strength (g/cm2), gelling temperature (°C), melting temperature (°C), 3,6-anhydrogalactose content (%), and the sulfate content (%) were all considered in the evaluation. A multiple regression statistical model was used to fit all the experimental responses to a second-order polynomial equation that confirmed the suitability of the approach. Temperature of 120 °C, low pressure of 3.28 bar, and an extended extraction time of 150 min along with a 3% (w: v) algae concentration were projected to be optimum conditions for a high extraction yield of 17.03%. The strength of the recovered agar hydrogel oscillated between a minimum of 25 g/cm2 and a maximum of 350 g/cm2. The key parameters impacting the fluctuation of the sulfate content in the recovered agar (2% ≤ sulfate content ≤10%, with R2 = 79.8%) appeared to be the temperature and the algae concentration, in addition to the quadratic effect of the solid concentration. By adjusting the parameters, the process can accommodate the physicochemical properties of agar for wider range of applications., European Commission, Horizon 2020 program through the Marie-Curie Individual Fellowship (H2020-MSCA-IF-2019), with regards to the ALGWAS-BIOR project (Grant agreement number 898804). This work was also supported by the Junta de Castilla y León (JCyL) and the European Regional Development Fund (ERDF) [grant numbers BU301P18 and BU050P20]; as well as the Agencia Estatal de Investigación [grant number AEI /10.13039/501100011033].
Repositorio Institucional de la Universidad de Burgos (RIUBU)
Publication Artículo científico (JournalArticle)

Adjustable Gel Texture of Recovered Crude Agar Induced by Pressurized Hot Water Treatment of Gelidium sesquipedale Industry Waste Stream: An RSM Analysis

  • Diop, C.I.K.
  • Beltrán Calvo, Sagrario
  • Jaime Moreno, Isabel
  • Sanz Díez, Mª Teresa
A significant amount of bioactive compound-rich solid waste is released during the industrial phycocolloid-centric extraction of Gelidium sesquipedale. The impact of mild pressurized hot water extraction on repurposing this waste for the recovery of agar with an adjustable gel texture is investigated. A two-factor interaction response surface model assessed the influences of the operating temperatures (80 to 130 °C), times (45 and 150 min), pressures (1 to 70 bar), and algae concentrations (3 to 10% (w:v)). At a temperature of 100 °C, a pressure of 10.13 bar, a recovery time of 45 min, and a 10% algae concentration, the working parameters were considered ideal (w:v). Agar with a hardness of 431.6 g, an adhesiveness of −13.14 g.s−1, a springiness of 0.94, a cohesiveness of 0.63, and a gumminess of 274.46 g was produced under these conditions. A combined desirability of 0.78 was obtained for the exposed technology that retrieved gels with a minimum agar yield of 10% and thermal hysteresis between 39 ± 1 and 52 ± 0.5 °C. The fitted design can provide a high techno-commercial value to the agri-food industrial waste stream., This research was funded by the European Commission, Horizon 2020 program through the Marie-Curie Individual Fellowship (H2020-MSCA-IF-2019), with regards to the ALGWAS-BIOR project (Grant agreement number 898804).