Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Assessment of Myofascial Trigger Points with ultrasound: a methodology combining external vibration with Power Doppler Imaging and B-mode

  • Herrero, Pablo
  • Lapuente-Hernández, Diego
  • Blanco, Teresa
  • Casas, Roberto
  • Valera-Garrido, Fermín
  • Minaya-Muñoz, Francisco
  • Gomes Monres, Jose
  • Gómez-Trullén, Eva María
Introduction: This case series explores a novel methodology for identifying myofascial trigger points (MTrPs) by integrating Doppler and B-mode ultrasound with externally applied vibratory stimulation. The study aims to address the current lack of accessible and objective tools for MTrP assessment in clinical settings. Case presentation: Five participants were included: four healthy individuals and one post-stroke patient. A custom-designed vibration device was developed to apply mechanical stimulation to the gastrocnemius medialis muscle, while ultrasound imaging was collected using a standardized setup. To optimize vibration signal detection within muscle tissue, different configurations of the electrodes transmitting the vibration and the Doppler modes (Color Doppler and Power Doppler Imaging (PDI)) were tested. Results: PDI demonstrated superior sensitivity to vibration-induced muscle responses compared to conventional Color Doppler. A consistent pattern was identified among healthy participants. This pattern consisted of well-defined, non-vibratory zones surrounded by vibratory regions, corresponding to hypoechoic areas on B-mode ultrasound. These findings are suggestive of MTrPs and distinct from other stiff anatomical structures, such as fascia, tendons, or fibrotic tissue, which appear hyperechoic. In the stroke patient, pathological muscle adaptations reduced the consistency and visibility of vibratory stimulus propagation; however, MTrP-compatible areas were still identified. Notably, dry needling altered the Doppler signal in this case, attenuating the previously observed pattern. Conclusions: This proof-of-concept study demonstrates the feasibility and reproducibility of a cost-effective assessment protocol that uses conventional ultrasound modes. Combining PDI, B-mode, and vibration may improve the objective identification of MTrPs and expand capabilities in musculoskeletal practice.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Laser induced surface nitriding of niobium: Phase evolution and superconducting behaviour

  • Frechilla, J.
  • Frechilla, A.
  • de la Fuente, G.F.
  • Larrea, A.
  • Angurel, L.A.
  • Martínez, E.
Laser nitriding is a versatile approach for tailoring the surface properties of metals. To date, its effect on the superconducting response of niobium nitrides remains largely unexplored. In this study, the nitriding of niobium by laser irradiation under controlled nitrogen atmospheres up to 2.50 bar using a nanosecond pulsed laser (λ = 1064 nm) was investigated. Niobium sheets were processed over a wide range of laser conditions, including pulse widths (20–200 ns), repetition frequencies (175–1000 kHz) and scanning speeds (15–250 mm/s). By independently tuning the nitrogen pressure, two-dimensional accumulated fluence (F2D) and laser irradiance, a laser processing map for the formation of β-Nb2N (hexagonal) and γ-Nb4N3±x (tetragonal) phases was established. The phase, microstructural and superconducting properties were characterized using X-ray diffraction, scanning electron microscopy, electron backscatter diffraction and SQUID magnetometry. The γ-phase forms in the near-surface layer through melting when F2D exceeds a threshold (> 50 kJ/cm2 at 2.50 bar). Beneath this layer, a β-layer was observed, followed by embedded β-grains in the Nb matrix, whose size decreases with depth, indicating thermal gradients and a diffusion-controlled growth mechanism. When the γ-phase becomes predominant, the superconducting critical temperature increases to Tc ≈ 15 K, accompanied by magnetic irreversibility. Lower F2D conditions (≈ 7.5 kJ/cm2 at 1.50–2.50 bar) promote a uniform β-Nb2N layer composed of submicron-sized grains, yielding a fourfold enhancement in surface microhardness. These findings establish the first systematic correlation between the laser nitriding parameters and the superconducting properties of Nb–N layers.