Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Shear wave modeling and Poisson's ratio in the Variscan Belt of SW Iberia

  • Palomeras, Imma
  • Carbonell, Ramón
  • Ayarza, Pui
  • Martí, David
  • Brown, Dennis
  • Simancas, José Fernando
In 2003 two wide-angle reflection/refraction seismic transects were acquired in the Variscan Belt of SW Iberia. The approximately 250 and 300 km long, dense trace spacing transects revealed clear S wave arrivals in the shot gathers recorded by vertical component sensors in both transects. First S wave arrivals (Sg) and Moho reflections (SmS) are the most prominent phases that can be correlated from shot to shot. Sg is observed up to relatively large offsets and constrains the upper and middle crust S wave velocities. The SmS is seen from offset 0 (18 s twtt) to 150 km offset, where it intercepts first S wave arrivals (Sg). The upper mantle refracted phase (Sn) is difficult to recognize, although PmS/SmP converted phases can be identified. Using a 2-D ray tracing approach, two S wave velocity models for the crust of SW Iberia were obtained. These S wave velocity models complement the previous P wave velocity models and provide us with relatively well resolved Poisson's ratio crustal sections for SW Iberia. The resulting Poisson's ratio models present differences between tectonic zones at upper and middle crustal depths, thus supporting the existence of different tectonic zones prior to the Variscan collision. The most noteworthy feature is the high Poisson's ratio value (over 0.28) coincident with high P wave velocity areas (over 6.8 km/s) at midcrustal depths. In order to constrain the possible crustal composition, P wave velocities and Poisson's ratios have been compared with published laboratory measurements on different crustal rock types. This comparison indicates that the high P wave velocity and Poisson's ratios are compatible with a mixture of mafic to ultramafic rock types alternating with felsic ones. This result is consistent with the existence of mafic layered bodies in the middle crust, in the same way that has been suggested by previous works in this area. Copyright 2011 by the American Geophysical Union., Funding for this research was provided by the Spanish Ministry of Education and Science through projects CGL200404623, CGL2007-63889, and TOPOIBERIA CONSOLIDER-INGENIO CSD2006-00041; the Generalitat de Catalunya (2005SGR00874); and the Junta de Andalucía.
Dipòsit Digital de Documents de la UAB
Publication Artículo científico (JournalArticle)

Crustal thickness and velocity structure across the Moroccan Atlas from long offset wide-angle reflection seismic data, the SIMA experiment

  • Ayarza, P.
  • Carbonell, R.
  • Teixell, Antonio|||0000-0002-7423-6361
  • Palomeras, I.
  • Martí, D.
  • Kchikach, A.
  • Harnafi, M.
  • Levander, A.
  • Gallart, Josep|||0000-0003-3833-9571
  • Arboleya, María Luisa|||0000-0002-9700-5566
  • Alcalde, J.
  • Fernández, M.
  • Charroud, M.
  • Amrhar, M.
The crustal structure and topography of the Moho boundary beneath the Atlas Mountains of Morocco has been constrained by a controlled source, wide-angle seismic reflection transect: the SIMA experiment. This paper presents the first results of this project,consisting of an almost 700 km long, high-resolution seismic profile acquired from the Sahara craton across the High and the Middle Atlas and the Rif Mountains. The interpretation of this seismic dataset is based on forward modeling by raytracing, and has resulted in a detailed crustal structure and velocity model for the Atlas Mountains. Results indicate that the High Atlas features a moderate crustal thickness, with the Moho located at a minimum depth of 35 km to the S and at around 31 km to the N, in the Middle Atlas. Upper crustal shortening is resolved at depth through a crustal root where the Saharan crust underthrusts the northern Moroccan crust. This feature defines a lower crust imbrication that, locally, places the Moho boundary at ~40-41 km depth in the northern part of the High Atlas. The P-wave velocity model is characterized by relatively low velocities, mostly in the lower crust and upper mantle, when compared to other active orogens and continental regions. These low deep crustal velocities together with other geophysical observables such as conductivity estimates derived from MT measurements, moderate Bouguer gravity anomaly, high heat flow, and surface exposures of recent alkaline volcanism lead to a model where partial melts are currently emplaced at deep crustal levels and in the upper mantle. The resulting model supports the existence of a mantle upwelling as mechanism that would contribute significantly to sustain the High Atlas topography. However, the detailed Moho geometry deduced in this work should lead to a revision of the exact geometry and position 43 of this mantle feature and will require new modeling efforts.