Skip to main content

DESARROLLO DE METODOLOGIAS DE ESPECIACION QUIMICA DIRECTA E INDIRECTA PARA LA CARACTERIZACION EFICIENTE DE SISTEMAS CONTAMINADOS. (AGUAS INDUSTRIALES, SUELOS CONTAMINADOS Y PATRIMONIO MONUMENTAL)

CTQ2009-07432

•
Funding agency name Ministerio de Ciencia e Innovación
Funding agency acronym MICINN
Program Programa Nacional de Proyectos de Investigación Fundamental
Subprogram Subprograma de Proyectos de Investigación Fundamental no Orientada
Call Proyectos I+D
Call year 2009
State Plan 2008-2011 Plan Nacional de Investigación Científica, Desarrollo e Innovación Tecnológica
Management unit Subdirección General de Proyectos de Investigación
Beneficiary centre UNIVERSIDAD AUTONOMA DE BARCELONA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

Dipòsit Digital de Documents de la UAB
Publication Artículo científico (JournalArticle)

Molecularly imprinted polymer-liquid chromatography/fluorescence for the selective clean-up of hydroxylated polycyclic aromatic hydrocarbons in soils

  • Baltrons Rosell, Oriol
  • López-Mesas, Montserrat|||0000-0002-4470-0194
  • Palet, Cristina|||0000-0002-7467-613X
  • Le Derf, Franck
  • Portet-Koltalo, Florence
Hydroxylated polycyclic aromatic hydrocarbons (OH-PAHs), a group of metabolites produced during the biodegradation of PAHs by microorganisms, are known to be difficult to analyze from complex environmental or biological matrices. In the field of contaminated soils, where OH-PAHs are less studied, a new method was compared to a common method for the analysis of monohydroxylated PAH metabolites: 2-naphthol, 2-hydroxyfluorene, 9-phenanthrol and 1-hydroxypyrene. After optimizing the microwave assisted extraction (MAE) step, the obtained extracts, containing the OH-PAHs together with the corresponding PAHs, were purified by molecularly imprinted polymers (MIPs). MIPs showed an effective selectivity for the hydroxylated derivatives studied (and not for native PAHs), which allowed their identification and quantification by HPLC/FLD. By this method, good limits of detection (0.003-0.014 μg g-1) and limits of quantification (0.010-0.044 μg g-1) were achieved. On the other hand, following the common method, the sample extract was concentrated by evaporation, silylated, and analyzed by GC/MS. The new method was more sensitive for all OH-PAHs and the analysis showed fewer matrix effects due to the use of MIP clean-up. In the present work the advantages and disadvantages of the new method are shown, as well as the possible application to soil biodegradation studies.
Dipòsit Digital de Documents de la UAB
Publication Artículo científico (JournalArticle)

Pre-concentration of Uranium (VI) using bulk liquid and supported liquid membrane systems optimized containing bis(2-ethylhexyl) phosphoric acid as carrier in low concentrations

  • Candela, Angélica María|||0000-0002-9674-6055
  • Benatti, Viola
  • Palet, Cristina|||0000-0002-7467-613X
The present study describes the pre-concentration of Uranium (VI) from nitric acid solutions (0.100 mg/L) by using bulk liquid membrane (BLM) and supported liquid membrane (SLM) systems. The transport of Uranium (VI) through both membrane systems was studied using low concentration of bis(2-ethyl hexyl) phosphoric acid (D2EHPA) as carrier in kerosene solvent which favors the removal of Uranium (VI) traces (0.001 or 0.004 mol/L). The stripping used was a mixture of phosphoric acid and citric acid, with concentrations ranging from 0.150 mol/L up to around 0.600 mol/L, which improves the removal of the Uranium (VI). In the case of SLM, the polymeric supports used were homemade Polysulfone membranes (PSf) and commercial Polyvinylidene Fluoride membranes from Millipore (PVDF). The kinetics of the uranyl ion transport system was studied for up to 24 h under fixed physical and chemical conditions. Maximum extraction values obtained were above 95%, and recovery yields were in the range 57-79% for the BLM and 90% for the SLM. Pre-concentration systems in both kinds of membrane systems are properly demonstrated and presented in this paper.
Dipòsit Digital de Documents de la UAB
Publication Artículo científico (JournalArticle)

Bioseparation of Pb(II) and Cd(II) from aqueous solution using cork waste biomass. Modeling and optimization of the parameters of the biosorption step

  • López-Mesas, Montserrat|||0000-0002-4470-0194
  • Navarrete, Enrique Ruperto
  • Carrillo Navarrete, Fernando|||0000-0002-7357-9143
  • Palet, Cristina|||0000-0002-7467-613X
In this work the ability of cork wastes to remove Cd(II) and Pb(II) from aqueous solutions has been studied. The kinetics of the biosorption system, the influence of the aqueous pH and the initial metal concentration on the metal uptake were investigated, showing a pH dependent profile. The maximum sorption for both metals was found at pH 5, independently that if the metals were in individual solutions or mixed. When a solution of the mixed metals were studied, a reduction in the Cd(II) uptake was observed showing a clear competition between the metals which was corroborated by the P-factor approach, behavior probably due to a lower attraction of this metal towards the corresponding active groups of the cork. Finally, the cork has been evaluated by FTIR and SEM in order to determine if the biosorption process modifies its chemical structure and morphology, respectively. Cork has been proved to be an efficient biomaterial useful for heavy metal separation purposes that is not altered by the process.