Skip to main content

NUEVOS MATERIALES Y PROCESOS PARA EL ALMACENAMIENTO, PURIFICACION Y DETECCION DE HIDROGENO

CTQ2009-10813

•
Funding agency name Ministerio de Ciencia e Innovación
Funding agency acronym MICINN
Program Programa Nacional de Proyectos de Investigación Fundamental
Subprogram Subprograma de Proyectos de Investigación Fundamental no Orientada
Call Proyectos I+D
Call year 2009
State Plan 2008-2011 Plan Nacional de Investigación Científica, Desarrollo e Innovación Tecnológica
Management unit Subdirección General de Proyectos de Investigación
Beneficiary centre UNIVERSIDAD DE ALICANTE

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

A comparison between oxidation of activated carbon by electrochemical and chemical treatments

  • Berenguer, Raúl
  • Marco-Lozar, Juan Pablo
  • Quijada Tomás, Cesar
  • Cazorla-Amoros, Diego
  • Morallón, Emilia
The anodic oxidation of a granular activated carbon (GAC) in NaCl solution has been studied. The influence of the electrocatalyst-anode material, applied current and time of treatment on both the surface chemistry and porous texture properties of the GAC has been analyzed. For comparison purposes, the same GAC has been treated with three of the classical chemical oxidants: HNO 3, H 2O 2 and (NH 4) 2S 2O 8 at different concentrations and for different times. Results show that the anodic treatment in NaCl causes a remarkable oxidation of the AC without modifying significantly its textural properties. TPD profiles and the linear dependence of the amount of CO- and CO 2-evolution against the oxidation level denotes that surface oxygen groups of similar nature and composition are formed anodically, regardless of the anode material. The achieved oxidation degree depends on the different ability of each anode for the electrochemical generation of highly oxidizing chlorine species, and it increases progressively with the applied current and the time of treatment. In general, for similar treatment times, the anodic treatment in NaCl can produce oxidation degrees much higher than the chemical treatment with (NH 4) 2S 2O 8, which has been found to be the most oxidative chemical studied in this work., Financial support by the Ministerio de Ciencia e Innovacion (MAT2010-15273 and CTQ2009-10813) and Generalitat Valenciana and FEDER (PROMETEO/2009/047) projects are gratefully acknowledged.
RUA. Repositorio Institucional de la Universidad de Alicante
Publication Otros (Other)

Spherical activated carbons for low concentration toluene adsorption

  • Romero Anaya, Aroldo José
  • Lillo-Rodenas, Maria Angeles
  • Linares-Solano, Angel
  • Lillo-Rodenas, Maria Angeles|||/items/d56418ee-38bb-491e-a494-7f14757d264f
The activation process of a spherical activated carbon (SAC) from Kureha Carbon was analysed and the behaviour of these materials to adsorb low concentration volatile organic compounds was studied. Two series of activated carbons were prepared using CO2 or steam as activating atmospheres at 880 and 840 °C, respectively. Activation times between 45 min and 24 h were selected, leading to burn-offs between 21 and 60%. The results show, for similar burn-off percentages, that the porosity development is similar for the two activating gases at moderate burn-off percentages, and larger for CO2 than for steam at high burn-off percentages. For similar burn-offs, steam leads to SACs with slightly larger bed densities than CO2. In general, a low and similar increase in the total surface oxygen groups’ content is noted after activation with both activating agents. Toluene adsorption capacities as large as 46 g toluene/100 g SAC can be achieved with some of these spherical activated carbons in a continuous flow-through SAC bed, when influent air-phase toluene was 200 ppmv. Considering that these SACs have quite high bed densities, their toluene adsorption capacities per unit of volume reach remarkably high values.
RUA. Repositorio Institucional de la Universidad de Alicante
Publication Otros (Other)

Comparison among Chemical, Thermal, and Electrochemical Regeneration of Phenol-Saturated Activated Carbon

  • Berenguer Betrián, Raúl
  • Marco Lozar, Juan Pablo
  • Quijada Tomás, César
  • Cazorla-Amorós, Diego
  • Morallon, Emilia
  • Berenguer Betrián, Raúl|||/items/660b8462-63ec-4910-98e0-ac425e6bd7a6
  • Cazorla-Amorós, Diego|||/items/bab354fe-ec79-49e0-a4f3-5288ee396750
  • Morallon, Emilia|||/items/a15cf511-9365-4c40-afcb-ea29d4418244
The regeneration of phenol-saturated activated carbon (AC) by chemical, thermal, and electrochemical techniques has been studied and compared in this work. The influence of the solute (NaOH) concentration and the temperature on the conventional chemical and thermal regenerations, respectively, has been analyzed and compared to the optimal results achieved for the electrochemical method. Comparisons are based on the analysis of the remaining products after regeneration, the regeneration efficiency (RE), and the recovery of the textural properties of a commercial phenol-saturated granular AC. Results show that very low-porosity recoveries are achieved by chemical regeneration, independent of the NaOH concentration, and the optimal REs are 20% lower than those obtained by the thermal and electrochemical ones. REs obtained by thermal treatment in an inert atmosphere increase with the temperature up to 750 °C, reaching the highest REs (80−86%) and porosity recoveries at T > 600 °C. The cathodic regeneration in the NaOH medium in an undivided cell, where phenolate desorption is favored and surface blockage is minimized, yields similar RE values (80−85%) and slightly higher porosity than those obtained by thermal treatment. Temperature-programmed desorption (TPD) experiments show that, whereas phenol is almost completely removed electrochemically after 3 h, a temperature of at least 450−600 °C is required to achieve similar results by thermal regeneration.