Skip to main content

ESTUDIO DE LA UTILIZACION DE CELULOSA MICROFIBRILADA EN LA FABRICACION DE PAPEL RECICLADO: EFECTO SOBRE LA RETENCION Y EL DRENAJE DE LAS PASTAS

CTQ2012-36868-C02-01

•
Funding agency name Ministerio de Economía y Competitividad
Funding agency acronym MINECO
Program Programa Nacional de Proyectos de Investigación Fundamental
Subprogram Subprograma de Proyectos de Investigación Fundamental no Orientada
Call Proyectos I+D
Call year 2012
State Plan 2008-2011 Plan Nacional de Investigación Científica, Desarrollo e Innovación Tecnológica
Management unit Secretaría de Estado de Investigación, Desarrollo e Innovación
Beneficiary centre UNIVERSIDAD COMPLUTENSE DE MADRID

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

Docta Complutense
Publication Artículo científico (JournalArticle)

Synergies between cellulose nanofibers and retention additives to improve recycled paper properties and the drainage process

  • Merayo, Noemi
  • Balea Martín, Ana
  • Fuente González, Elena de la
  • Blanco Suárez, María Ángeles
  • Negro Álvarez, Carlos Manuel
Cellulose nanofibers (CNF) have increasing relevance in different applications, for instance, in the paper industry as a sustainable strength additive. This application is especially beneficial for recycled paper, which reaches higher product quality despite its limitations. CNF change paper properties and also can affect the production process, especially the drainage stage, in which retention additives (RA) are commonly used to promote interaction of cellulose fibers. CNF probably interact with fibers and RA, affecting the drainage stage. However, these interactions vary depending on the type and flocculation mechanism of RA. This research is aimed at establishing possible synergies between CNF and RA to improve paper strength, avoiding negative effects on the drainage process. No further RA were used to retain CNF, taking advantage of the RA already used in the process. Polyvinylamine, chitosan, cationic starch, C-PAM, and C-PAM-B were selected as RA. CNF from eucalyptus kraft pulp and corn stalk organosolv pulp were tested. Strength properties of laboratory sheets were studied, and interactions were assessed by measuring Z-potential. Synergies between PVA, chitosan, C-PAM, and C-PAM-B with CNF were found. Drainage time decreased ranging between 30 and more than 40% using CNF. Strength depended on RA and formation quality. Among the studied options, CNF with C-PAM-B or chitosan resulted in the best formation and higher strengths with a significant drainage time reduction.
Docta Complutense
Publication Artículo científico (JournalArticle)

Effect of bleached eucalyptus and pine cellulose nanofibers on the physico-mechanical properties of cartonboard

  • Balea Martín, Ana
  • Blanco Suárez, María Ángeles
  • Monte Lara, María Concepción
  • Merayo, Noemi
  • Negro Álvarez, Carlos Manuel
Extending the limits of paper recycling by increasing the number of recycling cycles results in decreased mechanical properties due to the irreversible hornification of cellulose fibers. This process alters the fiber structure and properties because of the repeated chemical and mechanical treatments that occur during wetting and drying. As a result, poor tensile strength is the main source of customer complaints to paper manufacturers. Cellulose nanofibers (CNF) from bleached eucalyptus and pine pulps were investigated as potential strength additives because of their proven contribution to interfiber bonding. These results were compared to the results obtained using different families of strength additives. The effects on the mechanical properties of recycled old corrugated containers were studied by measuring bursting, tensile, and short span compressive strength. Cellulose nanofibers and cationic polyacrylamide (cPAM) improved the mechanical strength properties when they were added at doses around 4 wt.%. A combination of CNF and cPAM was also tested. The effects of the combined additives were not as high as expected compared to the results achieved individually. The CNF from pine pulp resulted in the highest increase in bursting index when combined with cPAM, achieving an increase of over 93%. The combination of CNF from eucalyptus pulp and cPAM increased the bursting index over 60%.
Docta Complutense
Publication Artículo científico (JournalArticle)

Assessing the influence of refining, bleaching and TEMPO-mediated oxidation on the production of more sustainable cellulose nanofibers and their application as paper additives

  • Balea Martín, Ana
  • Merayo, Noemi
  • Fuente González, Elena de la
  • Negro Álvarez, Carlos Manuel
  • Blanco Suárez, María Ángeles
Agro-wastes valorization focusses on production of high value-added products, such as cellulose nanofibers (CNF), and contributes to reduce the environmental impact of these residues. CNF have been used successfully as papermaking additives and some previsions maintain that this sector will become the most important, demanding CNF at a reasonable cost. Furthermore, the optimization of the production process of CNF from agricultural residues would contribute to the goals of a circular economy, the development of rural areas and the costs reduction by producing CNF of the minimum quality fit-for-use in recycled paper. In this study, CNF was produced from two agricultural residues; corn (C-CNF) and rape (R-CNF) stalk pulps, pretreated with bleaching, refining and TEMPO-mediated oxidation. Coagulant and cationic polyacrylamide (dual system) and chitosan were the retention systems. Results show the difficulty of predicting the effect of CNF based on their properties, as fibrillation degree or anionic charge, on the improvement of mechanical properties of recycled paper. That is proved by the low differences in tensile index (TI) improvement (similar to 15% by adding 0.5% C-CNF combined with dual system), obtained with CNF with very different properties. The expensive TEMPO pretreatment could be avoid by applying bleaching pretreatment to the corn pulp, increasing the TI up to 15% without affecting drainage and decoupling the simultaneous deterioration of drainage with TI improvement (drainage time decreased nearly 50% and 20% adding bleached R-CNF and C-CNF, respectively, combined with chitosan). Similar improvements on TI can be achieved by replacing the dual retention system by chitosan without addition of CNF, but the combination of CNF and chitosan allows achieving the highest TI values.
Docta Complutense
Publication Artículo científico (JournalArticle)

Application of cellulose nanofibers to remove water-based flexographic inks from wastewaters

  • Balea Martín, Ana
  • Monte Lara, María Concepción
  • Fuente González, Elena de la
  • Negro Álvarez, Carlos Manuel
  • Blanco Suárez, María Ángeles
Water-based or flexographic inks in paper and plastic industries are more environmentally favourable than organic solvent-based inks. However, their use also creates new challenges because they remain dissolved in water and alter the recycling process. Conventional deinking technologies such as flotation processes do not effectively remove them. Adsorption, coagulation/flocculation, biological and membrane processes are either expensive or have negative health impacts, making the development of alternative methods necessary. Cellulose nanofibers (CNF) are biodegradable, and their structural and mechanical properties are useful for wastewater treatment. TEMPO-oxidised CNF have been evaluated for the decolourisation of wastewaters that contained copper phthalocyanine blue, carbon black and diarlyide yellow pigments. CNF in combination with a cationic polyacrylamide (cPAM) has also been tested. Jar-test methodology was used to evaluate the efficiency of the different treatments and cationic/anionic demand, turbidity and ink concentration in waters were measured. Results show that dual-component system for ink removal has a high potential as an alternative bio-based adsorbent for the removal of water-based inks. In addition, experiments varying CNF and cPAM concentrations were performed to optimise the ink-removal process. Ink concentration reductions of 100%, 87.5% and 83.3% were achieved for copper phthalocyanine blue, carbon black and diarlyide yellow pigments, respectively. Flocculation studies carried out show the decolourisation mechanism during the dual-component treatment of wastewaters containing waterbased inks.
Docta Complutense
Publication Artículo científico (JournalArticle)

Valorization of Corn Stalk by the Production of Cellulose Nanofibers to Improve Recycled Paper Properties

  • Balea Martín, Ana
  • Fuente González, Elena de la
  • Merayo, Noemí
  • Delgado-Aguilar, Marc
  • Mutje, Pere
  • Blanco Suárez, María Ángeles
  • Negro Álvarez, Carlos Manuel
Corn stalk, an agricultural waste, was valorized by the production of cellulose nanofibers (CNF), which were tested for improving recycled paper properties. CNF from eucalyptus kraft pulp (E-CNF) was used as a reference. Addition of 0.5% wt. CNF produced from corn organosolv pulp (C-CNF) to recycled paper increased the tensile index by 20%, whereas the same improvement with E-CNF was achieved at 1.5% wt. Tensile index was further enhanced by increasing the E-CNF, whereas C-CNF achieved its maximum effect at this dose. Different recycled furnish compositions were studied to evaluate C-CNF as a product additive. C-CNF improved tensile strength in all the different recycled furnishes studied. The tensile index improvement caused by C-CNF did not depend on the proportions of old newspaper and old magazine paper used. Addition of C-CNF to recycled corrugated board fluting increased the tensile strength, but to a slightly lower extent than in the case of recycled newsprint paper.
Docta Complutense
Publication Artículo científico (JournalArticle)

Interactions between cellulose nanofibers and retention systems in flocculation of recycled fibers

  • Merayo, Noemi
  • Balea Martín, Ana
  • Fuente González, Elena de la
  • Blanco Suárez, María Ángeles
  • Negro Álvarez, Carlos Manuel
Although the positive effect that cellulose nanofibers (CNF) can have on paper strength is known, their effect on flocculation during papermaking is not well understood, and most relevant studies have been carried out in presence of only cationic starch. Flocculation is the key to ensuring retention of fibers, fines, and fillers, and furthermore floc properties have a great influence on paper quality. The aim of this research is to study the interactions between CNF and flocculants by assessing the effect of two types of CNF, from eucalyptus and corn, on the flocculation process induced by three different retention systems [a dual system, polyvinylamine (PVA), and cationic starch as reference]. The results showed that CNF interacted with the flocculants in different ways, affecting flocculation efficiency and floc properties. In general, addition of CNF increased floc stability and minimized overdosing effects. Moreover, presence of CNF increased floc size for given PVA dose; therefore, CNF addition could contribute to improve the wet end in the paper machine if combined with the optimal flocculant and dose.