Skip to main content

CALIDAD Y REPRODUCIBILIDAD DE LAS DISPERSIONES DE NANOTUBOS DE CARBONO, GRAFENO Y OXIDO DE GRAFENO EN SISTEMAS DE TENSIOACTIVOS

CTQ2015-66575-P

•
Funding agency name Ministerio de Economía y Competitividad
Funding agency acronym MINECO
Program Programa Estatal de Fomento de la Investigación Científica y Técnica de Excelencia
Subprogram Subprograma Estatal de Generación de Conocimiento
Call Proyectos de I+D (Excelencia / Generación de Conocimiento)
Call year 2015
State Plan 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Management unit Secretaría de Estado de Educación, Formación Profesional y Universidades
Beneficiary centre UNIVERSIDAD DE ALCALA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

e_Buah Biblioteca Digital Universidad de Alcalá
Publication Artículo científico (JournalArticle)

Study of graphene dispersions in sodium dodecylsulfate by steady-state fluorescence of pyrene

  • Vera López, María Soledad|||0000-0001-8626-0556
  • Martínez, Patricia
  • San Andrés Lledó, María Paz|||0000-0002-1500-4528
  • Díez Pascual, Ana María|||0000-0001-7405-2354
  • Valiente Martínez, Mercedes|||0000-0002-1059-3925
Hypothesis: Aqueous solutions of ionic surfactants allow the exfoliation of graphene, that can be explained considering the adsorption model of ionic surfactants to hydrophobic surfaces. For many years, pyrene has been used as a fluorescent probe because its sensitivity to the micro-environment. The study of pyrene fluorescence in the presence of different graphene dispersions in an ionic surfactant, would improve the knowledge of the graphene-surfactant interactions.Experiments: Different dispersions of graphene in sodium dodecylsulfate were prepared at different weight ratios 0.5, 1 and 2%. The dispersions have been studied by Raman spectroscopy, scanning electron microscopy and transmission electron microscopy. The influence of the dispersions on the pyrene fluorescence has been investigated.Findings: The graphene sheets modified by the surfactant quench the fluorescence of pyrene, which depends on the amount of graphene, the concentration of surfactant and the weight ratio. For surfactant concentrations below the critical micelle concentration, the quenching effect is higher as the weight ratio increases. Once this concentration is reached, the fluorescence increases slightly and then levels off. This behavior has been explained by the adsorption model. For a constant surfactant concentration, twostraight lines can be observed in the Stern-Volmer plots whose cut-off point is approximately 20 mg L-1 of graphene., Ministerio de Economía y Competitividad, Universidad de Alcalá
e_Buah Biblioteca Digital Universidad de Alcalá
Publication Artículo científico (JournalArticle)

Influence of surfactants of different nature and chain length on the morphology, thermal stability and sheet resistance of graphene

  • Díez Pascual, Ana María|||0000-0001-7405-2354
  • Vallés, Cristina
  • Mateos Medina, María del Rocío
  • Vera López, María Soledad|||0000-0001-8626-0556
  • Kinloch, Ian A.
  • San Andrés Lledó, María Paz|||0000-0002-1500-4528
The effects of surfactants of different nature (anionic, cationic and non-ionic) and chain length on the morphology, microstructure, thermal stability and electrical resistivity of liquid exfoliated graphene (G) were investigated. Microscopic (SEM and AFM) observations revealed that the thickness of G in the dispersions depended on the surfactant nature: non-ionic surfactants rendered the highest level of exfoliation, whilst dispersions in the cationic ones exhibited fully-covered thicker sheets; the flake thickness increased with increasing surfactant chain length. X-ray diffraction studies indicated an increased interlamellar G spacing with increasing surfactant content. Raman spectra showed an increase in the ID/IG ratio with decreasing G loading. Larger upshifts of the G, 2D and D + G bands were found with increasing surfactant concentration, particularly for dispersions in the cationic surfactants. For the same G/surfactant weight ratio, the electrical resistivity of the dispersions followed the order: cationic >non-ionic > anionic, consistent with the amount of surfactant adsorbed onto G calculated via TGA. It is demonstrated herein that the thermal and electrical properties of liquid exfoliated G can be tuned by varying the surfactant concentration, nature and chain length, which is of great importance for numerous applications like solar power harvesting, high-temperature devices and flexible nanoelectronics., Ministerio de Economía y Competitividad
e_Buah Biblioteca Digital Universidad de Alcalá
Publication Artículo científico (JournalArticle)

Dispersive solid phase extraction/ fluorescence analysis of riboflavin using sepiolite as sorbent

  • Mateos Medina, María del Rocío
  • Vera López, María Soledad|||0000-0001-8626-0556
  • Díez Pascual, Ana María|||0000-0001-7405-2354
  • San Andrés Lledó, María Paz|||0000-0002-1500-4528
The use of a natural clay, sepiolite (Sep), and graphene (G)/Sep mixtures as sorbents for the solid phase extraction in dispersive mode (dSPE) with fluorescence detection of a biologically interesting molecule, riboflavin, is reported. The retention of riboflavin by Sep is quantitative with different volumes of the sample and 10?50?mg of the clay. The desorption process has been performed using aqueous solutions of surfactants of different nature: anionic sodium dodecylsulphate (SDS), cationic hexadecyltrimethylammonium chloride (CTAC) and non-ionic polyoxyethylene-23-lauryl eter (Brij L23). The non-ionic surfactant provides the highest riboflavin recoveries; upon optimization of the process, that takes less than half an hour, an extraction yield of 93% was attained using 40?mM Brij L23. The developed method has been applied to the analysis of beer, soya drink and infant milk samples with excellent accuracy (recoveries of 100%) and very good precision, avoiding the interferences of the matrix components that hinder the direct fluorescence analysis of riboflavin., Ministerio de Economía y Competitividad
e_Buah Biblioteca Digital Universidad de Alcalá
Publication Artículo científico (JournalArticle)

Graphene/sepiolite mixtures as dispersive solid-phase extraction sorbents for the anaysis of polycyclic aromatic hydrocarbons in wastewater using surfactant aqueous solutions for desorption

  • Mateos Medina, María del Rocío
  • Vera López, María Soledad|||0000-0001-8626-0556
  • Saz Manzano, Miriam
  • Díez Pascual, Ana María|||0000-0001-7405-2354
  • San Andrés Lledó, María Paz|||0000-0002-1500-4528
tDifferent graphene/sepiolite (G/Sep) solid mixtures have been prepared and tested as nanometric sor-bents for the analysis of polycyclic aromatic hydrocarbons (PAHs) using dispersive solid phase extraction(dSPE) and aqueous solutions of surfactants as environmentally friendly agents for desorption. Quantifi-cation of the PAHs was carried out by reversed-phase liquid chromatography (RP-HPLC) with fluorescencedetection. The adsorption of four PAHs with increasing number of benzene rings into a G/Sep mixture(2/98, w/w) was investigated. A 100% retention was attained for phenanthrene (Phe), pyrene (Pyr) andbenzo(a)pyrene (BaP), while for naphthalene (Nap) the maximum retention was close to 75%. The G/Sepmixtures can be used to remove the PAHs from wastewater. The desorption step was carried out usingan aqueous surfactant solution: 100 mM non-ionic polyoxiethylen-23-lauryl eter (Brij L23). Consideringthe whole extraction process, the highest PAH recoveries (50, 92, 83 and 76% for Nap, Phe, Pyr and BaP,respectively) were obtained using 100 mM Brij L23. The developed method shows very high sensitivity,robustness and precision, as well as low limits of detection and quantification, and has been successfullyapplied to the analysis of PAHs in wastewater samples., Ministerio de Economía y Competitividad
e_Buah Biblioteca Digital Universidad de Alcalá
Publication Artículo científico (JournalArticle)

Impact of recovery correction or subjecting calibrators to sample preparation on measurement uncertainty: PAH determinations in waters

  • Mateos Medina, María del Rocío
  • Oliveira, Cristina
  • Díez Pascual, Ana María|||0000-0001-7405-2354
  • Vera López, María Soledad|||0000-0001-8626-0556
  • San Andrés Lledó, María Paz|||0000-0002-1500-4528
  • Bettencourt da Silva, Ricardo
The decision on the fitness of a measurement for its intended use and the interpretation of an analytical result requires the assessment of the measurement uncertainty. Frequently, the determination of analytes in complex matrices involves demanding sample preparations in which analyte losses are observed. These losses should be considered when reporting the results, which can be corrected for low recovery by taking the mean recovery observed in the analysis of reference items (e.g. spiked samples) or, alternatively, by subjecting calibrators to the same pre-treatment performed on the samples. In these cases, neat (NC) or adjusted (AC) calibrators are used, respectively. The way analyte losses are handled impacts on the measurement uncertainty. The top-down evaluation of the measurement uncertainty involves combining precision, trueness and additional uncertainty components. The trueness component is quantified by pooling various analyte recovery determinations. This work assesses and compares the uncertainty of polycyclic aromatic hydrocarbons (PAHs) measurements in water based on HPLC-FD calibrations with NC or AC. The trueness component is estimated by pooling mean recoveries observed from the analysis of different spiked samples to which mean recovery uncertainty and degrees of freedom are used to estimate a weighted mean recovery and respective uncertainty. The performance of measurements based on NC and AC are associated with equivalent uncertainty except when large analyte losses are observed, namely in the determination of Naphtalene. In this case, the processing of AC reduces the expanded relative uncertainty from 9.9% to 3.5%. The evaluated expanded uncertainty ranged from 3.5% to 12% of the measured value., Ministerio de Economía y Competitividad, Banco Santander, Fundação para a Ciência e Tecnología
e_Buah Biblioteca Digital Universidad de Alcalá
Publication Artículo científico (JournalArticle)

Effect of graphene flakes modified by dispersion in surfactant solutions on the fluorescence behaviour of pyridoxine

  • Mateos Medina, María del Rocío
  • García Zafra, Alba
  • Vera López, María Soledad|||0000-0001-8626-0556
  • San Andrés Lledó, María Paz|||0000-0002-1500-4528
  • Díez Pascual, Ana María|||0000-0001-7405-2354
The influence of graphene (G) dispersions in different types of surfactants (anionic, non-ionic, and cationic) on the fluorescence of vitamin B-6 (pyridoxine) was studied. Scanning electron microscopy (SEM) was used to evaluate the quality of the G dispersions via measuring their flake thickness. The effect of surfactant type and concentration on the fluorescence intensity was analyzed, and fluorescence quenching effects were found for all of the systems. These turn out to be more intense with increasing both surfactant and G concentrations, albeit they do not depend on the G/surfactant weight ratio. For the same G concentration, the magnitude of the quenching follows the order: cationic > non-ionic anionic. The cationic surfactants, which strongly adsorb onto G via electrostatic attraction, are the most effective dispersing agents and they enable a stronger interaction with the zwitterionic form of the vitamin; the dispersing power improves with increasing the surfactant chain length. The fit of the experimental data to the Stern-Volmer equation suggests either a static or dynamic quenching mechanism for the dispersions in non-ionic surfactants, while those in ionic surfactants show a combined mechanism. The results that were obtained herein have been compared to those that were reported earlier for the quenching of another vitamin, riboflavin, to elucidate how the change in the vitamin structure influences the interactions with G in the surfactant dispersions. Keywords, Ministerio de Economia, Industria y Competitividad