Skip to main content

SISTEMAS DE CONDUCCION SEGURA DE VEHICULOS DE TRANSPORTE DE PASAJEROS Y MATERIALES CON ASISTENCIA HAPTICA/AUDIOVISUAL E INTERFACES BIOMEDICAS

DPI2013-42302-R

•
Funding agency name Ministerio de Economía y Competitividad
Funding agency acronym MINECO
Program Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Call Proyectos I+D+i Retos de Investigación
Call year 2013
State Plan 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Management unit Secretaría de Estado de Educación, Formación Profesional y Universidades
Beneficiary centre UNIVERSITAT POLITÈCNICA DE VALÈNCIA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Haptic Feedback to Assist Bus Drivers for Pedestrian Safety at Low Speed

  • Girbés, Vicent
  • Leopoldo Armesto|||0000-0003-0979-4428
  • Dols Ruiz, Juan Francisco|||0000-0003-1815-1360
  • Tornero Montserrat, Josep|||0000-0003-1571-0251
Buses and coaches are massive Passenger Transportation Systems (PTS), because they represent more than half of land PTS in the European Union. Despite of that, bus accident figures are lower than other means of transport, but its size and weight increase the severity of accidents in which buses are involved, even at low speed. In urban scenarios, turnings and manoeuvres around bus stops are the main causes of accidents, mostly due to low visibility, blind spots or driver s distractions. Therefore, there is an increasing interest in developing driving assistance systems to avoid these situations, among others. However, even though there are some solutions on the market, they are not meant to work in urban areas at low speed and with the sole purpose of preventing collisions with pedestrians. In this sense, the paper proposes an active safety system for buses in manoeuvres at low speed. The safety system consists of haptic feedback devices together with collision avoidance and risk evaluation systems based on detected people nearby the bus. The performance of the active safety system has been validated in a simulated urban scenario. Our results show that driver s reaction time is reduced and time to collision increased due to the proposed low-speed active safety system. In particular, it is shown that there is a reduction in the number of high risk cases and collisions, which implies a considerable improvement in safety terms. In addition to this, a brief discussion about current regulations for innovative safety systems on a real vehicles is carried out., This paper has been funded by Ministerio de Ciencia e Innovacion (Spain) through the projects "Sistemas Avanzados de Seguridad Integral en Autobuses (SAFEBUS)" (IPT-2011-1165-370000) and "Sistemas de Conduccion Segura de Vehiculos de Transporte de Pasajeros y Materiales con Asistencia Haptica/Audiovisual e Interfaces Biomedicas (SAFETRANS)" (DPI2013-42302-R). This work was also supported by Programa VALi+d (Generalitat Valenciana). The authors wish to thank Jose Luis Sanchez Carrascosa for his dedication and commitment to the project and thank to Ana Isabel Sanchez Galdon for her valuable help regarding ANOVA analysis.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

An Active Safety System for Low-Speed Bus Braking Assistance

  • Girbés, Vicent
  • Leopoldo Armesto|||0000-0003-0979-4428
  • Dols Ruiz, Juan Francisco|||0000-0003-1815-1360
  • Tornero Montserrat, Josep|||0000-0003-1571-0251
Accidents in which buses or coaches are involved cause thousands of injuries and fatalities every year. To reduce their number and severity, the paper describes an Advanced Driver Assistance Systems (ADAS) based on a haptic throttle pedal and emergency braking. It also proposes a computationally efficient algorithm with a methodology based on three main concepts: a simplified but accurate vehicle model; an efficient collision detection system considering driver's intention and pedestrians wandering around the vehicle; and a risk evaluation system to generate warnings and emergency braking signals. Finally, the performance of the proposed ADAS is validated using a driving simulation cabin with a very realistic urban scenario and original elements from real buses. The results show a statistically significant improvement in safety, as the number of collisions and high risk situations are clearly minimized, reaction time to press the brake pedal is improved and time to collision increased in emergency situations. Implementation of the proposed ADAS into city buses would potentially improve safety, reducing the frequency and severity of accidents with pedestrians., This work was supported in part by Ministry of Science and Innovation of Spain through the SAFEBUS Project "Sistemas Avanzados de Seguridad Integral en Autobuses" under Grant IPT-2011-1165-370000 and the SAFETRANS Project "Sistemas de Conduccion Segura de Vehiculos de Transporte de Pasajeros y Materiales con Asistencia Haptica/Audiovisual e Interfaces Biomedicas" under Grant DPI2013-42302-R and in part by the Generalitat Valenciana, Programa VALi+d (ACIF/2010/206). The Associate Editor for this paper was E. Kosmatopoulos.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Drive Force and Longitudinal Dynamics Estimation in Heavy-Duty Vehicles

  • Girbés, Vicent
  • Hernández, Daniel
  • Leopoldo Armesto|||0000-0003-0979-4428
  • Dols Ruiz, Juan Francisco|||0000-0003-1815-1360
  • Sala, Antonio|||0000-0002-5691-8772
[EN] Modelling the dynamic behaviour of heavy vehicles, such as buses or trucks, can be very useful for driving simulation and training, autonomous driving, crash analysis, etc. However, dynamic modelling of a vehicle is a difficult task because there are many subsystems and signals that affect its behaviour. In addition, it might be hard to combine data because available signals come at different rates, or even some samples might be missed due to disturbances or communication issues. In this paper, we propose a non-invasive data acquisition hardware/software setup to carry out several experiments with an urban bus, in order to collect data from one of the internal communication networks and other embedded systems. Subsequently, non-conventional sampling data fusion using a Kalman filter has been implemented to fuse data gathered from different sources, connected through a wireless network (the vehicle¿s internal CAN bus messages, IMU, GPS, and other sensors placed in pedals). Our results show that the proposed combination of experimental data gathering and multi-rate filtering algorithm allows useful signal estimation for vehicle identification and modelling, even when data samples are missing., This research was funded by the Spanish Ministry of Economy and European Union, grant DPI2016-81002-R, by Generalitat Valenciana, grant APOSTD/2017/055, and by the European Union too through the European Social Fund (ESF). The authors want to acknowledge public transport operators Autos Vallduxense S.L. and EMT Valencia for their support to the project by lending their vehicles and bus drivers. The authors are also thankful to Instituto de Diseño y Fabricación and SAFETRANS project (DPI2013-42302-R) research teams, for lending most of the electronic devices and sensors used in the experimentation.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Robust fulfillment of constraints in robot visual servoing

  • Muñoz-Benavent, Pau|||0000-0003-4681-183X
  • Gracia Calandin, Luis Ignacio|||0000-0001-9258-9286
  • Solanes, J. Ernesto|||0000-0001-5011-4872
  • Esparza Peidro, Alicia|||0000-0002-7471-8686
  • Tornero Montserrat, Josep|||0000-0003-1571-0251
[EN] In this work, an approach based on sliding mode ideas is proposed to satisfy constraints in robot visual servoing. In particular, different types of constraints are defined in order to: fulfill the visibility constraints (camera fieldof-view and occlusions) for the image features of the detected object; to avoid exceeding the joint range limits and maximum joint speeds; and to avoid forbidden areas in the robot workspace. Moreover, another task with low-priority is considered to track the target object. The main advantages of the proposed approach are low computational cost, robustness and fully utilization of the allowed space for the constraints. The applicability and effectiveness of the proposed approach is demonstrated by simulation results for a simple 2D case and a complex 3D case study. Furthermore, the feasibility and robustness of the proposed approach is substantiated by experimental results using a conventional 6R industrial manipulator., This work was supported in part by the Spanish Government under grants BES-2010-038486 and Project DPI2013-42302-R, and the Generalitat Valenciana under grants VALi+d APOSTD/2016/044 and BEST/2017/029.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

PWM and PFM for visual servoing in fully decoupled approaches

  • Muñoz-Benavent, Pau|||0000-0003-4681-183X
  • Solanes, J. Ernesto|||0000-0001-5011-4872
  • Gracia Calandin, Luis Ignacio|||0000-0001-9258-9286
  • Tornero Montserrat, Josep|||0000-0003-1571-0251
In this paper, novel visual servoing techniques based on Pulse Width Modulation (PWM) and Pulse Frequency Modulation (PFM) are presented. In order to apply previous pulse modulations, a fully decoupled position based visual servoing approach (i.e. with block-diagonal interaction matrix) is considered, controlling independently translational and rotational camera motions. These techniques, working at high frequency, could be considered to address the sensor latency problem inherent in visual servoing systems. The expected appearance of ripple due to the concentration of the control action in pulses is quantified and analyzed under simulated scenario. This high frequency ripple does not affect the system performance since it is filtered by the manipulator dynamics. On the contrary it can be seen as a dither signal to minimize the impact of friction and overcome back-lashing., This work was supported in part by the Spanish Government under Grant BES-2010-038486 and Project DPI2013-42302-R.
RUC. Repositorio da Universidade da Coruña
Publication Contribución de congreso (ConferenceOutput)

Aprendizaje por refuerzo con búsqueda de políticas: simulación y aplicación a un sistema electromecánico

  • Pastor, José Manuel
  • Díaz-Iza, Henry
  • Armesto, Leopoldo
  • Sala, Antonio
[Resumen] La búsqueda de políticas (Policy Search) es un subcampo en el aprendizaje por refuerzo altamente extendido en el ámbito de la automática, ya que sus técnicas permiten trabajar con espacios de estados y acción de orden elevado. Este trabajo se centra en los algoritmos existentes de búsqueda de políticas con modelo-libre basados en métodos por gradiente, aplicándolos tanto en sistemas simulados lineales sencillos como a un sistema electromecánico real formado por un p endulo de 1DoF. El propósito de este estudio es analizar comparativamente sus principales características así como ventajas frente a otros, a la hora de ser aplicados en sistemas más complejos., Los autores agradecen al Gobierno de España (DPI2011-27845-C02-01 y DPI2013-42302-R9), a la Generalitat Valenciana (PROMETEOII/2013/004) y al Gobierno de Ecuador (Beca SENESCYT) la financiación recibida para llevar a cabo la investigación aquí presentada, Generalitat Valenciana; PROMETEOII/2013/004, https://doi.org/10.17979/spudc.9788497498081