DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication
Artículo científico (JournalArticle)
Magnetic microwire probes for the magnetic rod interfacial stress rheometer
The magnetic needle interfacial shear rheometer is a valuable tool for the study of the mechanical properties of thin fluid films or monolayers. However, it is difficult to differentiate the interfacial and subphase contributions to the drag on the needle. In principle, the problem can be addressed by decreasing the needle diameter, which decreases the bulk contribution while the interfacial contribution remains essentially the same. Here we show the results obtained when using a new type of needle, that of magnetic microwires with diameter approximately 10 times thinner than for commercial needles. We show that the lower inertia of the microwires calls for a new calibration procedure. We propose such a new calibration procedure based on the flow field solution around the needle introduced in refs 1 and 2. By measuring thin silicone oil films with well-controlled interfacial viscosities as well as eicosanol (C) and pentadecanoic acid (PDA, C) Langmuir monolayers, we show that the new calibration method works well for standard needles as well as for the microwire probes. Moreover, we show that the analysis of the force terms contributing to the force on the needle helps to ascertain whether the measurements obtained are reliable for given surface shear viscosity values. We also show that the microwire probes have at least a 10-fold-lower resolution limit, allowing one to measure interfacial viscosities as low as 10 N·m/s., J.T. acknowledges a grant from UNED’s Researchers Formation Program. M.A.R. and J.M.P. acknowledge partial support from MINECO (grant FIS2013-47350-C5-5-R). F.M.P., F.O., and R.G.R. acknowledge partial support from MINECO (grant FIS2012-38231-C02-01), from E.U. through ITN Cowet, and from a PICATA fellowship of the Moncloa Campus of International Excellence (UCM-UPM).