Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

The graphitization of carbon nanofibers produced by the catalytic decomposition of natural gas

  • García Suárez, Ana Beatriz
  • Cameán Martínez, Ignacio
  • Suelves Laiglesia, Isabel
  • Pinilla Ibarz, José Luis
  • Lázaro Elorri, María Jesús
  • Palacios, J. M.
  • Moliner, R.
Fishbone carbon nanofibers (CNFs) were produced by methane decomposition in a fluidized bed reactor using nickel-copper based catalysts that were prepared with different promoters (SiO<inf>2</inf>, Al<inf>2</inf>O<inf>3</inf>, TiO<inf>2</inf>, MgO). The CNFs were subjected to heat treatment (HT) in the temperature range 2400-2800 °C to explore their ability to graphitize. The influence of treatment temperature and CNF metal content on the structural and textural parameters of the resulting heat treated carbon nanofibers was studied. More-ordering was achieved in CNFs containing Si and Ti because of the catalytic effect of these metals. Since titanium carbide appeared after the HT, the formation of graphitic material by carbide decomposition seems to be a plausible mechanism to explain the catalytic graphitization of the CNFs. A parallel evolution of the structural and textural properties of the nanofibers during HT was found, suggesting that a decrease of the specific surface area is caused by the removal of structural defects and an increase of crystallite size. © 2009 Elsevier Ltd. All rights reserved., Financial support from the Spanish Ministry of Science and Innovation MICINN (under Projects MAT2004-01094 and ENE2008-06516) is gratefully acknowledged. I. Cameán thanks MICINN for a personal grant to develop the work., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Graphitized boron-doped carbon foams: Performance as anodes in lithium-ion batteries

  • Rodríguez Vázquez, Elena
  • Cameán Martínez, Ignacio
  • García Fernández, Roberto
  • García Suárez, Ana Beatriz
The electrochemical performance as potential anodes in lithium-ion batteries of several boron-doped and non-doped graphitic foams with different degree of structural order was investigated by galvanostatic cycling. The boron-doped foams were prepared by the co-pyrolysis of a coal and two boron sources (boron oxide and a borane-pyridine complex), followed by heat treatment in the 2400-2800 °C temperature interval. The extent of the graphitization process of the carbon foams depends on boron concentration and source. Because of the catalytic effect of boron, lightweight graphite-like foams were prepared. Boron in the foams was found to be present as carbide (B<inf>4</inf>C), in substitutional positions in the carbon lattice (B-C), bonded to nitrogen (B-N) and forming clusters. Larger reversible lithium storage capacities with values up to ∼310 mA h g<sup>-1</sup> were achieved by using the boron oxide-based carbon foams. Moreover, since the electrochemical anodic performance of these boron-doped foams with different degree of structural order is similar, the beneficial effect of the presence of the B-C boron phase was inferred. However, the bonding of boron with nitrogen in the pyridine borane-based has a negative effect on lithium intercalation. © 2011 Elsevier Ltd. All rights reserved., Financial support from the Spanish Ministry of Science and Innovation MICINN (under Projects MAT2004-01094 and MAT2005-04658), and FICYT (under Project PC07-014) is gratefully acknowledged. E. Rodríguez and I. Cameán thanks MICINN for a contract and a personal grant, respectively, to develop the work., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

On the electrochemical performance of anthracite-based graphite materials as anodes in lithium-ion batteries

  • Cameán Martínez, Ignacio
  • Lavela, Pedro
  • Tirado, José L.
  • García Suárez, Ana Beatriz
The electrochemical performance as potential negative electrode in lithium-ion batteries of graphite materials that were prepared from two Spanish anthracites of different characteristics by heat treatment in the temperature interval 2400-2800 °C are investigated by galvanostatic cycling. The interlayer spacing, d<inf>002</inf>, and crystallite sizes along the c axis, L<inf>c</inf>, and the a axis, L<inf>a</inf>, calculated from X-ray diffractometry (XRD) as well as the relative intensity of the Raman D-band, I<inf>D</inf>/I<inf>t</inf>, are used to assess the degree of structural order of the graphite materials. The galvanostatic cycling are carried out in the 2.1-0.003 V potential range at a constant current and C/10 rate during 50 cycles versus Li/Li<sup>+</sup>. Larger reversible lithium storage capacities are obtained from those anthracite-based graphite materials with higher structural order and crystal orientation. Reasonably good linear correlations were attained between the electrode reversible charge and the materials XRD and Raman crystal parameters. The graphite materials prepared show excellent cyclability as well as low irreversible charge; the reversible capacity being up to ∼250 mA h g<sup>-1</sup>. From this study, the utilization of anthracite-based graphite materials as negative electrode in lithium-ion batteries appears feasible. Nevertheless, additional work should be done to improve the structural order of the graphite materials prepared and therefore, the reversible capacity. © 2009 Elsevier Ltd. All rights reserved., Financial support from the Spanish Ministry of Science and Innovation MICINN (under Project MAT2004-01094), and FICYT (under Project PC07-014)) is gratefully acknowledged. I. Cameán thanks MICINN for a personal grant to develop the work., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

The graphitization of carbon nanofibers produced by catalytic decomposition of methane: Synergetic effect of the inherent Ni and Si

  • García Suárez, Ana Beatriz
  • Cameán Martínez, Ignacio
  • Pinilla Ibarz, José Luis
  • Suelves Laiglesia, Isabel
  • Lázaro Elorri, María Jesús
  • Moliner, Rafael
The catalytic effect of the inherent Ni and Si on the graphitization of carbon nanofibers produced by catalytic decomposition of methane is reported. The participation of the inherent Ni and Si metals as co-catalysts in the graphitization of the carbon nanofibers through the formation of Ni <inf>2</inf>Si and SiC was inferred. Taking advantage of this catalytic effect, graphite materials showing structural characteristics comparable to oil-derived graphites which are employed in several industrial applications have been prepared from the carbon nanofibers. Unlike SiC which is further descomposed to graphite, the role of Ni<inf>2</inf>Si remains unclear. At the CNFs heat treatment temperatures employed, Ni<inf>2</inf>Si is in a liquid state where the carbon can be dissolved to form a supersaturated solution from which the SiC can be produced by segregation, thus being an intermediate stage in the catalytic graphitization of the carbon nanofibers. Further work are currently in progress to go insight this issue. © 2010 Elsevier Ltd. All rights reserved., Financial support from the Spanish Ministry of Science and Innovation (under Projects MAT2004-01094 and ENE2008-06516) is gratefully acknowledged. I. Cameán thanks MCINN for a personal grant to develop the work., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Graphite materials prepared by HTT of unburned carbon from coal combustion fly ashes: Performance as anodes in lithium-ion batteries

  • Cameán Martínez, Ignacio
  • García Suárez, Ana Beatriz
The behaviour as the potential negative electrode in lithium-ion batteries of graphite-like materials that were prepared by high temperature treatment of unburned carbon concentrates from coal combustion fly ashes was investigated by galvanostatic cycling. Emphasis was placed on the relation between the structural/morphological and electrochemical characteristics of the materials. In addition, since good electrode capacity retention on cycling is an important requirement for the manufacturing of the lithium-ion batteries, the reversible capacity provided by the materials prepared on prolonged cycling (50 cycles) was studied and the results were compared with those of petroleum-based graphite which is commercialized as anodic material for lithium-ion batteries. The graphite-like materials prepared lead to battery reversible capacities up to ∼310 mA hg<sup>-1</sup> after 50 cycles, these values were similar to those of the reference graphite. Moreover, they showed a remarkable stable capacity along cycling and low irreversible capacity. Apparently, both the high degree of crystallinity and the irregular particle shape with no flakes appear to contribute to the good anodic performance in lithium-ion batteries of these materials, thus making feasible their utilization to this end. © 2011 Elsevier B.V. All rights reserved., Financial support from the Spanish Ministry of Science and Innovation MICINN (Under Projects MAT2004-01094), and FICYT (Under Project PC07-014) is gratefully acknowledged. I. Cameán thanks MICINN for a personal grant to develop the work., Peer reviewed