Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

Investigo. Repositorio Institucional de la Universidade de Vigo
Publication Artículo científico (JournalArticle)

Dual-Band class J power amplifier at 2.45 and 5.8 GHz for UAVs communications

  • Morales Fernandez, Ainhoa
  • Fernández Barciela, Mónica
  • Isasi De Vicente, Fernando Guillermo
  • Martín Rodríguez, Fernando
  • Tasker, Paul J.
A hybrid dual-band power amplifier (PA) prototype working at two Industrial, Scientific and Medical (ISM) bands, 2.4-2.5 GHz and 5.725-5.875 GHz, was designed for Unmanned Aerial Vehicles (UAVs) communication applications in Spain. Initially, two single-band PA prototypes centered at each band were designed to evaluate the single-band achievable RF performance. In all the PAs, the Gallium Nitride (GaN) Qorvo HEMT TGF2977-SM was used, as well as microstrip transmission lines technology. To achieve wideband, good linearity and efficiency, the PAs were designed in class J. The measured results for the dual-band PA prototype at the 2dB compression point at the lower and higher bands, respectively, are 14.8 dB and 11.2 dB of Transducer Power Gain ( GT ), 35.7 dBm and 34.8 dBm of RF output power (Pout) and 59.2% and 43.5% of Drain Efficiency ( η ). At 3dB compression the respective lower and higher bands results are 37.9 dBm and 37 dBm of Pout and 73.9% and 55% of η ., Agencia Estatal de Investigación | Ref. TEC2017-88242-C3-2-R, Agencia Estatal de Investigación | Ref. PID2020-116569RB-C33
Investigo. Repositorio Institucional de la Universidade de Vigo
Publication Contribución de congreso (ConferenceOutput)

Extracción de modelos comportamentales para transistores de alta frecuencia

  • Martín Rodríguez, Fernando
  • Moure Fernández, María del Rocío
  • Morales Fernandez, Ainhoa
  • Fernández Barciela, Mónica
  • Tasker, Paul J.
This communication describes the software tools developed in MATLAB environment to extract behavioral models for microwave transistors from RF calibrated experimental data (Load-Pull measurements). These tools are designed to extract both linear and nonlinear frequency domain models. Linear models are limited to a single impedance and small signal operation. In the linear case, small-signal S, Y and Z parameters are computed. Extracted nonlinear models are based on Cardiff model formulations: Cardiff conventional A-B model, Cardiff Admittance I-V model and Cardiff advanced formulations. Auxiliary apps have been designed to import calibrated measurement data and also for drawing test graphs to evaluate models extraction. Finally, another type of model has been explored: artificial neural networks based models. Hence, another MATLAB tool has been designed for training shallow neural networks (a Multi-Layer Perceptron, MLP; with one hidden layer trained for approximate fitting). A quality FoM (SNR) is computed comparing measurements with model predictions for all extracted models obtaining good results for all methods and allowing a comparison between them., Agencia Estatal de Investigación | Ref. PID2020- 116569RB-C33
Investigo. Repositorio Institucional de la Universidade de Vigo
Publication Contribución de congreso (ConferenceOutput)

Cardiff behavioral model analysis for frequency doubler design

  • Morales Fernandez, Ainhoa
  • Martín Rodríguez, Fernando
  • Moure Fernández, María del Rocío
  • Fernández Barciela, Mónica
  • Bogusz, Aleksander
  • Tasker, Paul J.
The Cardiff behavioral model is a robust nonlinear tool for guiding nonlinear circuit design. This paper proposes a methodology to generate Cardiff AB models suitable for microwave frequency doubler optimization. Active Load-Pull data from both measurement and simulations are processed through a self-developed MATLAB application to extract and evaluate Cardiff AB models formulated with different mixing orders and number of parameters. Moreover, the role of harmonic source and load impedances in model extraction for frequency doubler design space prediction is studied., Universidade de Vigo, Agencia Estatal de Investigación | Ref. PID2020-116569RB-C33
Investigo. Repositorio Institucional de la Universidade de Vigo
Publication Artículo científico (JournalArticle)

GaN HEMT-based frequency quadrupler up-converting from s band to x band with conversion gain in narrowband

  • Morales Fernandez, Ainhoa
  • Marante Boado, Maria
  • Fernández Barciela, Mónica
  • Martín Rodríguez, Fernando
This work presents the first design of an active frequency quadrupler based on GaN HEMTs. It is based on two cascaded frequency doubler stages that allow up-conversion from the S band to the X band, obtaining conversion gain in narrowband without the need for any additional buffer amplifier. A hybrid prototype of the quadrupler provides, at the input fundamental frequency of 2.5 GHz, a measuredfourthharmonic maximum conversion gain of 13.7 dB and an output power of 23.5 dBm, with suppression of both fundamental andsecondharmonic above 14 dBc. To obtain these results, due to its impact in the final quadrupler behavior, a prototype of the higher frequency second stage doubler was designed and manufactured separately to assess its RF performance. The experimental results of this standalone prototype are highly competitive with the current state of the art in frequency doublers at the C band., Agencia Estatal de Investigación | Ref. PID2020-116569RB-C33, Agencia Estatal de Investigación | Ref. PID2023-147653OB-C33
Investigo. Repositorio Institucional de la Universidade de Vigo
Publication Artículo científico (JournalArticle)

Evaluation of admittance domain behavioural model complexity requirements for Power Amplifier design

  • Moure Fernández, María del Rocío
  • Casbon, Michael
  • Ladero Canle, Nicolás
  • Fernández Barciela, Mónica
  • Tasker, Paul J.
In the framework of Power Amplifier (PA) design for communications, frequency domain non-linear behavioural models have shown their potential as efficient complementary modelling tools when Field Effect Transistor compact models are not available or sufficiently accurate. The Admittance behavioural model, formulated in the V-I domain, is especially suitable for device size and fundamental frequency scaling. It is important to note that the direct extraction of this model, from the Nonlinear Vector Network Analyser (NVNA) load-pull (LP) measurements, requires some extra processing since it necessitates a Look-up-Table indexed to |V11| rather than |A11|. When using such models in PA design, there is the need for the user to select the necessary model complexity. To address this requirement, in this paper, a systematic analysis methodology, to guide the user, is presented and validated in different PA design scenarios. The methodology was tested using NVNA LP measurements of GaN Heterostructure FETs. A fifth order Admittance model formulation showed good accuracy in the studied PA design scenarios., Agencia Estatal de Investigación | Ref. TEC2017‐88242‐C3‐2‐R, Xunta de Galicia and European Regional Development Fund - ERDF| Ref. "Centro singular de investigación de Galicia accreditation 2019-2022, atlanTTic", Agencia Estatal de Investigación | Ref. PID2020-116569RB-C33
Investigo. Repositorio Institucional de la Universidade de Vigo
Publication Contribución de congreso (ConferenceOutput)

Diseño de un amplificador híbrido equilibrado usando acopladores basados en “space-filling curves”

  • Guillerme, Rodríguez Varela
  • Morales Fernandez, Ainhoa
  • Fernández Barciela, Mónica
  • Martín Rodríguez, Fernando
This communication outlines the design of a hybrid Power Amplifier (PA), suitable for load modulation, optimized for applications at a frequency of 3.5 GHz, specifically targeting communications with Unmanned Aerial Vehicles (UAVs). The design utilizes a Gallium Nitride High Electron Mobility Transistor (GaN-HEMT), chosen for its superior power and efficiency, a crucial factor for onboard embedded applications. It relies on a Balanced Amplifier (BA) configuration, which combines two single PA’s, and “space-filling curves” based couplers to enhance power while minimizing signal reflections. The circuit can operate as a conventional BA or as a LoadModulated Balanced Amplifier (LMBA). The designed circuit was fabricated and measured. It was obtained at P2dB a measured output power of 34.5 dBm, a power gain of 15 dB, and a drain efficiency close to 40%., Agencia Estatal de Investigación | Ref. PID2020-116569RB-C33, Agencia Estatal de Investigación | Ref. PID2023-147653OB-C33