Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Modeling High-Efficiency Quantum Dot Sensitized Solar Cells

  • González-Pedro, Victoria|||0000-0002-8133-5958
  • Bisquert, Juan|||0000-0003-4987-4887
  • Xu, Xuequing
  • Mora-Sero, Iván
[EN] With energy conversion efficiencies in continuous growth, quantum dot sensitized solar cells (QDSCs) are currently under an increasing interest, but there is an absence of a complete model for these devices. Here, we compile the latest developments in this kind of cells in order to attain high efficiency QDSCs, modeling the performance. CdSe QDs have been grown directly on a TiO(2) surface by successive ionic layer adsorption and reaction to ensure high QD loading. ZnS coating and previous growth of OS were analyzed. Polysulfide electrolyte and Cu(2)S counterelectrodes were used to provide higher photocurrents and fill factors, FF. Incident photon-to-current efficiency peaks as high as 82%, under full 1 sun illumination, were obtained, which practically overcomes the photocurrent limitation commonly observed in QDSCs. High power conversion efficiency of up to 3.84% under full 1 sun illumination (V(oc) = 0.538 V, j(sc) = 13.9 mA/cm(2), FF = 0.51) and the characterization and modeling carried out indicate that recombination has to be overcome for further improvement of QDSC., This work was supported by the Ministerio de Ciencia e Innovacion of Spain under the projects HOPE C5D2007-00007, JES-NANOSOLAR PLE2009-0042, and MAT2007-62982, and by Generalitat Valenciana under the project PROME-TEO/2009/058. The authors want to acknowledge S. Gimenez for the TEM measurements and the calculation of expected currents from IPCE, A. Braga for the preparation of CdS sensitized substrates, and also the SCIC of University Jaume I (Spain) for providing the microscopy facilities.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Interfacial engineering of quantum dot-sensitized TiO2 fibrous electrodes for futuristic photoanodes in photovoltaic applications

  • Sudhagar, P.
  • González-Pedro, Victoria
  • Mora-Sero, Iván
  • Fabregat-Santiago, Francisco
  • Kang, Yong Soo
  • Bisquert, Juan|||0000-0003-4987-4887
[EN] Herein we report generic surface treatment approaches to improve the electronic interfaces of quantum dot-sensitized TiO2 fiber electrodes, thereby promoting their photoanode performance. Highly dense, continuous and nanostructured TiO2 fibrous membranes, without the inclusion of a scattering layer, unlike conventional TiO2 particulate electrodes, showed feasible photoconversion performance under the proposed interfacial engineering modification. The proposed interfacial treatment concerns fibrous membranes both before and after calcination. The chemical vapor pre-treatment on an as-deposited fibrous membrane using tetrahydrofuran (THF) reinforces the physical contact between the fibrous membrane and the transparent conducting substrate and reduces significantly the recombination rate. In the case of post-treatment by F-ion on a fibrous surface, together with the interfacial engineering approach, the ZnS surface passivation layer markedly improves the photoanode performance of the TiO2 fibrous membrane nearly to a factor of 3.2% with a remarkable open-circuit voltage V-oc = 0.69 V and J(sc) = 13 mA cm(-2) under 1 sun illumination (100 mW cm(-2)). This report provides an excellent platform for studying and understanding the interfacial contacts and mechanisms related to the charge transfer at CdS/CdSe QD-sensitized TiO2 fibrous assemblies. Such implications of this interfacial treatment strategy can be successfully extended to a wide range of photoanode candidates in energy conversion systems and confirm the effectiveness of some alternative nanostructured electrodes for the development of semiconductor-sensitized solar cells., This work was supported by the Engineering Research Center Program through a National Research Foundation of Korea (NRF) grant funded by the Ministry of Education, Science and Technology (MEST) (no. 2012-0000591) and also by the World Class University (WCU) program (no. R31-2008-000-10092), the Ministerio de Educacion y Ciencia of Spain under the project HOPE CSD2007-00007 (Consolider-Ingenio 2010) JES-NANOSOLAR PLE2009-0042, MAT 2010-19827 and by Generalitat Valenciana under project PROMETEO/2009/058.