Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

Recercat. Dipósit de la Recerca de Catalunya
Publication Contribución de congreso (ConferenceOutput)

Frequency-based detection of replay attacks: application to a quadrotor UAV

  • Sánchez Corrales, Helem Sabina
  • Rotondo, Damiano
  • Lopez Vidal, Marc
  • Quevedo Casín, Joseba Jokin
© 2019 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works., Unmanned aerial vehicles (UAVs) are reported to be highly exposed as possible targets of cyber attacks, due to their strong strategic and economic value, and their increasing use in a wide range of operations. Among the most critical cyber attacks, replay attacks are performed by replacing the real data coming from the sensors with previously recorded data. In this way, the attacker may provoke performance degradation, cause instability, and allow to perform undetectable physical attacks. The main contribution of this paper is to investigate the applicability of a frequency-based detection method, which uses a sine wave with time-varying frequency as authentication signal, to a UAV affected by replay attacks. The effectiveness of the method is illustrated through simulation scenarios., Peer Reviewed, Postprint (author's final draft)
Recercat. Dipósit de la Recerca de Catalunya
Publication Contribución de congreso (ConferenceOutput)

Input design for active detection of integrity attacks using set-based approach

  • Trapiello Fernández, Carlos
  • Puig Cayuela, Vicenç
© 2020. The Authors, This paper presents the design of an input sequence in order to actively guarantee detectabilityof integrity attacks. The design of the input sequence is formulated as an optimization problemwhere the performance degradation imposed in the protected system is minimized whileguaranteeing attack detectability by separating the reachable sets of the system in healthyand attacked operation. By considering uncertainties bounded by zonotopes, the design of anoptimal open-loop input sequence such that guarantee the separability of the reachable zonotopicsets can be computed by solving a Mixed Integer Quadratic Program (MIQP). Following thisapproach, attack detection can be guaranteed by: I) forcing a distinct behavior of the systemoutputs; II) ensuring that residuals under attack will exit the healthy residual set. Furthermore,the present work also considers the imposition of residuals detectability for the specific replayattack scenario affecting an state estimate control system. The effectiveness of the proposals isvalidated in simulation by means of a numerical example., This work has been partially funded by AGAUR ACCIO RIS3CAT UTILITIES 4.0 – P7 SECUTIL, Peer Reviewed, Postprint (author's final draft)
Recercat. Dipósit de la Recerca de Catalunya
Publication Contribución de congreso (ConferenceOutput)

System reconfiguration of large-scale control systems using back-up actuators

  • Trapiello Fernández, Carlos
  • Puig Cayuela, Vicenç
  • Cembrano Gennari, Gabriela
© 2020 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works., The intrinsic redundancy of large-scale control systems allows to differentiate between the nominal system configuration, where the dynamics of the plant are controlled through a specific subset of actuators, and the possible configurations that arise from the combination of all the existing actuators (nominal plus back-up ones). After the occurrence of an unexpected event (component fault, isolation of a specific area due to security concerns, etc), some of the back-up system actuators can be used in order to guarantee that the system performance will remain within some admissible margins. Thus, given a scenario that causes a non-admissible system operation with the nominal configuration, the possibility to use back-up actuators in order to improve the system performance expands the traditional fault tolerant control scenario defining a new problem. Accordingly, this work is devoted to the introduction of the problem which is solved by formulating the actuator selection as a mixed-integer programming optimization. A water distribution network is used with the aim to illustrate the new problem implications as well as to demonstrate the validity of the proposed solution., This work has been partially funded by AGAUR ACCIO RIS3CAT UTILITIES 4.0 – P7 SECUTIL and by SMART Project (ref. num. EFA153/16Interreg Cooperation Program POCTEFA 2014-2020), Peer Reviewed, Postprint (author's final draft)
Recercat. Dipósit de la Recerca de Catalunya
Publication Contribución de congreso (ConferenceOutput)

Input design for active dectection of integrity attacks using set-based approach

  • Trapiello Fernández, Carlos
  • Puig Cayuela, Vicenç
This paper presents the design of an input sequence in order to actively guarantee detectability of integrity attacks. The design of the input sequence is formulated as an optimization problemwhere the performance degradation imposed in the protected system is minimized while guaranteeing attack detectability by separating the reachable sets of the system in healthy and attacked operation. By considering uncertainties bounded by zonotopes, the design of anoptimal open-loop input sequence such that guarantee the separability of the reachable zonotopicsets can be computed by solving a Mixed Integer Quadratic Program (MIQP). Following thisapproach, attack detection can be guaranteed by: I) forcing a distinct behavior of the systemoutputs; II) ensuring that residuals under attack will exit the healthy residual set. Furthermore, the present work also considers the imposition of residuals detectability for the specific replay attack scenario affecting an state estimate control system. The effectiveness of the proposals is validated in simulation by means of a numerical example., This work has been partially funded by AGAUR ACCIO RIS3CATUTILITIES 4.0 – P7 SECUTIL, Peer Reviewed, Postprint (author's final draft)
Recercat. Dipósit de la Recerca de Catalunya
Publication Contribución de congreso (ConferenceOutput)

Detection of replay attacks in CPSs using observer-based signature compensation

  • Trapiello Fernández, Carlos
  • Rotondo, Damiano
  • Sánchez Corrales, Helem Sabina
  • Puig Cayuela, Vicenç
© 2019 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works., This paper presents a replay attack detection method that addresses the performance loss of watermarking-based approaches. The proposed method injects a sinusoidal signal that affects a subset, chosen at random, of the system outputs. The presence of the signal in each one of the outputs is estimated by means of independent observers and its effect is compensated in the control loop. When a system output is affected by a replay attack, the loss of feedback of the associated observer destabilizes the signal estimation, leading to an exponential increase of the estimation error up to a threshold, above which the estimated signal compensation in the control loop is disabled. This event triggers the detection of a replay attack over the output corresponding to the disrupted observer. The effectiveness of the method is demonstrated using results obtained with a quadruple-tank system simulator., Peer Reviewed, Postprint (author's final draft)
Recercat. Dipósit de la Recerca de Catalunya
Publication Contribución de congreso (ConferenceOutput)

Replay attack detection using a zonotopic KF and LQ approach

  • Trapiello Fernández, Carlos
  • Puig Cayuela, Vicenç
© 2020 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works., This paper exploits the analogy between the stochastic and zonotopic Kalman filters with the aim of formulating a metric that allows to assess the impact of an external zonotopically bounded signal in an state estimate optimal control scheme. To that end, the concept of linear quadratic zonotopic (LQZ) controller is introduced. Besides, the design of a zonotopically bounded watermarking signal such that enforces replay attack detectability is also addressed. The proposed detection scheme takes advantage of the observability loss of an textit{a priori} known exogenous signal during the replay phase of the attack. Consequently, by injecting the corresponding estimation error generated by a set-based observer, a zonotopically bounded signal such that imposes replay attack detectability is achieved. A numerical example is provided., This work has been partially funded by AGAUR ACCIO RIS3CAT UTILITIES 4.0 – P7 SECUTIL and by SMART Project (ref. num. EFA153/16Interreg Cooperation Program POCTEFA 2014-2020)., Peer Reviewed, Postprint (author's final draft)