Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Nanocomposite SPEEK-based membranes for Direct Methanol Fuel Cells at intermediate temperatures

  • Mollá Romano, Sergio
  • Compañ Moreno, Vicente|||0000-0001-8233-7472
Novel nanocomposite membranes were prepared by infiltration of a blend of sulfonated PEEK (SPEEK) with polyvinyl alcohol (PVA), using water as solvent, into electrospun nanolibers of SPEEK blended with polyvinyl butyral (PVB). The membranes were characterized for their application on Direct Methanol Fuel Cells (DMFCs) operating at moderate temperatures (>80 degrees C). An important role of the solvent on the crosslinking temperature for the SPEEK-PVA system was observed. A mat of hydrated SPEEK-30%PVB nanofibers revealed higher proton conductivity in comparison with a dense membrane of similar composition. Incorporation of the nanoliber mats to the SPEEK-35%PVA matrix provided mechanical stability, methanol barrier properties and certain proton conductivity up to a crosslinking temperature of 120 degrees C. Not remarkable effect of the nanofibers was found above that crosslinking temperature. The combined effect of the nanofibers and crosslinking temperature on the properties of the membranes is discussed. DIV1FC performance experiments concluded promising results for this new low-cost type of membranes, although further optimization steps are still required., This research has been funded by the R&D Support Programmes of the Polytechnic University of Valencia (project 24761) and the Spanish Ministry of Science and Innovation (project SP-ENE-20120718).
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Modification of Nafion Membranes with Polyaniline to Reduce Methanol Permeability

  • Gonzalez-Ausejo, J.
  • Cabedo Mas, Luis
  • Gámez-Pérez, J.
  • Mollá Romano, Sergio
  • Giménez Torres, Enrique|||0000-0002-6330-0209
  • Compañ Moreno, Vicente|||0000-0001-8233-7472
The modification of Nafion membranes with polyaniline (PAni) has been studied as an alternative for reducing methanol crossover in direct methanol fuel cells (DMFC). The modification has been performed by directly polymerizing the PAni following two different routes: immersion (Naf-S-Y, where S mean surface and Y the number of hours exposition) and crossover (Naf-C-Y, where C means crossover). The former consist of exposing the membranes to a reactive solution containing the aniline, oxidant and catalyst; while in the latter the aniline and a solution with the oxidant and the catalyst are in different chambers separated by the membrane, thus forcing them to react inside it. The effect of the modification mechanism and the reaction times has been studied. The resulting membranes were extensively characterized by means of Fourier Transform Infrared (FTIR), ionic exchange capacity (IEC), water uptake (WU), methanol permeability and single direct methanol fuel cell performance. Chemical characterization revealed that the oxidation state of the polyaniline was in all cases emeraldine and the amount of PAni for an equivalent exposure time was bigger for the crossover route. The crossover route has proven to be more effective in decreasing the apparent methanol permeability of Nafion modified membranes up to 48% for the crossover sample with higher modification time when the polymerization is due inside the membrane such is the case of the composite Naf-C-Y membranes. The Direct Methanol Fuel Cells performances of membrane-electrode assemblies prepared with pristine Nafion and Nafion-PAni membranes were tested at 40, 60 and 80 degrees C under 2 M methanol concentration. The results are compared with those found for Nafion pristine membranes which power densities were 90, 65, 60 and 50 mW/cm(2) at 80 degrees C for Nafion, Naf-S-1, Naf-S-5 and Naf-C-2, membranes respectively., This research is in the frame of Support Program for Research and Development of the Polytechnic University of Valencia and the Ministry of Science and Innovation for funding provided through the projects: SP-ENE-20120718 and 24761, respectively.