Skip to main content

NANOESTRUCTURAS NITRUROS DEL GRUPO III PARA APLICACIONES FOTOVOLTAICAS

TEC2014-60483-R

•
Funding agency name Ministerio de Economía y Competitividad
Funding agency acronym MINECO
Program Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Call Proyectos I+D+i Retos de Investigación
Call year 2014
State Plan 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Management unit Secretaría de Estado de Educación, Formación Profesional y Universidades
Beneficiary centre UNIVERSIDAD DE ALCALA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Influence of the AlN interlayer thickness on the photovoltaic properties of in-rich AlInN on Si heterojunctions deposited by RF sputtering

  • Valdueza-Felip, S.
  • Núñez-Cascajero, A.
  • Blasco, R.
  • Montero, D.
  • Grenet, L.
  • Mata, M. de la
  • Fernández, S.
  • Rodríguez de Marcos, Luís
  • Molina, S.I.
  • Olea, J.
  • Naranjo, Fernando B.
8 pags., 5 figs., 1 tab., We report the influence of the AlN interlayer thickness (0-15 nm) on the photovoltaic properties of AlInN on Si heterojunction solar cells deposited by radio frequency sputtering. The poor junction band alignment and the presence of a 2-3 nm thick amorphous layer at the interface mitigates the response in devices fabricated by direct deposition of n-AlInN on p-Si(111). Adding a 4-nm-thick AlN buffer layer improves the AlInN crystalline quality and the interface alignment leading to devices with a conversion efficiency of 1.5% under 1-sun AM1.5G illumination. For thicker buffers the performance lessens due to inefficient tunnel transport through the AlN. These results demonstrate the feasibility of using In-rich AlInN alloys deposited by radio frequency sputtering as novel electron-selective contacts to Si-heterojunction solar cells., Support from projects NitPho (TEC2014-60483-R), ANOMALOS (TEC2015- 71127-C2-2-R), INFRASIL (TEC 2013-41730-R), SINFOTON (S2013/MIT 2790), MADRID-PV (2013/MAE-2780), PhotoAl (CCG2015/EXP-014), PAI research group (TEP-946 INNANOMAT), and FEDER-EU is acknowledged. TEM data were taken at DME-SC-ICyT-UCA. A. Nuñez- ˜ Cascajero thanks her grant to the University of Alcala and D. Montero acknowledges his contract ´ BES-2014-067585.
e_Buah Biblioteca Digital Universidad de Alcalá
Publication Artículo científico (JournalArticle)

Quality improvement of AlInN/p-Si heterojunctions with AlN buffer layer deposited by RF-sputtering

  • Núñez Cascajero, Arántzazu
  • Valdueza Felip, Sirona|||0000-0003-1817-5354
  • Blasco Chicano, Rodrigo
  • Mata Fernández, María de la
  • Molina Rubio, Sergio Ignacio
  • González Herráez, Miguel|||0000-0003-2555-2971
  • Monroy, Eva
  • Naranjo Vega, Fernando Bernabé|||0000-0002-2119-6749
The effect of an AlN buffer layer thickness on the structural, morphological and optical properties of n- Al0.37In0.63N deposited on p-Si (111) by radio-frequency sputtering was studied. The AlN/ Al0.37In0.63N samples were structurally characterized via X-ray diffraction and high-resolution transmission electron microscopy showing that all layers present wurtzite structure highly oriented along the c-axis with no phase separation. All the samples present compact morphology with root-mean-square surface roughness below 1.7 nm and low-temperature photoluminescence emission centered at 1.8 eV. The presence of the buffer layer leads to an improvement of the structural quality, evidenced by a reduction of the full width at half maximum of the rocking curve around the (0002) AlInN reflection from 8° to 5°. Selected samples were processed and tested as solar cells showing a good rectifying behavior in the dark and an open circuit voltage of 0.35 V, a short circuit current density of 22.2 mA/cm2 and fill factor of 20% under 1 sun AM1.5G illumination., Ministerio de Economía y Competitividad, Comunidad de Madrid, Universidad de Alcalá