Pasar al contenido principal

SENSORES FOTONICOS PARA SEGURIDAD Y PROTECCION

TEC2016-76021-C2-1-R

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos I+D+i Retos de Investigación
Año convocatoria 2016
Plan Estatal 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSIDAD PUBLICA DE NAVARRA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Effects of pump pulse extinction ratio in Brillouin optical time-domain analysis sensors

  • Iribas Pardo, Haritz
  • Mariñelarena Ollacarizqueta, Jon
  • Feng, Cheng
  • Urricelqui Polvorinos, Javier
  • Schneider, Thomas
  • Loayssa Lara, Alayn
We report on two previously unknown non-local effects that have been found to impair Brillouin optical time-domain analysis (BOTDA) sensors that deploy limited extinction ratio (ER) pump pulses. The first one originates in the increased depletion of the pedestal of the pump pulses by the amplified probe wave, which in turn entails a reduced amplification of the probe and a measurement distortion. The second effect is due to the interplay between the transient response of the erbium-doped fiber amplifiers (EDFA) that are normally deployed to amplify the pump and the pedestal of the pump pulses. The EDFA amplification modifies the pedestal that follows the pulses in such a way that it also leads to a distortion of the measured gain spectra after normalization. Both effects are shown to lead to non-local effects in the measurements that have similar characteristics to those induced by pump pulse depletion. In fact, the total depletion factor for calculations of the Brillouin frequency shift (BFS) error in BOTDA sensors is shown to be the addition of the depletion factors linked to the pump pulse as well as the pedestal. A theoretical model is developed to analyze both effects by numerical simulation. Furthermore, the effects are investigated experimentally in long-range BOTDA sensors. The pedestal depletion effect is shown to severely constrain the probe power as well as the minimum ER of the pulses that can be deployed in BOTDA sensors. For instance, it is shown that, in a long-range dual-probe BOTDA, an ER higher that 32-dB, which is above that provided by standard electro-optic modulators (EOM), is necessary to be able to deploy a probe power of -3 dBm, which is the theoretical limit for that type of sensors. Even more severe can be the limitation due to the depletion effect induced by the EDFA transient response. It is found that the impairments brought by this effect are independent of the probe power, hence setting an ultimate limit for the BOTDA sensor performance. Experimentally, a long-range BOTDA deploying a 26-dB ER EOM and a conventional EDFA is shown to exhibit a BFS error higher than 1 MHz even for very small probe power., Spanish Ministerio de Economía y Competitividad (TEC2013-47264-C2-2-R and TEC2016-76021-C2-1-R); FEDER funds; Universidad Pública de Navarra; German Research Foundation (DFG SCHN 716/13-1).
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Multiparameter sensor based on a multiinterferometric serial configuration for temperature and strain measurements

  • Pérez Herrera, Rosa Ana
  • Bravo Acha, Mikel
  • Leandro González, Daniel
  • Novais, Susana
  • Pradas Martínez, Javier
  • López-Amo Sáinz, Manuel
In this work, a multi-parameter point sensor based on the combination of Fabry-Perot (FP) and the anti-resonant (AR) reflecting guidance in cascade configuration is proposed and experimentally demonstrated. This structure, based on FP interference and AR reflecting guidance, was fabricated with two different air micro-cavities. The attained experimental results showed different strain and temperature sensitivities for the antiresonance contribution. However, when analyzing the FP interference, only strain sensitivity was observed, demonstrating that this air micro-cavity was also insensitive to temperature variations., This work was supported by the Spanish AEI projects TEC2016-76021-C2 and PID2019-107270RB-C22, FEDER Funds, the European Union’s Horizon 2020 research and innovation programme under the Marie Skłodowska-Curie grant agreement No 838143, Projects for young researches UPNA 2019, “Caja Navarra” and “la Caixa” foundations under agreement LCF/PR/PR13/51080004 and the grant BGP18/00180 of the “Beatriz Galindo” programme from the Spanish Ministry of Science, Innovation and Universities.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Quasi-distributed vibration sensing based on weak reflectors and STFT demodulation

  • Leandro González, Daniel
  • Zhu, Mengshi
  • López-Amo Sáinz, Manuel
  • Murayama, Hideaki
In this work, a new system is proposed for quasi-distributed vibration sensing based on the Doppler effect. The setup employs an optical frequency domain reflectometer (OFDR) and an array of weak reflectors. The short-time Fourier transform (STFT) is employed to obtain the spectrogram, then the demodulation process detects the frequency variation and compensates the accumulated response. In this manner, events occurring in the fiber segment between neighboring reflectors can be measured. The theoretical development of the approach is presented and demonstrated, evidencing the velocimeter operation of the technique. The setup has been proved in several tests under different perturbation conditions, evaluating the limitations and capabilities. This solution presents many advantages such as the ability to measure arbitrary perturbations, the linear response, high spatial-resolution, simplicity, high configurability or the low repetition rate required to detect kilohertz-frequency vibrations., This work was supported by a Fundación La Caixa postdoc and Talent Grant, the project AEI TEC-2016-76021-C2-1 and the FEDER funds.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Non-local effects in Brillouin optical time-domain analysis sensors

  • Iribas Pardo, Haritz
  • Urricelqui Polvorinos, Javier
  • Mompó Roselló, Juan José
  • Mariñelarena Ollacarizqueta, Jon
  • Loayssa Lara, Alayn
Brillouin optical time-domain analysis (BOTDA) sensors have great potential to provide distributed measurements of temperature and strain over large structures with high spatial resolution and measurement precision. However, their performance ultimately depends on the amount of probe and pump pulse power that can be injected into the sensing fiber, which determines the signal-to-noise ratio of the detected measurement signal. The probe wave power is constrained by the generation of noise induced by spontaneous Brillouin scattering and at lower power by the so-called non-local effects. In this work, we focus on the latter. We review the physical origins of non-local effects and analyze the performance impairments that they bring. In addition, we discuss the different methods that have been proposed to counteract these effects comparing their relative merits and ultimate performance. Particularly, we focus on a technique that we have devised to compensate non-local effects which is based on introducing an optical frequency modulation or dithering to the probe wave. This method is shown to provide a comprehensive solution to most of the impairments associated with non-local effects and also to enable some side benefits, such as amplification of the pump pulses to compensate the attenuation of the fiber., The authors wish to acknowledge the financial support of the Spanish Ministerio de Economía y Competitividad through the projects TEC2013-47264-C2-2-R and TEC2016- 76021-C2-1-R, FEDER funds and the Universidad Pública de Navarra.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Cyclic coding for Brillouin optical time-domain analyzers using probe dithering

  • Iribas Pardo, Haritz
  • Loayssa Lara, Alayn
  • Sauser, Florian
  • Llera, Miguel
  • Le Floch, Sébastien
We study the performance limits of mono-color cyclic coding applied to Brillouin optical time-domain analysis (BOTDA) sensors that use probe wave dithering. BOTDA analyzers with dithering of the probe use a dual-probe-sideband setup in which an optical frequency modulation of the probe waves along the fiber is introduced. This avoids non-local effects while keeping the Brillouin threshold at its highest level, thus preventing the spontaneous Brillouin scattering from generating noise in the deployed sensing fiber. In these conditions, it is possible to introduce an unprecedented high probe power into the sensing fiber, which leads to an enhancement of the signal-to-noise ratio (SNR) and consequently to a performance improvement of the analyzer. The addition of cyclic coding in these set-ups can further increase the SNR and accordingly enhance the performance. However, this unprecedented probe power levels that can be employed result in the appearance of detrimental effects in the measurement that had not previously been observed in other BOTDA set-ups. In this work, we analyze the distortion in the decoding process and the errors in the measurement that this distortion causes, due to three factors: the power difference of the successive pulses of a code sequence, the appearance of first-order non-local effects and the non-linear amplification of the probe wave that results when using mono-color cyclic coding of the pump pulses. We apply the results of this study to demonstrate the performance enhancement that can be achieved in a long-range dithered dual-probe BOTDA. A 164-km fiber-loop is measured with 1-m spatial resolution, obtaining 3-MHz Brillouin frequency shift measurement precision at the worst contrast location. To the best of our knowledge, this is the longest sensing distance achieved with a BOTDA sensor using mono-color cyclic coding., H. Iribas and A. Loayssa wish to acknowledge the financial support of the Spanish Ministerio de Economía y Competitividad through the projects TEC2013-47264-C2-2-R and TEC2016-76021-C2-1-R, FEDER funds and the Universidad Pública de Navarra.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Compensation of nonlocal effects induced by the extinction ratio of pump pulses in Brillouin optical time-domain analysis sensors

  • Mariñelarena Ollacarizqueta, Jon
  • Iribas Pardo, Haritz
  • Urricelqui Polvorinos, Javier
  • Loayssa Lara, Alayn
We demonstrate a technique to compensate the nonlocal effects that appear in Brillouin optical time-domain analysis sensors when pump pulses with limited extinction ratio are deployed. These recently discovered nonlocal effects are originated in the interaction between the probe wave and the pulse pedestal. Hence, their compensation method is based on deploying a modulation (dithering) of the optical frequency of the probe and pulse pedestal waves that provides a reduction of the effective interaction length between them. This is implemented by taking advantage of the chirp associated to the direct current modulation of a semiconductor laser used as common source for both waves. The net effect of this procedure is that the probe and pulse pedestal waves display efficient Brillouin interaction just at correlation peaks along the fiber where the frequency difference between both waves remains constant. Proof-of-concept experiments in a 25-km sensing link demonstrate the performance of the technique, where large errors of more than 10 MHz in the measurement of the Brillouin frequency shift are completely compensated by introducing a sinusoidal dithering to the laser source., Project TEC2016-76021-C2-1-R (AEI/FEDER,UE); Universidad Pública de Navarra.