Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Degradation and regeneration mechanisms of NiO protective layers deposited by ALD on photoanodes

  • Ros, Carles
  • Andreu, Teresa
  • David, Jeremy
  • Arbiol, Jordi
  • Morante, Joan Ramón
The use of high pH electrolytes requires protective layers to avoid corrosion in photoanodes based on semiconductors like silicon. NiO is one of the materials that comply with the requirements for transparency, conductivity, chemical stability and catalysis on the surface in contact with the electrolyte. Here, NiO layers have been deposited by atomic layer deposition (ALD) at low temperatures, and their stability is analyzed over 1000 hours. Due to the layer structure characteristics, the best overall performance was achieved at 100 °C deposition temperature. By electrochemical measurements progressive time dependent degradation under anodic working conditions is observed, attributed to the formation of higher nickel oxidation states at the electrode/electrolyte interface as a main degradation mechanism, resulting in an OER overpotential increase. Another minor degradation mechanism affects the optical surface quality and gives rise to a loss of photon absorption efficiency on the scale of hundreds of hours. A regeneration process based on in situ periodic cyclic voltammetry, bringing the electrodes to cathodic conditions every 3, 12 or 48 hours, has been shown to partially reverse the main degradation mechanism achieving 85% stability over 1000 hours in a study with over 10 mA cm−2 photocurrent densities., Authors from the IREC acknowledge Generalitat de Catalunya for financial support through the CERCA Programme, M2E (2014SGR1638). The IREC also acknowledges additional support through the European Regional Development Funds (ERDF, FEDER) and MINECO coordinated projects MAT2014-59961-C2, ENE2016-80788-C5-5-R and ENE2017-85087-C3. C. R. acknowledges the MINECO for his FPI grant (BES-2015-071618). The ICN2 was supported by the Severo Ochoa program from the Spanish MINECO (Grant No. SEV-2017-0706) and was funded by the CERCA Programme/Generalitat de Catalunya. The ICN2 acknowledges funding from Generalitat de Catalunya 2017 SGR 327 and the Spanish MINECO project ENE2017-85087-C3. J. D. received funding from the European Union's Horizon 2020 research and innovation programme under the Marie Sklodowska-Curie grant agreement no. 665919 (P-SPHERE) co-funded by the Severo Ochoa Programme., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

A Self-Assembled 2D Thermofunctional Material for Radiative Cooling

  • Jaramillo-Fernandez, Juliana
  • Whitworth, Guy L.
  • Pariente González, J. Ángel
  • Blanco Montes, Álvaro
  • García Fernández, Pedro David
  • López, Cefe
  • Sotomayor Torres, C. M.
[EN] The regulation of temperature is a major energy-consuming process of humankind. Today, around 15% of the global-energy consumption is dedicated to refrigeration and this figure is predicted to triple by 2050, thus linking global warming and cooling needs in a worrying negative feedback-loop. Here, an inexpensive solution is proposed to this challenge based on a single layer of silica microspheres self-assembled on a soda-lime glass. This 2D crystal acts as a visibly translucent thermal-blackbody for above-ambient radiative cooling and can be used to improve the thermal performance of devices that undergo critical heating during operation. The temperature of a silicon wafer is found to be 14 K lower during daytime when covered with the thermal emitter, reaching an average temperature difference of 19 K when the structure is backed with a silver layer. In comparison, the soda-lime glass reference used in the measurements lowers the temperature of the silicon by just 5 K. The cooling power of this simple radiative cooler under direct sunlight is found to be 350 W m when applied to hot surfaces with relative temperatures of 50 K above the ambient. This is crucial to radiatively cool down devices, i.e., solar cells, where an increase in temperature has drastic effects on performance., The European Union’s Horizon 2020 research and innovation program under the Marie Sklodoswa-Curie grant agreement N 665919 supported J.J.-F. and funded this project. Moreover, the research received funds from the Spanish Minister of Science, Innovation and Universities via the Severo Ochoa Program (Grant No. SEV-2017-0706), RTI2018-093921-B-C41 and RTI2018-093921-A-C44 (SMOOTH), as well as by the CERCA Program/Generalitat de Catalunya. P.D.G. was supported by a Ramon y Cajal fellowship nr. RyC-2015-18124. J.J