Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

e-Archivo. Repositorio Institucional de la Universidad Carlos III de Madrid
Publicación Contribución de congreso (ConferenceOutput)

Influencia del tratamiento iostérmico en la intercara de los intermetálicos Ni₃Al como refuerzo de un compuesto de matriz de aluminio obtenido por pulvimetalurgia, Isothermal heat treatment influence on the interface of a powder metallurgy aluminium metal matrix composite reinforced with Ni₃Al intermetallics

  • Ferrer, C.
  • Amigó, V.
  • Salvador Moya, María Dolores
  • Busquets Mataix, David
  • Torralba Castelló, José Manuel
Presentado al: 8º Congreso Nacional de Ciencia y Tecnología Metalúrgicas. Madrid 27 a 29 de mayo de 1998, La mejora de las propiedades mecánicas de los composites de aluminio reforzados con partículas de Ni3Al se debe a la continuidad de la unión entre las partículas de refuerzo y la matriz, así como a la resistencia de las primeras. En este trabajo, se analiza la influencia que diferentes tratamientos térmicos tienen en la evolución de nuevas fases en la intercara matriz-partícula. Las muestras se prepararon por vía pulvimetalúrgica con una etapa de extrusión final. Se realizaron diferentes tratamientos térmicos abarcando un amplio espectro de temperaturas y tiempos, que dieron lugar al desarrollo de distintas fases alrededor de las partículas iniciales. Las muestras se analizaron mediante técnicas de microscopía óptica y electrónica de barrido con análisis de elementos por rayos X. Así mismo, se realizaron ensayos de microdureza en las distintas fases generadas., The improvement of the mechanical properties of aluminium MMCs reinforced with Ni3Al particles is based on the continuity of the matrix-particle interface as well as on the strength of these particles. This work deals with the influence of different heat treatments on the evolution of new phases in that interface. Samples were prepared following a powder metallurgy route with a final stage of extrusion. Several heat treatments encompassing a broad group of temperatures and times were applied, producing different phases around the primary particles. Samples were analysed via optical and scanning electron microscopy with energy dispersive X ray analysis. Microhardness tests were also conducted on the different phases generated., Este trabajo ha sido realizado con una subvención del proyecto del Plan Nacional de I+D de la CICYT con referencia MAT96-0722-C02-02.
e-Archivo. Repositorio Institucional de la Universidad Carlos III de Madrid
Publicación Contribución de congreso (ConferenceOutput)

Obtención de carburos de tantalio y de niobio por reducción carbotérmica del mineral columbotantalita, Tantalum and niobium carbides obtention by carbothermic reduction of columbotantalite ores

  • Gordo Odériz, Elena
  • García-Carcedo, F.
  • Torralba Castelló, José Manuel
Presentado al: 8º Congreso Nacional de Ciencia y Tecnología Metalúrgicas. Madrid 27 a 29 de mayo de 1998, Los carburos de tantalio y de niobio se caracterizan por su extremada dureza y resistencia al ataque químico. Ambos carburos, pero principalmente el de tantalio, se utilizan en la fabricación de metal duro (carburos cementados), junto con otros carburos, para herramientas de corte, matricería y para operaciones especiales de mecanizado que requieran resistencia al desgaste y resistencia al choque mecánico y a alta temperatura. También se está investigando su uso como refuerzo de aceros rápidos para el desarrollo de materiales resistentes al desgaste por vía pulvimetalúrgica. Sin embargo, el uso de TaC suele venir limitado por su alto precio, por lo que en ocasiones se utiliza carburo de tantalio con conteniendo de niobio, más barato. En el presente trabajo se estudia la obtención de carburos complejos de tantalio y de niobio a partir de un concentrado mineral de columbotantalita de procedencia española, mediante un proceso relativamente barato y sencillo, como es la reducción carbotérmica. Se describe el afino previo del mineral y su posterior reducción, así como la caracterización de los productos obtenidos., Tantalum and niobium carbides are characterized by its high hardness and chemical corrosion resistance. Both carbides, but mainly TaC, are used in hard metals (sintered carbides), together with other carbides, to manufacture cutting tools and dies and in special machining applications involving mechanical shock at high temperature. Its use as reinforcement of wear resistant materials through powder metallurgy techniques are being investigated. However, the use of TaC is usually limited because of its high cost. Therefore tantalum carbide with niobium content, which is cheaper, is used. In this work the obtention of complex tantalum and niobium carbides from a Spanish columbotantalite ore is studied through a relatively cheap and simple process as it is carbothermic reduction. Concentration of the ore, its reduction and the characterization of products are described., Este trabajo ha sido posible gracias a la financiación por la CICYT del proyecto MAT96-0542, ya finalizado, y del proyecto MAT97-0695, actualmente en curso, y a los trabajos realizados con anterioridad por el Dr. J. C. Ruiz Sierra, iniciador e impulsor de ambos proyectos y de esta línea de investigación.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Contribución de congreso (ConferenceOutput)

Reliability loss with sampling rate reduction

  • Sousa, Paulo
  • Almeida, Rute
  • Silva, Marta João
  • Rocha, Ana Paula
High sampling frequency is not usually available in hospital monitoring systems, what can limit the usefulness of the data, namely for repolarization measures. In this work the reliability of beat-to-beat measures using low sampling frequency is quantified with respect to the original high sampling rate. ECG recordings originally at 1000 Hz, including intensive care patients data, were downsampled to 500 Hz and to 250 Hz. Automatic delineation was applied to extract beat-to-beat intervals. The reliability was measured considering concordance correlation coefficient (CCC) and intraclass correlation coefficient (ICC); the Information-based measure of disagreement (IBMD) was used for agreement quantification. High reliability and low disagreement were generally found. Using the conventional interpretation excellent consistency was found at 250 HZ for more than 68%, 50%, 50% and 58% of the cases for RR, RT, QT and QTc, respectively. Results indicate that at 250 Hz RR, RT, QT and QTc measures are still reliable compared with the values at 1000 Hz.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Contribución de congreso (ConferenceOutput)

Circadian modulation on T-wave alternans activity in chronic heart failure patients

  • Martín-Yebra, Alba
  • Caiani, Enrico G.
  • Laguna, Pablo
  • Monasterio, Violeta
  • Martínez, Juan Pablo
Average TWA activity has been shown to be an independent predictor of sudden cardiac death (SCD) in chronic heart failure (CHF) patients. However, the influence of circadian rhythms on TWA remains understudied. In this work, we assessed circadian TWA changes in a CHF population and evaluated whether the prognostic value of TWA indices is sensitive to the circadian pattern. Holter ECG recordings from 626 consecutive CHF patients (52 SCD) were analyzed. The index of average alternans (IAA), quantifying the average TWA level, was measured in 4 consecutive 6-hour intervals using a multilead fully-automated method. Survival analysis was performed considering SCD as an independent endpoint. IAA changed along the day, with statistically significant lower values during the night than during daytime. This pattern is similar to the one observed in the mean heart rate (HR). However, a low correlation (r=.18) was found between IAA and HR in windows of 128 beats. After dichotomization of patients based on the third quartile of IAA indices, IAA indices computed between hours 06-12 (IAA06-12) and 18-24 (IAA18-24) successfully predicted SCD (Hazard Ratio, HaR:2.34(1.33-4.13)per µV, andHaR:1.87(1.04-3.36) per µV, respectively). In conclusion, circadian variation should be considered for SCD risk prediction.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Contribución de congreso (ConferenceOutput)

The role of purkinje automaticity as an arrhythmia mechanism in hyperkalaemia

  • Monasterio, Violeta
  • Carro, Jesús
  • Pueyo, Esther
  • Rodríguez, José F.
The pacemaker activity of Purkinje (PK) cells is usually suppressed by the sino-atrial (SA) node. Under abnormal conditions, PK cells may produce ectopic focal activity leading to tachycardia and fibrillation. This computational modelling work illustrates the potential role of PK automaticity as an arrhythmia mechanism in hyperkalaemia. First, we investigated the automaticity of isolated PK cells under hyperkalaemic conditions. Second, the potential consequences of altered PK automaticity were explored in a 1-D model of a terminal PK fibre running through a hyperkalaemic zone. Hyperkalaemia was found to accelerate the autorhythmic period of isolated PK cells with respect to control. For extracellular potassium levels = 7.2 mM, spontaneous action potentials (APs) appeared in the PK fibre, leading to conduction disturbances and complex combinations of spontaneous and stimulation-driven APs.
Recercat. Dipósit de la Recerca de Catalunya
Publicación Contribución de congreso (ConferenceOutput)

Analysis of atmospheric aerosol properties using lidar measurements and their impact on radiative budget in Barcelona over the past 20 years

  • Lolli, Simone
  • Sicard, Michaël
  • Comerón Tejero, Adolfo
  • Gil Díaz, Cristina
  • Oliveira, Daniel Camilo Fortunato dos Santos
  • Landi, Tony C.
  • Rodríguez Gómez, Alejandro Antonio
  • Muñoz Porcar, Constantino
  • Rocadenbosch Burillo, Francisco
  • Dios Otín, Víctor Federico
Aerosols are significant atmospheric constituents that modulate radiation and cloud processes. We evaluated 17-year aerosol profile trends in Barcelona, Spain, from lidar measurements. In summer aerosol reaches 5 km, while in the other seasons it exhibits clear exponential decay. Sahara dust transport affects all seasons, with winter layers above and others penetrating the boundary layer. This study informs the formation of haze and urban preservation strategies in the Mediterranean. The analysis puts in evidence that the averaged net radiative effect is of cooling at both surface level and top of the atmosphere., This work has been made possible through the efforts of many people, whom it would be too long to mention, and the funding of many grants through the years, in particular European projects of different framework programmes (FP5 EARLINET project (ID EVR1-CT-1999-40003), FP6 EARLINET-ASOS (ID: 25991), FP7 ACTRIS (ID: 262254), H2020 ACTRIS-2 (ID: 654109), ACTRIS-PPP (ID: 739530), ACTRIS IMP (ID: 871115) and ATMO-ACCESS (ID: 101008004)), projects of the Spanish National Research Programmes (refs. TIC 431/93, AMB96-1144-C02-01, REN2000-1907-CE, REN2000-1754-C02-02 / CLI, REN2003-09753-C02-C02 / CLI, REN2003-09753-C02-C CGL2008- 01330-E/CLI 02 / CLI, REN2002-12784-E, CGL2005-5131-E, CGL2006-27108-E/CLI, CGL2006-26149-E/CLI, CGL2007-28871-/CLI, CTM2006-27154-E/TECNO, TEC2006-07850/TCM, TEC2009-09106, TEC2012-34575, TEC2015-63832-P and PID2019-103886RB-I00), the project of the Catalan Regional Government IMMPACTE, and the ESA project No. nº 21487/08/NL/HE. The support of the European Union through NextGenerationEU funds is also gratefully acknowledged., Peer Reviewed, Postprint (author's final draft)